- 您現在的位置：買賣IC網 > PDF目錄370574 > HFBR-0305 1300 nm E-LED Transmitter and PIN/Preamp Receiver for Single-Mode Fiber(1300 nm 應用于單模式的E-LED傳送器和PIN/前置放大器接收器) PDF資料下載
參數資料
| 型號： | HFBR-0305 |
| 英文描述： | 1300 nm E-LED Transmitter and PIN/Preamp Receiver for Single-Mode Fiber(1300 nm 應用于單模式的E-LED傳送器和PIN/前置放大器接收器) |
| 中文描述： | 1300納米電子發光二極管發射機和PIN /接收機前置單模光纖（1300納米應用于單模式的電子發光傳送器和密碼/前置放大器接收器） |
| 文件頁數： | 2/11頁 |
| 文件大?。?/td> | 213K |
| 代理商： | HFBR-0305 |
2
Panel Mounting of
Threaded ST Package
Style
Any standard 3/8 - 32 UNEF-2B
threaded nut and washer can be
used to secure the threaded ST
receptacle to the chassis wall,
provided the overall thickness of
the chassis wall, washer and nut
are less than 5.1 mm (0.2 inch).
Agilent supplies the HFBR-4411
kit which consists of 100 each,
nuts and washers per the figure
below.
When preparing the chassis wall
for panel mounting, use the
mounting template in the figure
below. When tightening the nut,
torque should not exceed 0.8 N-m
(8.0 in-lb). Note that the maxi-
mum nut dimension exceeds the
width of the port package, so
approximately 2 mm of space
between device packages is
required to allow nuts to be
mounted on adjacent ports.
ESD Handling
Precautions
The HFBR-0305 Series products
are MIL-STD 883C Method
3015.4 Class 1 devices. Normal
static precautions should be
taken in handling and assembly
of this component to prevent
damage and/or degradation which
may be induced by electrostatic
discharge (ESD)
Solder Processing
The HFBR-0305 Series products
are compatible with either hand
or wave solder processes. When
soldering, it is advisable to leave
the protective cap on the port to
keep the optics clean. Good
system performance requires
clean port optics and cable
ferrules to avoid obstructing the
optical path. Clean compressed
air is often sufficient to remove
particles of dirt; methanol on a
cotton swab also works well.
Wash Processing -
Chemical Resistance
The HFBR-0305 Series package
is compatible with the following
chemicals for cleaning and
degreasing:
- Aqueous Wash
- Naptha
- Alcohol (methyl, isopropyl,
isobutyl)
- Aliphatics (hexane, heptane)
The following chemicals are not
recommended as they will
damage the package: Partially
halogenated hydrocarbons such
as 1,1,1 Trichloroethane, Ketones
such as MEK, Acetone, Chloro-
form, Ethyl Acetate, Methylene
Dichloride and N-methylpyroldone.
Flame Resistance
The HFBR-0305 Series package
is made with UL V-0 flame
retardant plastic material.
Electrostatic Discharge
(ESD)
Static discharges can occur to the
exterior of the equipment chassis
containing the HFBR-0305 Series
parts. To the extent that their
connector receptacles are
exposed to the outside of the
equipment chassis, they may be
subject to whatever ESD system
level test criteria that the
equipment is intended to meet.
Radiated Susceptibility
Equipment utilizing these
products will be subject to EMI
fields in some environments.
These HFBR-0305 Series prod-
ucts are expected to withstand
fields of up to 10 volts per meter,
when tested on a circuit card in
free space without an equipment
chassis, with no measurable
effect on their performance. A
suggested test method is based
on the equipment procedure
specified in IEC 801-3.
9.80
(0.386)
DIA.
8.0
(0.315)
14.27
(0.563)
(9.53
INTERNAL TOOTH LOCK WASHER
12.70
3/8 - 32 UNEF -
2B THREAD
1.65
(0.065)
TYP.
DIA.
10.41
(0.410)
MAX.
DIA.
ALL DIMENSIONS IN MILLIMETERS AND (INCHES).
HEX-NUT
(0.46
相關PDF資料 |
PDF描述 |
|---|---|
| HFBR-0400 | Low Cost, Miniature Fiber Optic Components with ST， SMA, SC and FC Ports(帶ST，SMA, SC 和 FC端口的低價格，微型光纖元件) |
| HFBR-0600 | SERCOS Fiber Optic Transmitters and Receiver |
| HFBR-1115T | Fiber Optic Transmitter Data Links for 125 MBd(應用于125 MBd的光纖傳送數據鏈路) |
| HFBR-1116T | Fiber Optic Transmitter Data Links for 155 MBd(應用于155 MBd的光纖傳送數據鏈路) |
| HFBR-1119T | Fiber Optic Transmitter Data Links for 266 MBd(應用于266 MBd的光纖傳送數據鏈路) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HFBR-0310 | 功能描述:光學纖維開發工具 155 MBd Txcvr Evaluation Kit RoHS:否 制造商:Omron Electronics 產品:Evaluation Boards 用于:SX51 封裝: |
| HFBR-0310Z | 功能描述:光學纖維開發工具 125MBd 1300nm Evaluation Kit RoHS:否 制造商:Omron Electronics 產品:Evaluation Boards 用于:SX51 封裝: |
| HFBR-0319 | 功能描述:光學纖維開發工具 1X9 Fiber Optic Evaluation Kit RoHS:否 制造商:Omron Electronics 產品:Evaluation Boards 用于:SX51 封裝: |
| HFBR-0319 | 制造商:Avago Technologies 功能描述:Evaluation test fixture board |
| HFBR-0400 | 功能描述:光學纖維開發工具 SMA Fiber Optic Evaluation Kit RoHS:否 制造商:Omron Electronics 產品:Evaluation Boards 用于:SX51 封裝: |
發布緊急采購，3分鐘左右您將得到回復。