- 您現在的位置：買賣IC網 > PDF目錄9758 > HI5767/6CB (Intersil)CONV A/D 10BIT 60MSPS 28-SOIC PDF資料下載
參數資料
| 型號： | HI5767/6CB |
| 廠商： | Intersil |
| 文件頁數： | 6/15頁 |
| 文件大小： | 0K |
| 描述： | CONV A/D 10BIT 60MSPS 28-SOIC |
| 標準包裝： | 26 |
| 位數： | 10 |
| 采樣率（每秒）： | 60M |
| 數據接口： | 并聯 |
| 轉換器數目： | 8 |
| 功率耗散（最大）： | 310mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-SOIC（0.295"，7.50mm 寬） |
| 供應商設備封裝： | 28-SOIC W |
| 包裝： | 管件 |
| 輸入數目和類型： | 2 個單端，單極；1 個差分，雙極 |
14
where:
VCORR = 0.5 dB (Typical).
VCORR adjusts the SINAD, and hence the ENOB, for the
amount the analog input signal is backed off from full scale.
Signal To Noise and Distortion Ratio (SINAD)
SINAD is the ratio of the measured RMS signal to RMS sum
of all the other spectral components below the Nyquist
frequency, fS/2, excluding DC.
Signal To Noise Ratio (SNR)
SNR is the ratio of the measured RMS signal to RMS noise at
a specified input and sampling frequency. The noise is the
RMS sum of all of the spectral components below fS/2
excluding the fundamental, the first five harmonics and DC.
Total Harmonic Distortion (THD)
THD is the ratio of the RMS sum of the first 5 harmonic
components to the RMS value of the fundamental input signal.
2nd and 3rd Harmonic Distortion
This is the ratio of the RMS value of the applicable harmonic
component to the RMS value of the fundamental input signal.
Spurious Free Dynamic Range (SFDR)
SFDR is the ratio of the fundamental RMS amplitude to the
RMS amplitude of the next largest spectral component in the
spectrum below fS/2.
Intermodulation Distortion (IMD)
Nonlinearities in the signal path will tend to generate
intermodulation products when two tones, f1 and f2, are
present at the inputs. The ratio of the measured signal to the
distortion terms is calculated. The terms included in the
calculation are (f1+f2), (f1-f2), (2f1), (2f2), (2f1+f2), (2f1-f2),
(f1+2f2), (f1-2f2). The ADC is tested with each tone 6dB
below full scale.
Transient Response
Transient response is measured by providing a full-scale
transition to the analog input of the ADC and measuring the
number of cycles it takes for the output code to settle within
10-bit accuracy.
Over-Voltage Recovery
Over-Voltage Recovery is measured by providing a full-scale
transition to the analog input of the ADC which overdrives
the input by 200mV, and measuring the number of cycles it
takes for the output code to settle within 10-bit accuracy.
Full Power Input Bandwidth (FPBW)
Full power input bandwidth is the analog input frequency at
which the amplitude of the digitally reconstructed output has
decreased 3dB below the amplitude of the input sine wave.
The input sine wave has an amplitude which swings from
-FS to +FS. The bandwidth given is measured at the
specified sampling frequency.
HI5767
相關PDF資料 |
PDF描述 |
|---|---|
| MAX3130EAI+ | IC TXRX W/RS232 28-SSOP |
| MS27484T12F98SA | CONN PLUG 10POS STRAIGHT W/SCKT |
| VI-243-MX-F3 | CONVERTER MOD DC/DC 24V 75W |
| V375C12M150BL3 | CONVERTER MOD DC/DC 12V 150W |
| MS27497P14F35PA | CONN RCPT 37POS WALL MNT W/PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HI5767EVAL1 | 功能描述:數據轉換 IC 開發工具 HI5767 LW FREQUENCY EVALUATION PLATFORM RoHS:否 制造商:Texas Instruments 產品:Demonstration Kits 類型:ADC 工具用于評估:ADS130E08 接口類型:SPI 工作電源電壓:- 6 V to + 6 V |
| HI5767EVAL2 | 功能描述:數據轉換 IC 開發工具 HI5767 HI FREQUENCY EVALUATION PLATFORM RoHS:否 制造商:Texas Instruments 產品:Demonstration Kits 類型:ADC 工具用于評估:ADS130E08 接口類型:SPI 工作電源電壓:- 6 V to + 6 V |
| HI5780 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:10-Bit, 80 MSPS, High Speed, Low Power D/A Converter |
| HI5780-EV | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:10-Bit, 80 MSPS, High Speed, Low Power D/A Converter |
| HI5780JCQ | 制造商:Rochester Electronics LLC 功能描述:32 PQFP COMTEMP VIDEO D/A 10BIT 80MHZ - Bulk 制造商:Harris Corporation 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。