![](http://datasheet.mmic.net.cn/230000/IC41SV44054_datasheet_15577386/IC41SV44054_4.png)
IC41SV44052
IC41SV44054
4
Integrated Circuit Solution Inc.
DR035-0B 7/31/2002
Functional Description
The IC41SV44052 and IC41LV44054 are CMOS DRAMs
optimized for high-speed bandwidth, low power applications.
During READ or WRITE cycles, each bit is uniquely
addressed through the 11 or 12 address bits. These are
entered 11 bits (A0-A10) at a time for the 2K refresh device
or 12 bits (A0-A11) at a time for the 4K refresh device. The
row address is latched by the Row Address Strobe (
RAS
).
The column address is latched by the Column Address
Strobe (
CAS
).
RAS
is used to latch the first nine bits and
CAS
is used the latter ten bits.
Memory Cycle
A memory cycle is initiated by bring
RAS
LOW and it is
terminated by returning both
RAS
and
CAS
HIGH. To
ensures proper device operation and data integrity any
memory cycle, once initiated, must not be ended or aborted
before the minimum t
RAS
time has expired. A new cycle
must not be initiated until the minimum precharge time t
RP
,
t
CP
has elapsed.
Read Cycle
A read cycle is initiated by the falling edge of
CAS
or
OE
,
whichever occurs last, while holding
WE
HIGH. The col-
umn address must be held for a minimum time specified by
t
AR
. Data Out becomes valid only when t
RAC
, t
AA
, t
CAC
and
t
OEA
are all satisfied. As a result, the access time is
dependent on the timing relationships between these
parameters.
Write Cycle
A write cycle is initiated by the falling edge of
CAS
and
WE
,
whichever occurs last. The input data must be valid at or
before the falling edge of
CAS
or
WE
, whichever occurs
last.
Refresh Cycle
To retain data, 2,048 refresh cycles are required in each
32 ms period, or 4,096 refresh cycles are required in each
64ms period. There are two ways to refresh the memory:
1. By clocking each of the 2,048 row addresses (A0
through A10) or 4096 row addresses (A0 through A11)
with RAS at least once every 32 ms or 64ms respectively.
Any read, write, read-modify-write or RAS-only cycle
refreshes the addressed row.
2. Using a
CAS
-before-
RAS
refresh cycle.
CAS
-before-
RAS
refresh is activated by the falling edge of
RAS
,
while holding
CAS
LOW. In
CAS
-before-
RAS
refresh
cycle, an internal 11(12)-bit counter provides the row
addresses and the external address inputs are ignored.
CAS
-before-
RAS
is a refresh-only mode and no data
access or device selection is allowed. Thus, the output
remains in the High-Z state during the cycle.
Power
-
On
After application of the V
CC
supply, an initial pause of
200 μs is required followed by a minimum of eight initializa-
tion cycles (any combination of cycles containing a
RAS
signal).
During power-on, it is recommended that
RAS
track with
V
CC
or be held at a valid V
IH
to avoid current surges.