- 您現在的位置：買賣IC網 > PDF目錄9608 > ICL3226CA (Intersil)IC 1DRVR/1RCVR RS232 3V 16-SSOP PDF資料下載
參數資料
| 型號： | ICL3226CA |
| 廠商： | Intersil |
| 文件頁數： | 4/18頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC 1DRVR/1RCVR RS232 3V 16-SSOP |
| 標準包裝： | 77 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 1/1 |
| 規程： | RS232 |
| 電源電壓： | 3 V ~ 5.5 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-SSOP（0.209"，5.30mm 寬） |
| 供應商設備封裝： | 16-SSOP |
| 包裝： | 管件 |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁
12
FN4876.10
March 1, 2006
transition occurs on a receiver or transmitter input (see
Figure 7). For immediate power up when the cable is
reattached, connect FORCEON to FORCEOFF through a
network similar to that shown in Figure 5.
Ready Output (ICL3224 and ICL3226 only)
The Ready output indicates that the ICL322X is ready to
transmit. Ready switches low whenever the device enters
powerdown, and switches back high during power-up when
V- reaches -4V or lower.
Capacitor Selection
The charge pumps require 0.1
F capacitors for 3.3V
operation. For other supply voltages refer to Table 3 for
capacitor values. Do not use values smaller than those listed
in Table 3. Increasing the capacitor values (by a factor of 2)
reduces ripple on the transmitter outputs and slightly
reduces power consumption. C2, C3, and C4 can be
increased without increasing C1’s value, however, do not
increase C1 without also increasing C2, C3, and C4 to
maintain the proper ratios (C1 to the other capacitors).
When using minimum required capacitor values, make sure
that capacitor values do not degrade excessively with
temperature. If in doubt, use capacitors with a larger nominal
value. The capacitor’s equivalent series resistance (ESR)
usually rises at low temperatures and it influences the
amount of ripple on V+ and V-.
Power Supply Decoupling
In most circumstances a 0.1
F bypass capacitor is
adequate. In applications that are particularly sensitive to
power supply noise, decouple VCC to ground with a
capacitor of the same value as the charge-pump capacitor C1.
Connect the bypass capacitor as close as possible to the IC.
Transmitter Outputs when Exiting
Powerdown
Figure 10 shows the response of two transmitter outputs
when exiting powerdown mode. As they activate, the two
transmitter outputs properly go to opposite RS-232 levels,
with no glitching, ringing, nor undesirable transients. Each
transmitter is loaded with 3k
in parallel with 2500pF. Note
that the transmitters enable only when the magnitude of the
supplies exceed approximately 3V.
Operation Down to 2.7V
ICL32XX transmitter outputs meet RS-562 levels (±3.7V), at
the full data rate, with VCC as low as 2.7V. RS-562 levels
typically ensure interoperability with RS-232 devices.
Mouse Driveability
The ICL3244 is specifically designed to power a serial
mouse while operating from low voltage supplies. Figure 11
shows the transmitter output voltages under increasing load
current. The on-chip switching regulator ensures the
transmitters will supply at least ±5V during worst case
conditions (15mA for paralleled V+ transmitters, 7.3mA for
single V- transmitter).
High Data Rates
The ICL32XX maintain the RS-232 ±5V minimum transmitter
output voltages even at high data rates. Figure 12 details a
transmitter loopback test circuit, and Figure 13 illustrates the
loopback test result at 120kbps. For this test, all transmitters
were simultaneously driving RS-232 loads in parallel with
TABLE 3. REQUIRED CAPACITOR VALUES (Note 8)
VCC (V)
C1 (F)
C2, C3, C4 (F)
3.0 to 3.6 (3.3V
±10%)
0.1 (0.22)
3.15 to 3.6 (3.3V
±5%)
(0.1)
4.5 to 5.5
0.047
0.33
3.0 to 5.5
0.1 (0.22)
0.47 (1.0)
NOTE:
7. Parenthesized values apply only to the ICL3238
TIME (20
s/DIV.)
T1
T2
2V/DIV
5V/DIV
VCC = +3.3V
FORCEOFF
FIGURE 10. TRANSMITTER OUTPUTS WHEN EXITING
POWERDOWN
C1 - C4 = 0.1
F
5V/DIV
READY
FIGURE 11. TRANSMITTER OUTPUT VOLTAGE vs LOAD
CURRENT (PER TRANSMITTER, i.e., DOUBLE
CURRENT AXIS FOR TOTAL VOUT+ CURRENT)
T
RANSMITTER
OUTPUT
V
O
LTAGE
(V)
LOAD CURRENT PER TRANSMITTER (mA)
02
468
10
-6
-4
-2
0
2
4
6
-5
-3
-1
1
3
5
1
3579
VOUT+
VOUT -
VCC
VOUT+
VOUT -
T1
T2
T3
VCC = 3.0V
ICL3244
ICL3224, ICL3226, ICL3238, ICL3244
相關PDF資料 |
PDF描述 |
|---|---|
| ICL3223IA | IC 2DRVR/2RCVR RS232 3V 20-SSOP |
| MS27497T20B16SA | CONN RCPT 16POS WALL MNT W/SCKT |
| D38999/20KE26SA | CONN RCPT 26POS WALL MNT W/SCKT |
| MS27505E25F61P | CONN RCPT 61POS BOX MNT W/PINS |
| MS3122E24-61SZ | CONN RCPT 61POS BOX MNT W/SCKT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ICL3226CA-T | 功能描述:IC 1DRVR/1RCVR RS232 3V 16-SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,000 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| ICL3226CAZ | 功能描述:RS-232接口集成電路 RS232 3V 1D/1R E-DWN COM RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| ICL3226CAZ-T | 功能描述:RS-232接口集成電路 RS232 3V 1D/1R E-DWN COMEL RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| ICL3226E | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:+/-15kV ESD Protected, +3V to +5.5V, 1Microamp, 250kbps, RS-232 Transceivers with Enhanced Automatic Powerdown |
| ICL3226ECA | 功能描述:IC TXRX RS-232 3-5.5V ESD 16SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:2,500 系列:- 類型:驅動器 驅動器/接收器數:4/0 規程:RS422 電源電壓:4.5 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC N 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。