- 您現在的位置：買賣IC網 > PDF目錄360786 > ICS950811yFLFT Frequency Generator with 200MHz Differential CPU Clocks PDF資料下載
參數資料
| 型號： | ICS950811yFLFT |
| 英文描述： | Frequency Generator with 200MHz Differential CPU Clocks |
| 中文描述： | 頻率發生器200MHz的CPU的時鐘差分 |
| 文件頁數： | 4/18頁 |
| 文件大?。?/td> | 302K |
| 代理商： | ICS950811YFLFT |
4
ICS950811
0482E—08/09/07
1.
The ICS clock generator is a slave/receiver, I
2
C component. It can read back the data stored in the latches
for verification.
Read-Back will support Intel PIIX4 "Block-Read" protocol
.
The data transfer rate supported by this clock generator is 100K bits/sec or less (standard mode)
The input is operating at 3.3V logic levels.
The data byte format is 8 bit bytes.
To simplify the clock generator I
2
C interface, the protocol is set to use only "
Block-Writes
" from the
controller. The bytes must be accessed in sequential order from lowest to highest byte with the ability to stop
after any complete byte has been transferred. The Command code and Byte count shown above must be
sent, but the data is ignored for those two bytes. The data is loaded until a Stop sequence is issued.
At power-on, all registers are set to a default condition, as shown.
2.
3.
4.
5.
6.
General I
2
C serial interface information
The information in this section assumes familiarity with I
2
C programming.
How to Write:
Controller (host) sends a start bit.
Controller (host) sends the write address D2
(H)
ICS clock will
acknowledge
Controller (host) sends a dummy command code
ICS clock will
acknowledge
Controller (host) sends a dummy byte count
ICS clock will
acknowledge
Controller (host) starts sending first byte (Byte 0)
through byte 5
ICS clock will
acknowledge
each byte
one at a time
.
How to Read:
Controller (host) will send start bit.
Controller (host) sends the read address D3
(H)
ICS clock will
acknowledge
ICS clock will send the
byte count
Controller (host) acknowledges
ICS clock sends first byte
(Byte 0) through byte 6
Controller (host) will need to acknowledge each byte
Controller (host) will send a stop bit
Notes:
Controller (Host)
Start Bit
Address
D2
(H)
ICS (Slave/Receiver)
ACK
Dummy Command Code
ACK
Dummy Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Byte 6
ACK
Stop Bit
How to Write:
Controller (Host)
Start Bit
Address
D3
(H)
ICS (Slave/Receiver)
ACK
Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Byte 6
ACK
Stop Bit
How to Read:
相關PDF資料 |
PDF描述 |
|---|---|
| ICS950812YGLFT | Frequency Generator with 200MHz Differential CPU Clocks |
| ICS950812 | Frequency Generator with 200MHz Differential CPU Clocks |
| ICS950812YFLFT | LED STANDARD GREEN 3MM T-1 |
| ICS950813 | Frequency Generator with 200MHz Differential CPU Clocks |
| ICS950813YFT | Frequency Generator with 200MHz Differential CPU Clocks |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ICS950812 | 制造商:ICS 制造商全稱:ICS 功能描述:Frequency Generator with 200MHz Differential CPU Clocks |
| ICS950812CGLF | 功能描述:IC FREQ GEN 200MHZ CLK 56-TSSOP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT |
| ICS950812CGLFT | 功能描述:IC FREQ GEN 200MHZ CLK 56-TSSOP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:28 系列:- 類型:時鐘/頻率發生器 PLL:是 主要目的:Intel CPU 服務器 輸入:時鐘 輸出:LVCMOS 電路數:1 比率 - 輸入:輸出:3:22 差分 - 輸入:輸出:無/是 頻率 - 最大:400MHz 電源電壓:3.135 V ~ 3.465 V 工作溫度:0°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:64-TFSOP （0.240"，6.10mm 寬） 供應商設備封裝:64-TSSOP 包裝:管件 |
| ICS950812YFLFT | 制造商:ICS 制造商全稱:ICS 功能描述:Frequency Generator with 200MHz Differential CPU Clocks |
| ICS950812YGLFT | 制造商:ICS 制造商全稱:ICS 功能描述:Frequency Generator with 200MHz Differential CPU Clocks |
發布緊急采購，3分鐘左右您將得到回復。