參數資料
型號: ICX204AL
廠商: Sony Corporation
英文描述: Diagonal 6mm (Type 1/3) Progressive Scan CCD Image Sensor with Square Pixel for B/W Cameras(對角線式、6毫米(1/3型)步進掃描CCD圖像傳感器(具有正方形像素,用于黑白攝像機))
中文描述: 對角線6毫米(類型1 / 3)逐行掃描CCD圖像傳感器/黑白攝像機(對角線式,6毫米(1 / 3型)步進掃描防治荒漠化圖像傳感器(具有正方形像素,用于黑白攝像機的廣場像素))
文件頁數: 11/22頁
文件大?。?/td> 265K
代理商: ICX204AL
– 11 –
ICX204AL
Measurement conditions
1) In the following measurements, the device drive conditions are at the typical values of the progressive scan
mode, bias and clock voltage conditions.
2) In the following measurements, spot blemishes are excluded and, unless otherwise specified, the optical
black level (OB) is used as the reference for the signal output, which is taken as the value measured at
point [
B] of the measurement system.
Definition of standard imaging conditions
1) Standard imaging condition
I
:
Use a pattern box (luminance: 706cd/m
2
, color temperature of 3200K halogen source) as a subject. (Pattern
for evaluation is not applicable.) Use a testing standard lens with CM500S (t = 1.0mm) as an IR cut filter
and image at F8. The luminous intensity to the sensor receiving surface at this point is defined as the
standard sensitivity testing luminous intensity.
2) Standard imaging condition
II
:
Image a light source (color temperature of 3200K) with a uniformity of brightness within 2% at all angles.
Use a testing standard lens with CM500S (t = 1.0mm) as an IR cut filter. The luminous intensity is adjusted
to the value indicated in each testing item by the lens diaphragm.
3) Standard imaging condition
III
:
Image a light source (color temperature of 3200K) with a uniformity of brightness within 2% at all angles.
Use a testing standard lens (exit pupil distance –33mm) with CM500S (t = 1.0mm) as an IR cut filter. The
luminous intensity is adjusted to the value indicated in each testing item by the lens diaphragm.
1. Sensitivity
Set to standard imaging condition
I
. After selecting the electronic shutter mode with a shutter speed of
1/250s, measure the signal outputs (V
S
) at the center of screen, and substitute the values into the following
formulas.
S = V
S
×
[mV]
2. Saturation signal
Set to standard imaging condition
II
. After adjusting the luminous intensity to 10 times the intensity with the
average value of the signal output, 150mV, measure the minimum values of the signal output.
3. Smear
Set to standard imaging condition
II
. With the lens diaphragm at F5.6 to F8, first adjust the luminous
intensity to 500 times the intensity with the average value of the signal output, 150mV. Then after the
readout clock is stopped and the charge drain is executed by the electronic shutter at the respective H
blankings, measure the maximum value (V
Sm
[mV]) of the signal output, and substitute the values into the
following formula.
Sm = Vsm
×
×
×
100 [%] (1/10V method conversion value)
1
500
250
30
150
1
10
相關PDF資料
PDF描述
ICX204 Diagonal 6mm (Type 1/3) Progressive Scan CCD Image Sensor with Square Pixel for Color Cameras
ICX205AK Diagonal 8mm (Type 1/2) Progressive Scan CCD Image Sensor With Square Pixel for Color Cameras(對角線式、8毫米(1/2型)步進掃描CCD圖像傳感器(具有正方形像素,用于彩色攝像機))
ICX205AL Diagonal 8mm (Type 1/2) Progressive Scan CCD Image Sensor With Square Pixel for B/W Cameras(對角線式、8毫米(1/2型)步進掃描CCD圖像傳感器(具有正方形像素,用于黑白攝像機))
ICX205 Diagonal 6mm (Type 1/3) Progressive Scan CCD Image Sensor with Square Pixel for B/W Cameras
ICX206AKB Diagonal 4.5mm (Type 1/4) CCD Image Sensor for NTSC Color Video Cameras
相關代理商/技術參數
參數描述
ICX205 制造商:SONY 制造商全稱:Sony Corporation 功能描述:Diagonal 8mm (Type 1/2) Progressive Scan CCD Image Sensor with Square Pixel for B/W Cameras
ICX205AK 制造商:SONY 制造商全稱:Sony Corporation 功能描述:Diagonal 6mm (Type 1/3) Progressive Scan CCD Image Sensor with Square Pixel for B/W Cameras
ICX205AL 制造商:SONY 制造商全稱:Sony Corporation 功能描述:Diagonal 8mm (Type 1/2) Progressive Scan CCD Image Sensor with Square Pixel for B/W Cameras
ICX206 制造商:SONY 制造商全稱:Sony Corporation 功能描述:1/4-Inch Super HAD CCD Color Image Sensor
ICX206AK 制造商:SONY 制造商全稱:Sony Corporation 功能描述:1/4-Inch Super HAD CCD Color Image Sensor