IDT72205LB/72215LB/72225LB/72235LB/72245LB CMOS SyncFIFOTM 256 x 18, 512 x 18, 1,024 x 18, 2,048 x 18" />
參數資料
型號: IDT72205LB10PF8
廠商: IDT, Integrated Device Technology Inc
文件頁數: 13/16頁
文件大?。?/td> 0K
描述: IC FIFO 256X18 SYNC 10NS 64-TQFP
標準包裝: 750
系列: 7200
功能: 同步
存儲容量: 4.6K(256 x 18)
數據速率: 100MHz
訪問時間: 10ns
電源電壓: 4.5 V ~ 5.5 V
工作溫度: 0°C ~ 70°C
安裝類型: 表面貼裝
封裝/外殼: 64-LQFP
供應商設備封裝: 64-TQFP(14x14)
包裝: 帶卷 (TR)
其它名稱: 72205LB10PF8
6
IDT72205LB/72215LB/72225LB/72235LB/72245LB CMOS SyncFIFOTM
256 x 18, 512 x 18, 1,024 x 18, 2,048 x 18 and 4,096 x 18
COMMERCIALANDINDUSTRIAL
TEMPERATURERANGES
MARCH 2013
SIGNAL DESCRIPTIONS:
INPUTS:
DATA IN (D0 - D17)
Data inputs for 18-bit wide data.
CONTROLS:
RESET (RS)
ResetisaccomplishedwhenevertheReset(RS)inputistakentoaLOWstate.
During reset, both internal read and write pointers are set to the first location.
Aresetisrequiredafterpower-upbeforeawriteoperationcantakeplace.The
FullFlag(FF),Half-FullFlag(HF)andProgrammableAlmost-FullFlag(PAF)
will be reset to HIGH after tRSF. The Empty Flag (EF) and Programmable
Almost-EmptyFlag(PAE)willberesettoLOWaftertRSF. Duringreset,theoutput
registerisinitializedtoallzerosandtheoffsetregistersareinitializedtotheirdefault
values.
WRITE CLOCK (WCLK)
AwritecycleisinitiatedontheLOW-to-HIGHtransitionoftheWriteClock
(WCLK).DatasetupandholdtimesmustbemetwithrespecttotheLOW-to-HIGH
transitionofWCLK.
The Write and Read Clocks can be asynchronous or coincident.
WRITE ENABLE (WEN)
WhentheWENinput isLOWandLDinputisHIGH,datamaybeloadedinto
the FIFO RAM array on the rising edge of every WCLK cycle if the device is
notfull. DataisstoredintheRAMarraysequentiallyandindependentlyofany
ongoing read operation.
WhenWENisHIGH,nonewdataiswrittenintheRAMarrayoneachWCLK
cycle.
Topreventdataoverflow,FFwillgoLOW,inhibitingfurtherwriteoperations.
Upon the completion of a valid read cycle, FF will go HIGH allowing a write to
occur. The FF flag is updated on the rising edge of WCLK. WEN is ignored
when the FIFO is full.
READ CLOCK (RCLK)
DatacanbereadontheoutputsontheLOW-to-HIGHtransitionoftheRead
Clock (RCLK), when Output Enable (OE) is set LOW.
The Write and Read Clocks can be asynchronous or coincident.
READ ENABLE (REN)
WhenReadEnableisLOWand LDinputisHIGH,dataisloadedfromthe
RAM array into the output register on the rising edge of every RCLK cycle if
the device is not empty.
WhentheRENinputisHIGH,theoutputregisterholdsthepreviousdataand
nonewdataisloadedintotheoutputregister. ThedataoutputsQ0-Qnmaintain
the previous data value.
Every word accessed at Qn, including the first word written to an empty
FIFO,mustberequestedusingREN. Whenthelastwordhasbeenreadfrom
theFIFO,theEmptyFlag(EF)willgoLOW,inhibitingfurtherreadoperations.
REN is ignored when the FIFO is empty. Once a write is performed, EF will
go HIGH allowing a read to occur. The EF flag is updated on the rising edge
of RCLK.
OUTPUT ENABLE (OE)
When Output Enable (OE) is enabled (LOW), the parallel output buffers
receivedatafromtheoutputregister.WhenOEisdisabled(HIGH),theQoutput
databusisinahigh-impedancestate.
LOAD (LD)
The IDT72205LB/72215LB/72225LB/72235LB/72245LB devices con-
tain two 12-bit offset registers with data on the inputs, or read on the outputs.
When the Load (LD) pin is set LOW and WEN is set LOW, data on the inputs
D0-D11 is written into the Empty Offset register on the first LOW-to-HIGH
transition of the Write Clock (WCLK). When the LD pin and (WEN) are held
LOWthendataiswrittenintotheFullOffsetregisteronthesecondLOW-to-HIGH
transitionof(WCLK).Thethirdtransitionofthewriteclock(WCLK)againwrites
totheEmptyOffsetregister.
However,writingalloffsetregistersdoesnothavetooccuratonetime.One
ortwooffsetregisterscanbewrittenandthenbybringingtheLDpinHIGH,the
FIFOisreturnedtonormalread/writeoperation.WhentheLDpinissetLOW,
and WEN is LOW, the next offset register in sequence is written.
EMPTY OFFSET REGISTER
17
11
0
001FH (72205) 003FH (72215):
007FH (72225/72235/72245)
FULL OFFSET REGISTER
17
11
0
DEFAULT VALUE
001FH (72205) 003FH (72215):
007FH (72225/72235/72245)
2766 drw 05
Figure 2. Write Offset Register
NOTE:
1. The same selection sequence applies to reading from the registers. REN is enabled and
read is performed on the LOW-to-HIGH transition of RCLK.
Figure 3. Offset Register Location and Default Values
NOTE:
1. Any bits of the offset register not being programmed should be set to zero.
LD
WEN
WCLK
Selection
0
Writingtooffsetregisters:
EmptyOffset
FullOffset
0
1
NoOperation
1
0
Write Into FIFO
1
NoOperation
相關PDF資料
PDF描述
MS27656T23F53P CONN RCPT 53POS WALL MNT W/PINS
MS3106E28-18S CONN PLUG 12POS STRAIGHT W/SCKT
MS27466E11F35P CONN RCPT 13POS WALL MNT W/PINS
VI-J4V-MX-S CONVERTER MOD DC/DC 5.8V 75W
VE-23K-IW-F4 CONVERTER MOD DC/DC 40V 100W
相關代理商/技術參數
參數描述
IDT72205LB10PFG 功能描述:IC FIFO 256X18 SYNC 10NS 64TQFP RoHS:是 類別:集成電路 (IC) >> 邏輯 - FIFO 系列:7200 標準包裝:80 系列:7200 功能:同步 存儲容量:18.4K(1K x 18) 數據速率:- 訪問時間:10ns 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:64-LQFP 供應商設備封裝:64-TQFP(10x10) 包裝:托盤 其它名稱:72225LB10TF
IDT72205LB10PFG8 制造商:Integrated Device Technology Inc 功能描述:IC FIFO 256X18 SYNC 10NS 64-TQFP
IDT72205LB10TF 功能描述:IC FIFO 256X18 SYNC 10NS 64STQFP RoHS:否 類別:集成電路 (IC) >> 邏輯 - FIFO 系列:7200 標準包裝:80 系列:7200 功能:同步 存儲容量:18.4K(1K x 18) 數據速率:- 訪問時間:10ns 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:64-LQFP 供應商設備封裝:64-TQFP(10x10) 包裝:托盤 其它名稱:72225LB10TF
IDT72205LB10TF8 功能描述:IC FIFO 256X18 SYNC 10NS 64STQFP RoHS:否 類別:集成電路 (IC) >> 邏輯 - FIFO 系列:7200 標準包裝:80 系列:7200 功能:同步 存儲容量:18.4K(1K x 18) 數據速率:- 訪問時間:10ns 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:64-LQFP 供應商設備封裝:64-TQFP(10x10) 包裝:托盤 其它名稱:72225LB10TF
IDT72205LB15J 功能描述:IC FIFO 256X18 SYNC 15NS 68-PLCC RoHS:否 類別:集成電路 (IC) >> 邏輯 - FIFO 系列:7200 標準包裝:80 系列:7200 功能:同步 存儲容量:18.4K(1K x 18) 數據速率:- 訪問時間:10ns 電源電壓:4.5 V ~ 5.5 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:64-LQFP 供應商設備封裝:64-TQFP(10x10) 包裝:托盤 其它名稱:72225LB10TF