參數資料
型號: IDT82V3010PV
廠商: INTEGRATED DEVICE TECHNOLOGY INC
元件分類: 通信及網絡
英文描述: T1/E1/OC3 TELECOM CLOCK GENERATOR WITH DUAL REFERENCE INPUTS
中文描述: SPECIALTY TELECOM CIRCUIT, PDSO56
封裝: SSOP-56
文件頁數: 13/31頁
文件大小: 355K
代理商: IDT82V3010PV
IDT82V3010
T1/E1/OC3 Telecom Clock Generator with Dual Reference Inputs
Functional Description
13
June 19, 2006
Figure - 7 DPLL Block Diagram
In the Normal mode, the Limiter receives the error signal from the
Phase Detector, limits the phase slope within 5 ns per 125 μs and sends
the limited signal to the Loop Filter.
In the Fast Lock mode, the Limiter is disabled, and the DPLL locks to
the input reference within 500 ms, which is much shorter than that in the
Normal mode.
2.7.3
LOOP FILTER
The Loop Filter ensures that the jitter transfer meets the ETS 300
011 and AT&T TR62411 requirements. It works similarly to a first order
low pass filter with 2.1 Hz cutoff frequency for the four valid input
frequencies (8 kHz, 1.544 MHz, 2.048 MHz or 19.44 MHz).
The output of the Loop Filter goes to the Digital Control Oscillator
directly or through the Fraction blocks, in which E1, T1, C6 and C19
signals are generated.
2.7.4
FRACTION BLOCK
By applying some algorithms to the incoming E1 signal, the
Fraction_C19, Fraction_C6 and Fraction_T1 blocks generate C19, C6
and T1 signals respectively.
2.7.5
DIGITAL CONTROL OSCILLATOR (DCO)
In the Normal mode, the DCO receives four limited and filtered
signals from Loop Filter or Fraction blocks. Based on the values of the
received signals, the DCO generates four digital outputs: 19.44 MHz,
25.248 MHz, 32.768 MHz and 24.704 MHz for C19, C6, E1 and T1
dividers respectively.
In the Holdover mode, the DCO is running at the same frequency as
that generated by storage techniques.
In the Freerun mode, the DCO is running at the same frequency as
that of the master clock.
2.7.6
LOCK INDICATOR
If the output frequency of the DPLL is identical to the input frequency,
and the input phase offset is small enough so that no slope limiting is
exhibited, the LOCK pin will be set high.
2.7.7
OUTPUT INTERFACE
The Output Interface uses three output signals from the DCO to
generate totally 9 types of clock signals and 7 types of framing signals
All these output signals are synchronous to F8o.
D
C32o
F0o
F8o
C16o
C8o
C4o
C2o
C3o
C6o
RSP
TSP
F16o
F32o
C1.5o
Output Interface
T1_Divider
E1_Divider
C6_Divider
Frequency
Selection
Circuit 1
Phase
Detector
Virtual Reference
Fraction_C6
Fraction_T1
24.704 MHz
32.768 MHz
25.248 MHz
Feedback Signal
Limiter
FLOCK
F1_sel1
F1_sel0
C19_Divider
155.52 MHz
F19o
C19o
APLL
19.44 MHz
Fraction_C19
C19NEG
C19POS
IN_sel
F0_sel1
F0_sel0
Frequency
Selection
Circuit 0
C2/C1.5
Loop Filter
Fx_sel1 Fx_sel0 (x = 0 or 1)
相關PDF資料
PDF描述
IDT82V3010PVG T1/E1/OC3 TELECOM CLOCK GENERATOR WITH DUAL REFERENCE INPUTS
IDT82V3255 WAN PLL
IDT82V3255DK WAN PLL
IDT82V3255DKG WAN PLL
IDT82V3255TF WAN PLL
相關代理商/技術參數
參數描述
IDT82V3010PVG 功能描述:IC PLL WAN 51/E1/OC3 DUAL 56SSOP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP(0.209",5.30mm 寬) 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT
IDT82V3010PVG8 功能描述:IC PLL WAN 51/E1/OC3 DUAL 56SSOP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP(0.209",5.30mm 寬) 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT
IDT82V3011 制造商:IDT 制造商全稱:Integrated Device Technology 功能描述:T1/E1/OC3 WAN PLL WITH SINGLE REFERENCE INPUT
IDT82V3011PV 制造商:INT_DEV_TECH 功能描述:
IDT82V3011PVG 功能描述:IC PLL WAN T1/E1/OC3 SGL 56-SSOP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 專用 系列:- 標準包裝:1,500 系列:- 類型:時鐘緩沖器/驅動器 PLL:是 主要目的:- 輸入:- 輸出:- 電路數:- 比率 - 輸入:輸出:- 差分 - 輸入:輸出:- 頻率 - 最大:- 電源電壓:3.3V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP(0.209",5.30mm 寬) 供應商設備封裝:28-SSOP 包裝:帶卷 (TR) 其它名稱:93786AFT