- 您現在的位置：買賣IC網 > PDF目錄377498 > IR2137 (International Rectifier) IGBT Protection in AC or BLDC Motor Drives PDF資料下載
參數資料
| 型號： | IR2137 |
| 廠商： | International Rectifier |
| 英文描述： | IGBT Protection in AC or BLDC Motor Drives |
| 中文描述： | IGBT的保護在交流或直流無刷電機驅動器 |
| 文件頁數： | 2/9頁 |
| 文件大小： | 86K |
| 代理商： | IR2137 |
2
www.irf.com
In order to protect IGBT devices effectively during an Over-Current condition, one needs to focus on
two factors.
First, one needs to detect the type of Over-Current mode and shut the system down. In both Line-to-
Line and Shoot Through mode, the short-circuit current flows from and to the DC bus capacitors
(Figures 1 and 3). Therefore, a shunt resistor in the ground path can detect these Over-Current
conditions. However in the Ground Fault mode, the current flows from the AC line input, through the
positive DC bus and high side IGBT, to the earth ground (Figure 2). Therefore, the Ground Fault
condition has to be detected either with a shunt resistor on the positive bus line or by detecting the
current in the output lines.
Second, one needs to look at the AC drive architecture. Protection circuitry needs to be built in a manner
that does not disrupt the drive system. For instance, Figure 4 shows a typical Floating Ground Refer-
ence Architecture in which the micro-controller (
μ
C) is on the Floating Ground reference. Therefore, any
Over-Current detection circuit needs to be isolated. Alternate architecture may require reduced or no
isolation.
2-2 Traditional Methods of Over-Current Detection
Method 1
One can detect the Line-to-Line Short and Shoot Through currents by inserting a Hall Effect sensor
or a linear opto isolator across the shunt resistor. The device should be in series with the negative
DC bus line. For Ground Fault protection, an additional Hall Effect leakage current sensor could be
placed either on the AC line input or on the DC bus. The protection circuit is then implemented by
using fast comparators. The output of these comparators is ‘OR’d with the micro-controller or PWM
generator to initiate the shutdown of the gate signals.
Method 2
If located in the motor phase output, each Hall Effect sensor uses 2 comparators. This is done
because both positive and negative current polarities flow during a Line-to-Line Short condition.
Another important consideration is the total propagation delay for shutdown. The delay time associ-
ated with the optical isolators in the gate drive and the Hall Effect sensor is typically more than 2
microseconds. Therefore, regardless of protection circuitry implementation, this delay should be
added to the circuit delay, before matching it with the IGBT short circuit duration time. As shown in
Figure 4, the configuration requires 2 Hall Effect sensors and/or opto isolators in addition to the
protection circuit. The protection circuitry comprises of comparators (2), voltage references, capaci-
tors, and resistors.
Method 3
Another protection method is to use an IGBT de-saturation circuit. This discrete circuit can be con-
structed in the secondary side of the opto gate driver. (Opto isolated devices with in-built de-satura-
tion circuits can also be found in the market). This circuit detects voltage build-up across the collec-
tor and emitter while the device is fully on. If the voltage exceeds a specified limit, the associated
gate signal is shut off. A discrete circuit would require a comparator with voltage reference, a high
voltage diode, and various resistors and capacitors.
相關PDF資料 |
PDF描述 |
|---|---|
| IR21381Q | 3-PHASE AC MOTOR CONTROLLER IC |
| IR22381QPBF | 3-PHASE AC MOTOR CONTROLLER IC |
| IR2152 | SELF-OSCILLATING HALF-BRIDGE DRIVER |
| IR2153 | SELF-OSCILLATING HALF-BRIDGE DRIVER |
| IR2153PBF | SELF-OSCILLATING HALF-BRIDGE DRIVER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| IR2137IGBT | 制造商:IRF 制造商全稱:International Rectifier 功能描述:IGBT Protection in AC or BLDC Motor Drives |
| IR2137J | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:AC Motor Controller/Driver |
| IR2137Q | 制造商:INTRSL 功能描述: |
| IR21381Q | 制造商:IRF 制造商全稱:International Rectifier 功能描述:3-PHASE AC MOTOR CONTROLLER IC |
| IR21381QPBF | 功能描述:IC CTLR AC MOTOR 3PHASE 64-MQFP RoHS:是 類別:集成電路 (IC) >> PMIC - MOSFET，電橋驅動器 - 外部開關 系列:- 標準包裝:50 系列:- 配置:高端 輸入類型:非反相 延遲時間:200ns 電流 - 峰:250mA 配置數:1 輸出數:1 高端電壓 - 最大（自引導啟動）:600V 電源電壓:12 V ~ 20 V 工作溫度:-40°C ~ 125°C 安裝類型:通孔 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-DIP 包裝:管件 其它名稱:*IR2127 |
發布緊急采購，3分鐘左右您將得到回復。