- 您現在的位置：買賣IC網 > PDF目錄377498 > IR21592 (International Rectifier) DIMMING BALLAST CONTROL IC PDF資料下載
參數資料
| 型號： | IR21592 |
| 廠商： | International Rectifier |
| 英文描述： | DIMMING BALLAST CONTROL IC |
| 中文描述： | 調光鎮流器控制IC |
| 文件頁數： | 20/25頁 |
| 文件大?。?/td> | 259K |
| 代理商： | IR21592 |
IR21592/IR21593
(S)
20
www.irf.com
1V
3V
5V
0
0.5V
5V
V
MIN
V
DIM
R
MIN
R
MAX
V
CT
LO
USER
SETTING
DIM
RANGE
ν
0
-90
-180
Ε
Ε
Ε
ν
REF
Figure 14, Dimming interface
The charging time of CT from 1V to 5.1V
determines the on-time of output gate drivers HO
and LO and corresponds to -180 degrees of
possible phase shift in load current (minus
deadtime). For the 0 to -90 degree dim range, the
voltage on pin MIN is bounded between 1V and
3V using pins MIN and MAX. An external resistor
on pin MAX programs the minimum phase shift
reference (maximum lamp power) corresponding
to 5V on pin DIM, and an external resistor on pin
MIN sets the maximum phase shift (minimum
lamp power) corresponding to 0.5V on pin DIM.
Current Sensing
During dimming, the current sensing circuitry
(Figure 15) detects over-current which can occur
during hard-switching (see Fault section), and
zero-crossing to measure the phase of the total
load current. To reject any switching noise which
can occur at the turn-on of the low-side MOSFET
or IGBT, a digital current sense blanking circuit
blanks out the signal from the zero-crossing
detection comparator for 400ns after LO goes 'high'
(Figure 16).
11
12
COM
LO
10
CS
1.6V
Q2
RCS
16
HO
Q2
15
VS
Half
Bridge
Output
I
LOAD
V
BUS
(+)
V
BUS
(-)
Load
Return
Half
Bridge
Driver
IR2159
PHASE
CONTROL
FAULT
LOGIC
400ns
BLANK
R1
Figure 15, Current sensing circuitry.
The internal blank time reduces the dimming range
slightly (Figure 16) when operating at minimum
phase shift (maximum lamp power). The external
programming resistor on pin MAX must be
selected such that the minimum phase shift is
set a safe margin away from the blank time. A
series resistor (R1) is required to limit the amount
of current flowing out of pin CS when the voltage
across RCS goes below -0.7V. A filter capacitor
at pin CS may be required due to other possible
asynchronous noise sources present in the ballast
system.
相關PDF資料 |
PDF描述 |
|---|---|
| IR21592S | DIMMING BALLAST CONTROL IC |
| IR2166 | RES 560 OHM 1/10W 5% SM |
| IR2166PBF | PFC & BALLAST CONTROL IC |
| IR2166S | PFC & BALLAST CONTROL IC |
| IR2167 | PFC BALLAST CONTROL IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| IR21592_08 | 制造商:IRF 制造商全稱:International Rectifier 功能描述:IR21592 Dimming Ballast Control IC Design Kit |
| IR21592PBF | 功能描述:功率驅動器IC Dim Ballast Cntrl 1.8us Deadtime RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
| IR21592PBF | 制造商:International Rectifier 功能描述:Controller IC Output Voltage Max.:20V |
| IR21592S | 功能描述:IC CNTRLR BALLAST DIMMING 16SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 照明，鎮流器控制器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 類型:CCFL 控制器 頻率:40 ~ 80 kHz 電流 - 電源:5mA 電流 - 輸出:- 電源電壓:4.5 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) 其它名稱:90-3991V+V01 |
| IR21592SPBF | 功能描述:功率驅動器IC DIMMING BALLAST CTRL 0.5 to 5V DC RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。