- 您現在的位置：買賣IC網 > PDF目錄377500 > IR3621MTR (International Rectifier) 2-PHASE / DUAL SYNCHRONOUS PWM CONTROLLER WITH OSCILLATOR SYNCHRONIZATION AND PRE-BIAS STARTUP PDF資料下載
參數資料
| 型號： | IR3621MTR |
| 廠商： | International Rectifier |
| 英文描述： | 2-PHASE / DUAL SYNCHRONOUS PWM CONTROLLER WITH OSCILLATOR SYNCHRONIZATION AND PRE-BIAS STARTUP |
| 中文描述： | 2相/雙同步PWM控制器，帶有振蕩器同步操作和預偏置啟動 |
| 文件頁數： | 10/29頁 |
| 文件大?。?/td> | 389K |
| 代理商： | IR3621MTR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
10
IR3621 & (PbF)
www.irf.com
Frequency Synchronization
The IR3621 is capable of accepting an external digital
synchronization signal. Synchronization will be enabled
by the rising edge at an external clock. Per-channel switch-
ing frequency is set by external resistor (Rt). The free
running oscillator frequency is twice the per-channel fre-
quency. During synchronization, Rt is selected such that
the free running frequency is 20% below the sync fre-
quency. Synchronization capability is provided for both 2-
output and 2-phase configurations. When unused, the
Sync pin will remain floating and is noise immune.
Thermal Shutdown
Temperature sensing is provided inside IR3621. The trip
threshold is typically set to 140
!
C. When trip threshold is
exceeded, thermal shutdown turns off both MOSFETs.
Thermal shutdown is not latched and automatic restart is
initiated when the sensed temperature drops to normal
range. There is a 20
!
C hysteresis in the shutdown thresh-
old.
Power Good
The IR3621 provides a power good signal. The power good
signal should be available after both outputs have reached
regulation. This pin needs to be externally pulled high.
High state indicates that outputs are in regulation.
Power good will be low if either one of the output voltages
is 10% below the set value. There is only one power good
for both outputs.
Shutdown
The outputs can be shutdown independently by pulling
the respective soft-start pins below 0.3V. This can be
easily done by using an external small signal transis-
tor. During shutdown both MOSFETs will be turned off.
During this mode the LDO will stay on. Normal opera-
tion will resume by cycling soft start pins.
Operation Frequency Selection
The optimum operating frequency range for the IR3621
is 300kHz per phase, theoretically the IR3621 can be
operated at higher switching frequency (e.g. 500kHz).
However the power dissipation for IC, which is function
of applied voltage, gate drivers load and switching fre-
quency, will result in higher junction temperature of de-
vice. It may exceed absolute maximum rating of junc-
tion temperature, figure 18 (page 17) shows case tem-
perature versus switching frequency with different ca-
pacitive loads for TSSOP package.
This should be considered when using IR3621 for such
application. The below equation shows the relationship
between the IC's maximum power dissipation and Junc-
tion temperature:
Pd =
Τ
J-
Τ
A
θ
JA
Over-Voltage Protection OVP
Over-voltage is sensed through separate V
OUT
sense pins
V
SEN1
and V
SEN2
. A separate OVP circuit is provided for
each output. Upon over-voltage condition of either one of
the outputs, the OVP forces a latched shutdown on both
outputs. In this mode, the upper FET drivers turn off and
the lower FET drivers turn on, thus crowbaring the out-
puts. Reset is performed by recycling Vcc.
Error Amplifier
The IR3621 is a voltage mode controller. The error ampli-
fiers are of transconductance type. In independent mode,
each amplifier closes the loop around its own output volt-
age. In current sharing mode, amplifier 1 becomes the
master which regulates the common output voltage. Am-
plifier 2 performs the current sharing function. Both am-
plifiers are capable of operating with Type III compensa-
tion control scheme.
Figure 10- Switching Frequency versus External Resistor.
Where:
Tj: Maximum Operating Junction Temperature
TA: Ambient Temperature
θ
JA
= Thermal Impedance of package
The switching frequency is determined by an external
resistor (Rt). The switching frequency is approximately
inversely proportioned to resistance (see Fig 10).
Per Channel Switching Frequency vs. RT
0
100
200
300
400
500
600
700
0
10
20
30
40
50
60
70
RT (kohm)
S
相關PDF資料 |
PDF描述 |
|---|---|
| IR3621MTRPBF | 2-PHASE / DUAL SYNCHRONOUS PWM CONTROLLER WITH OSCILLATOR SYNCHRONIZATION AND PRE-BIAS STARTUP |
| IR3621PBF | 2-PHASE / DUAL SYNCHRONOUS PWM CONTROLLER WITH OSCILLATOR SYNCHRONIZATION AND PRE-BIAS STARTUP |
| IR3622AMPBF | HIGH FREQUENCY 2-PHASE, SINGLE OR DUAL OUTPUT SYNCHRONOUS STEP DOWN CONTROLLER WITH OUTPUT TRACKING AND SEQUENCING |
| IR3622MPBF | HIGH FREQUENCY 2-PHASE, SINGLE OR DUAL OUTPUT SYNCHRONOUS STEP DOWN CONTROLLER WITH OUTPUT TRACKING AND SEQUENCING |
| IR3637STRPBF | 1% ACCURATE SYNCHRONOUS PWM CONTROLLER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| IR3621MTRPBF | 功能描述:DC/DC 開關控制器 2-PHASE DUAL SYNC PWM CTRLLER RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| IR3621PBF | 制造商:IRF 制造商全稱:International Rectifier 功能描述:2-PHASE / DUAL SYNCHRONOUS PWM CONTROLLER WITH OSCILLATOR SYNCHRONIZATION AND PRE-BIAS STARTUP |
| IR3622AMPBF | 功能描述:IC REG CTRLR BUCK PWM VM 32MLPQ RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,000 系列:- PWM 型:電壓模式 輸出數:1 頻率 - 最大:1.5MHz 占空比:66.7% 電源電壓:4.75 V ~ 5.25 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:40-VFQFN 裸露焊盤 包裝:帶卷 (TR) |
| IR3622AMTRPBF | 功能描述:開關變換器、穩壓器與控制器 2 CH OR 2 PHASE SYNC PWM CNTRLR RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
| IR3622MPBF | 功能描述:IC REG CTRLR BUCK PWM VM 32MLPQ RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:4,000 系列:- PWM 型:電壓模式 輸出數:1 頻率 - 最大:1.5MHz 占空比:66.7% 電源電壓:4.75 V ~ 5.25 V 降壓:是 升壓:無 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 85°C 封裝/外殼:40-VFQFN 裸露焊盤 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。