- 您現在的位置：買賣IC網 > PDF目錄377560 > IS61LPD102418A-250B3 (INTEGRATED SILICON SOLUTION INC) 512K x 36, 1024K x 18 18Mb SYNCHRONOUS PIPELINED, DOUBLE CYCLE DESELECT STATIC RAM PDF資料下載
參數資料
| 型號： | IS61LPD102418A-250B3 |
| 廠商： | INTEGRATED SILICON SOLUTION INC |
| 元件分類： | DRAM |
| 英文描述： | 512K x 36, 1024K x 18 18Mb SYNCHRONOUS PIPELINED, DOUBLE CYCLE DESELECT STATIC RAM |
| 中文描述： | 1M X 18 CACHE SRAM, 2.6 ns, PBGA165 |
| 封裝： | 13 X 15 MM, 1 MM PITCH, PLASTIC, BGA-165 |
| 文件頁數： | 18/29頁 |
| 文件大?。?/td> | 219K |
| 代理商： | IS61LPD102418A-250B3 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
18
Integrated Silicon Solution, Inc. — 1-800-379-4774
Rev. B
02/03/06
IS61VPD51236A, IS61VPD102418A, IS61LPD51236A ,IS61LPD102418A
ISSI
IEEE 1149.1 SERIAL BOUNDARY SCAN (JTAG)
The IS61LPD/VPD51236A and IS61LPD/VPD102418A
have a serial boundary scan Test Access Port (TAP) in
the PBGA package only. (The TQFP package not avail-
able.) This port operates in accordance with
IEEE
Stan-
dard 114
9
.1-1
9
00, but does not include all functions
required for full 114
9
.1 compliance. These functions from
the
IEEE specification
are excluded because they place
added delay in the critical speed path of the SRAM. The
TAP controller operates in a manner that does not conflict
with the performance of other devices using 114
9
.1 fully
compliant TAPs. The TAP operates using JEDEC stan-
dard 2.5V I/O logic levels.
DISABLING THE JTAG FEATURE
The SRAM can operate without using the JTAG feature.
To disable the TAP controller, TCK must be tied LOW
(Vss) to prevent clocking of the device. TDI and TMS are
internally pulled up and may be disconnected. They may
alternately be connected to V
DD
through a pull-up resistor.
TDO should be left disconnected. On power-up, the
device will start in a reset state which will not interfere with
the device operation.
TEST ACCESS PORT (TAP) - TEST CLOCK
The test clock is only used with the TAP controller. All
inputs are captured on the rising edge of TCK and outputs
are driven from the falling edge of TCK.
TEST MODE SELECT (TMS)
The TMS input is used to send commands to the TAP
controller and is sampled on the rising edge of TCK. This
pin may be left disconnected if the TAP is not used. The
pin is internally pulled up, resulting in a logic HIGH level.
TEST DATA-IN (TDI)
The TDI pin is used to serially input information to the
registers and can be connected to the input of any
register. The register between TDI and TDO is chosen by
the instruction loaded into the TAP instruction register.
For information on instruction register loading, see the
TAP Controller State Diagram. TDI is internally pulled up
and can be disconnected if the TAP is unused in an
application. TDI is connected to the Most Significant Bit
(MSB) on any register.
31 30 29
. . .
Identification Register
2
1
0
2
1
0
0
x
. . . . .
Boundary Scan
Register*
2
1
0
Bypass Register
Instruction Register
TAP CONTROLLER
Selection Circuitry
Selection Circuitry
TDO
TDI
TCK
TMS
TAP CONTROLLER BLOCK DIAGRAM
相關PDF資料 |
PDF描述 |
|---|---|
| IS61LPD102418A-250B3I | 512K x 36, 1024K x 18 18Mb SYNCHRONOUS PIPELINED, DOUBLE CYCLE DESELECT STATIC RAM |
| IS61LPD102418A-250TQ | 512K x 36, 1024K x 18 18Mb SYNCHRONOUS PIPELINED, DOUBLE CYCLE DESELECT STATIC RAM |
| IS61LPD102418A-250TQI | 512K x 36, 1024K x 18 18Mb SYNCHRONOUS PIPELINED, DOUBLE CYCLE DESELECT STATIC RAM |
| IS61LPD25636A-250B2I | 256K x 36, 512K x 18 9 Mb SYNCHRONOUS PIPELINED, DOUBLE CYCLE DESELECT STATIC RAM |
| IS61LPD25636A-250B3 | 256K x 36, 512K x 18 9 Mb SYNCHRONOUS PIPELINED, DOUBLE CYCLE DESELECT STATIC RAM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| IS61LPD102418A-250B3I | 功能描述:靜態隨機存取存儲器 18Mb,Pipeline,Sync,1Mb x 18,250MHz,3.3V or 2.5V I/O,165 Ball BGA RoHS:否 制造商:Cypress Semiconductor 存儲容量:16 Mbit 組織:1 M x 16 訪問時間:55 ns 電源電壓-最大:3.6 V 電源電壓-最小:2.2 V 最大工作電流:22 uA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:TSOP-48 封裝:Tray |
| IS61LPD102418A-250B3I-TR | 功能描述:靜態隨機存取存儲器 18Mb,Pipeline,Sync,1Mb x 18,250MHz,3.3V or 2.5V I/O,165 Ball BGA RoHS:否 制造商:Cypress Semiconductor 存儲容量:16 Mbit 組織:1 M x 16 訪問時間:55 ns 電源電壓-最大:3.6 V 電源電壓-最小:2.2 V 最大工作電流:22 uA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:TSOP-48 封裝:Tray |
| IS61LPD102418A-250B3-TR | 功能描述:靜態隨機存取存儲器 18Mb,Pipeline,Sync,1Mb x 18,250MHz,3.3V or 2.5V I/O,165 Ball BGA RoHS:否 制造商:Cypress Semiconductor 存儲容量:16 Mbit 組織:1 M x 16 訪問時間:55 ns 電源電壓-最大:3.6 V 電源電壓-最小:2.2 V 最大工作電流:22 uA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:TSOP-48 封裝:Tray |
| IS61LPD102418A-250TQ | 功能描述:靜態隨機存取存儲器 18Mb,Pipeline,Sync,1Mb x 18,250MHz,3.3V or 2.5V I/O,100 Pin TQFP RoHS:否 制造商:Cypress Semiconductor 存儲容量:16 Mbit 組織:1 M x 16 訪問時間:55 ns 電源電壓-最大:3.6 V 電源電壓-最小:2.2 V 最大工作電流:22 uA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:TSOP-48 封裝:Tray |
| IS61LPD102418A-250TQI | 功能描述:靜態隨機存取存儲器 18Mb,Pipeline,Sync,1Mb x 18,250MHz,3.3V or 2.5V I/O,100 Pin TQFP RoHS:否 制造商:Cypress Semiconductor 存儲容量:16 Mbit 組織:1 M x 16 訪問時間:55 ns 電源電壓-最大:3.6 V 電源電壓-最小:2.2 V 最大工作電流:22 uA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:TSOP-48 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。