參數資料
型號: ISL22426UFV14Z-TK
廠商: Intersil
文件頁數: 5/15頁
文件大小: 0K
描述: IC POT DGTL 128TP LN LP 14-TSSOP
標準包裝: 1,000
系列: XDCP™
接片: 128
電阻(歐姆): 50k
電路數: 2
溫度系數: 標準值 ±80 ppm/°C
存儲器類型: 非易失
接口: 4 線 SPI(芯片選擇)
電源電壓: 2.7 V ~ 5.5 V
工作溫度: -40°C ~ 125°C
安裝類型: 表面貼裝
封裝/外殼: 14-TSSOP(0.173",4.40mm 寬)
供應商設備封裝: 14-TSSOP
包裝: 帶卷 (TR)
13
FN6180.2
September 8, 2009
Applications Information
Communicating with ISL22426
Communication with ISL22426 proceeds using SPI interface
through the ACR (address 1000b), IVRi (addresses 0000b,
0001b) and WRi (addresses 0000b, 0001b) registers.
The wiper of the potentiometer is controlled by the WRi
register. Writes and reads can be made directly to these
registers to control and monitor the wiper position without
any non-volatile memory changes. This is done by setting
MSB bit at address 1000b to 1.
The non-volatile IVRi stores the power up value of the wiper.
IVRs are accessible when MSB bit at address 1000b is set
to 0. Writing a new value to the IVRi register will set a new
power-up position for the wiper. Also, writing to this register
will load the same value into the corresponding WRi as the
IVRi. Reading from the IVRi will not change the WRi, if its
contents are different.
Examples
A. Writing to the IVR
This sequence will write a new value (77h) to the IVR0
(non-volatile):
Set the ACR (Addr 1000b) for NV write (40h)
Send the ID byte, Instruction Byte, then the Data byte
Set the IVR0 (Addr 0000b) to 77h
Send the ID byte, Instruction Byte, then the Data byte
B. Reading from the WR
This sequence will read the value from the WR1 (volatile):
Write to ACR first to access the WRs
Send the ID byte, Instruction Byte, then the Data byte
Read the data from WR1 (Addr 0001b)
Send the ID byte, Instruction Byte, then Read the Data byte
01 010 000 110 010 000 100 000 0
(Sent to DI)
01 010 000 110 000 000 111 011 1
(Sent to DI)
01 010 000 110 010 001 100 000 0
(Sent to DI)
0 1 0 1 0 0 0 0 1 0 1 1 0 0 0 1 x xxx xxxx
(Out on DO)
ISL22426
相關PDF資料
PDF描述
MC10E195FNG IC DELAY LINE 128TAP 28-PLCC
ISL22326UFR16Z-TK IC POT DGTL 128TP LN LP 16-QFN
ISL22416UFRT10Z IC POT DGTL 128TP LN LP 10-TDFN
MS27508E22B35SD CONN RCPT 100POS BOX MNT W/SCKT
ISL22416WFRT10Z IC POT DGTL 128TP LN LP 10-TDFN
相關代理商/技術參數
參數描述
ISL22426WFR16Z 功能描述:數字電位計 IC 128 TAP FL RNG IND DL DCP 16LD 4X4 RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL22426WFR16Z-TK 功能描述:數字電位計 IC 128 TAP FL RNG DCP 16LD 4X4 RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL22426WFV14Z 功能描述:數字電位計 IC 128 TAP FL RNG IND DCP 14LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL22426WFV14Z-TK 功能描述:數字電位計 IC 128 TAP FL RNG IND DCP 14LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL22429 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Low Noise, Low Power, SPI Bus, 128 Taps, Wiper Only