13 FN7872.0 June 21, 2011 Functional Pin Descriptions Potentiometers Pins RHI
參數資料
型號: ISL23345WFVZ-T7A
廠商: Intersil
文件頁數: 5/19頁
文件大小: 0K
描述: IC DGTL POT QUAD 10K 20TSSOP
標準包裝: 1
系列: XDCP™
接片: 256
電阻(歐姆): 10k
電路數: 4
溫度系數: 標準值 125 ppm/°C
存儲器類型: 易失
接口: I²C,2 線串口
電源電壓: 1.2 V ~ 5.5 V,1.7 V ~ 5.5 V
工作溫度: -40°C ~ 125°C
安裝類型: 表面貼裝
封裝/外殼: 20-TSSOP(0.173",4.40mm 寬)
供應商設備封裝: 20-TSSOP
包裝: 標準包裝
其它名稱: ISL23345WFVZ-T7ADKR
ISL23345
13
FN7872.0
June 21, 2011
Functional Pin Descriptions
Potentiometers Pins
RHI AND RLI
The high (RHi, i = 0, 1, 2, 3) and low (RLi, i = 0, 1, 2, 3) terminals
of the ISL23345 are equivalent to the fixed terminals of a
mechanical potentiometer. RHi and RLi are referenced to the
relative position of the wiper and not the voltage potential on the
terminals. With WRi set to 255 decimal, the wiper will be closest
to RHi, and with the WRi set to 0, the wiper is closest to RLi.
RWI
RWi (i = 0, 1, 3) is the wiper terminal, and it is equivalent to the
movable terminal of a mechanical potentiometer. The position of
the wiper within the array is determined by the WRi register.
VCC
Power terminal for the potentiometer section analog power source.
Can be any value needed to support the voltage range of the DCP
pins, from 1.7V to 5.5V, independent of the VLOGIC voltage.
Bus Interface Pins
SERIAL DATA INPUT/OUTPUT (SDA)
The SDA is a bidirectional serial data input/output pin for I2C
interface. It receives device address, wiper address and data
from an I2C external master device at the rising edge of the serial
clock SCL, and it shifts out data after each falling edge of the
serial clock.
SDA requires an external pull-up resistor, since it is an open drain
input/output.
SERIAL CLOCK (SCL)
This input is the serial clock of the I2C serial interface. SCL
requires an external pull-up resistor, since a master is an open
drain output.
DEVICE ADDRESS (A2, A1, A0)
The address inputs are used to set the least significant 3 bits of
the 7-bit I2C interface slave address. A match in the slave
address serial data stream must match with the Address input
FIGURE 21. WIPER LARGE SIGNAL SETTLING TIME
FIGURE 22. POWER-ON START-UP IN VOLTAGE DIVIDER MODE
FIGURE 23. 10k
Ω -3dB CUT OFF FREQUENCY
FIGURE 24. STANDBY CURRENT vs TEMPERATURE
Typical Performance Curves (Continued)
SCL 9TH CLOCK OF THE
DATA BYTE (ACK)
1V/DIV
0.2s/DIV
WIPER
SCL
0.5V/DIV
20s/DIV
VCC
WIPER
0.5V/DIV, 0.2s/DIV
-3dB FREQUENCY = 1.437MHz AT MIDDLE TAP
CH1: RH TERMINAL
CH2: RW TERMINAL
0
0.2
0.4
0.6
0.8
1.0
1.2
1.4
1.6
1.8
-40
-15
10
35
60
85
110
VCC = 1.7V, VLOGIC = 1.2V
VCC = 5.5V, VLOGIC = 5.5V
S
T
A
N
D
B
Y
C
U
R
E
N
T
I C
C
(
A
)
TEMPERATURE (°C)
相關PDF資料
PDF描述
VE-B3W-MY-F1 CONVERTER MOD DC/DC 5.5V 50W
VE-B3V-MY-F4 CONVERTER MOD DC/DC 5.8V 50W
VE-B3V-MY-F2 CONVERTER MOD DC/DC 5.8V 50W
VE-B3V-MY-F1 CONVERTER MOD DC/DC 5.8V 50W
VE-B3T-MY-F4 CONVERTER MOD DC/DC 6.5V 50W
相關代理商/技術參數
參數描述
ISL23345WFVZ-TK 功能描述:數字電位計 IC 256 TAP VOLATILE I2C QD FL RNG DCP 20LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL23348 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Quad, 128 Tap, Low Voltage Digitally Controlled Potentiometer (XDCPa?¢)
ISL23348TFRZ 功能描述:數字電位計 IC 128 TAP VOLATILE I2C QD FL RNG DCP 20LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL23348TFRZ-T7A 功能描述:數字電位計 IC 128 TAPVOLATILE I2C QUAD RNG IND 20LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL23348TFRZ-TK 功能描述:數字電位計 IC 128 TAP VOLATILE I2C QD FL RNG DCP 20LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel