15 FN7780.1 August 16, 2011 Write Operation A write operation to the ISL23415 is a two or more bytes operation. It requires first, the" />
參數資料
型號: ISL23415TFRUZ-T7A
廠商: Intersil
文件頁數: 7/20頁
文件大小: 0K
描述: IC DGTL POT 256POS 100K 10TQFN
產品培訓模塊: Solutions for Industrial Control Applications
標準包裝: 1
系列: XDCP™
接片: 256
電阻(歐姆): 100k
電路數: 1
溫度系數: 標準值 70 ppm/°C
存儲器類型: 易失
接口: 4 線 SPI(芯片選擇)
電源電壓: 1.2 V ~ 5.5 V,1.7 V ~ 5.5 V
工作溫度: -40°C ~ 125°C
安裝類型: 表面貼裝
封裝/外殼: 10-UFQFN
供應商設備封裝: 10-UTQFN(2.1x1.6)
包裝: 標準包裝
其它名稱: ISL23415TFRUZ-T7ADKR
ISL23415
15
FN7780.1
August 16, 2011
Write Operation
A write operation to the ISL23415 is a two or more bytes
operation. It requires first, the CS transition from HIGH-to-LOW.
Then the host sends a valid Instruction Byte, followed by one or
more Data Bytes to the SDI pin. The host terminates the write
operation by pulling the CS pin from LOW-to-HIGH. Instruction is
executed on the rising edge of CS (see Figure 27).
Read Operation
A Read operation to the ISL23415 is a four byte operation. It
requires first, the CS transition from HIGH-to-LOW. Then the host
sends a valid Instruction Byte, followed by a “dummy” Data Byte,
NOP Instruction Byte and another “dummy” Data Byte to SDI pin.
The SPI host receives the Instruction Byte (instruction code +
register address) and requested Data Byte from SDO pin on the
rising edge of SCK during third and fourth bytes, respectively. The
host terminates the read by pulling the CS pin from LOW-to-HIGH
(see Figure 28).
TABLE 4. INSTRUCTION SET
INSTRUCTION SET
OPERATION
I2
I1
I0
R4
R3
R2
R1
R0
0
XXX
XX
NOP
0
1
XXX
XX
ACR READ
0
1
XXX
XX
ACR WRTE
1
0
R4R3R2R1R0
WRi or ACR READ
1
0
R4R3R2R1R0
WRi or ACR WRTE
Where X means “do not care”.
FIGURE 27. TWO BYTE WRITE SEQUENCE
CS
SCK
SDI
SDO
WR INSTRUCTION
DATA BYTE
1
3
4
5
7
8
9
1011
1213141516
26
ADDR
FIGURE 28. FOUR BYTE READ SEQUENCE
CS
SCK
SDI
SDO
RD
ADDR
NOP
RD
ADDR
READ DATA
1
8
16
24
32
相關PDF資料
PDF描述
VI-BNW-MW-B1 CONVERTER MOD DC/DC 5.5V 100W
DS1672S-33/T&R IC TIMEKEEPER 3.3V 32-BIT 8-SOIC
VI-BNW-MV CONVERTER MOD DC/DC 5.5V 150W
M83723/76W14126 CONN PLUG 12POS STRAIGHT W/PINS
VI-BNV-MW-B1 CONVERTER MOD DC/DC 5.8V 100W
相關代理商/技術參數
參數描述
ISL23415TFRUZ-TK 功能描述:數字電位計 IC 256 TAP VOLATILE SPI FL RNG INC DCP 21X16 RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL23415TFUZ 功能描述:數字電位計 IC 256 TAP VOLATILE SPI DL FL RNG DCP 10LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL23415TFUZ-T7A 功能描述:數字電位計 IC 256 TAP VOLATILE SPI DL FL RNG DCP 10LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL23415TFUZ-TK 功能描述:數字電位計 IC 256 TAP VOLATILE SPI DL FL RNG DCP 10LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL23415UFRUZ-T7A 功能描述:數字電位計 IC 256 TAP VOLATILE SPI FL RNG INC DCP 21X16 RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel