17 FN7905.0 August 19, 2011 Wiper Transition When stepping up through each tap in voltage divider mode, some tap transition points can" />
參數資料
型號： ISL23448TFRZ-TK
廠商： Intersil
文件頁數： 9/21頁
文件大?。?/td> 0K
描述： IC DGTL POT 4CH 100K 20QFN
產品培訓模塊： Solutions for Industrial Control Applications
標準包裝： 1,000
系列： XDCP™
接片： 128
電阻（歐姆）： 100k
電路數： 4
溫度系數： 標準值 45 ppm/°C
存儲器類型： 易失
接口： 4 線 SPI（芯片選擇）
電源電壓： 1.2 V ~ 5.5 V，1.7 V ~ 5.5 V
工作溫度： -40°C ~ 125°C
安裝類型： 表面貼裝
封裝/外殼： 20-VFQFN 裸露焊盤
供應商設備封裝： 20-QFN（3x4）
包裝： 帶卷 (TR)
ISL23448
17
FN7905.0
August 19, 2011
Wiper Transition
When stepping up through each tap in voltage divider mode,
some tap transition points can result in noticeable voltage
transients, or overshoot/undershoot, resulting from the sudden
transition from a very low impedance “make” to a much higher
impedance “break” within a short period of time (<1s). There
are several code transitions such as 0Fh to 10h, 1Fh to 20h,...,
6Fh to 7Fh, which have higher transient glitch. Note, that all
switching transients will settle well within the settling time as
stated in the datasheet. A small capacitor can be added
externally to reduce the amplitude of these voltage transients,
but that will also reduce the useful bandwidth of the circuit, thus,
this may not be a good solution for some applications. It may be
a good idea, in this case, to use fast amplifiers in a signal chain
for fast recovery.
VLOGIC Requirements
It is recommended to keep VLOGIC powered all the time during
normal operation. In a case where turning VLOGIC OFF is
necessary, it is recommended to ground the VLOGIC pin of the
ISL23448. Grounding the VLOGIC pin or both VLOGIC and VCC does
not affect other devices on the same bus. It is good practice to put
a 1F capacitor in parallel with 0.1F decoupling capacitor close to
the VLOGIC pin.
VCC Requirements and Placement
It is recommended to put a 1F capacitor in parallel with 0.1F
decoupling capacitor close to the VCC pin.
CS
SCK
MOSI
MISO
CS
SCK
SDI
SDO
CS
SCK
SDI
SDO
CS
SCK
SDI
SDO
CS
SCK
SDI
SDO
C
DCP0
DCP1
DCP2
DCP(N-1)
FIGURE 29. DAISY CHAIN CONFIGURATION
N DCP IN A CHAIN
CS
SCK
SDI
SDO 0
WR
D C P2
WR
D C P1
WR
D C P0
WR
D C P1
SDO 1
WR
D C P2
SDO 2
WR
D C P2
FIGURE 30. DAISY CHAIN WRITE SEQUENCE OF N = 3 DCP
16 CLKLS
16 CLKS
相關PDF資料
PDF描述
DS1010-80 IC DELAY LINE 10TAP 80NS 14-DIP
VE-244-MX-B1 CONVERTER MOD DC/DC 48V 75W
ISL23348WFVZ-TK IC DGTL POT 4CH 10K 20TSSOP
VI-26F-MY-F1 CONVERTER MOD DC/DC 72V 50W
VE-244-MW CONVERTER MOD DC/DC 48V 100W
相關代理商/技術參數
參數描述
ISL23448TFVZ 功能描述:數字電位計 IC 128 TAP VOLATILE SPI QD FL RNG DCP 20LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL23448TFVZ-T7A 功能描述:數字電位計 IC 128 TAPVOLATILE SPI QUAD RNG IND 20LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL23448TFVZ-TK 功能描述:數字電位計 IC 128 TAP VOLATILE SPI QD FL RNG DCP 20LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL23448UFRZ 功能描述:數字電位計 IC 128 TAP VOLATILE SPI QD FL RNG DCP 20LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
ISL23448UFRZ-T7A 功能描述:數字電位計 IC 128 TAPVOLATILE SPI QUAD RNG IND 20LD RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*