- 您現在的位置：買賣IC網 > PDF目錄5863 > ISL28213FUZ (Intersil)IC OPAMP GP RRIO 2MHZ DUAL 8MSOP PDF資料下載
參數資料
| 型號： | ISL28213FUZ |
| 廠商： | Intersil |
| 文件頁數： | 7/23頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP GP RRIO 2MHZ DUAL 8MSOP |
| 標準包裝： | 50 |
| 放大器類型： | 通用 |
| 電路數： | 2 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 1 V/µs |
| 增益帶寬積： | 2MHz |
| 電流 - 輸入偏壓： | 3pA |
| 電壓 - 輸入偏移： | 500µV |
| 電流 - 電源： | 90µA |
| 電流 - 輸出 / 通道： | 22mA |
| 電壓 - 電源，單路/雙路(±)： | 1.8 V ~ 5.5 V，±0.9 V ~ 2.5 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-TSSOP，8-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 8-MSOP |
| 包裝： | 管件 |
ISL28113, ISL28213, ISL28413
15
FN6728.7
November 15, 2012
Revision History
The revision history provided is for informational purposes only and is believed to be accurate, but not warranted. Please go to Web to make sure you
have the latest Rev.
DATE
REVISION
CHANGE
10/25/12
FN6728.7
Ordering Information changes on page 2:
Removed “italics font” on “ISL28213FHZ-T7A” entry
Changed on both the 28213FHZ entries, “Part Marking” from “BCP” to “BEKA”
Added Note 3 Lead Finish Note for 8 Ld SOT-23 package
Added Note 5 reference for all the SOT-23 and SC-70 entries (6 total), after the part marking, and added the note to Table.
Added POD P8.064 on page 23
4/16/12
FN6728.6
Mask changes have been made from RevA to RevB, datasheet updated to reflect new silicon.
Page 4: Vos limits changed from ±5mV to ±4mV at room temp and ±6mV to ±5mV at +125°C.
TcVos, Max spec removed, typical increased from 2 to 5.
Page 7, Replaced Figure 8 with new graph.
Page 7, Replaced Figure 11 with new graph.
Page 8, Replaced Figure 18 with new graph.
5/18/11
FN6728.5
- On page 2, Ordering Information table: ISL28113FHZ-T7 & -T7A PKG DWG # changed from MDP0038 (Obsoleted) to
P5.064A. Removed ISL28213FHZ and added “Coming Soon” to parts ISL28213FHZ-T7A and ISL28413TSSOPEVAL1Z.
- On page 3, Pin Descriptions: Circuit 3 diagram, removed anti-parallel diodes from the IN+ to IN- terminals.
- On page 4, Absolute Maximum Ratings: changed Differential Input Voltage from "0.5V" to "V- - 0.5V to V+ + 0.5V".
- On page 4, updated CMRR and PSRR parameters in Electrical Specifications table with test condition specifiying -40°C
to +125°C typical parameter.
- On page 5, updated Note 6 (“over-temp” note) referenced in MIN and MAX column headings of Electrical Specifications
table from "Parameters with MIN and/or MAX limits are 100% tested at +25°C, unless otherwise specified. Temperature
limits established by characterization and are not production tested." to new standard "Compliance to datasheet limits is
assured by one or more methods: production test, characterization and/or design."
- On page 9, under “Input ESD Diode Protection,” removed “They also contain back to-back diodes across the input
terminals.” Changed “For applications where the input differential voltage is expected to exceed 0.5V, an external series
resistor...” to “For applications where the input differential voltage may exceed either power supply voltage by 0.5V or
more, an external series resistor...”. Removed “Although the amplifier is fully protected, high input slew rates that exceed
the amplifier slew rate (±1V/s) may cause output distortion.”
- On page 9, Figure 19: updated circuit schematic by removing back-to-back input protection diodes.
- On page 18, replaced Package Outline Drawing MDP0038 (obsolete) with P5.064A.
3/23/10
FN6728.4
Page 1, 2nd paragraph - Added “...SOT23-8 packages...” and changed “SO8” to “SOIC8”.
Also global, changed S08 to SOIC8
Pg 2, Ordering Information table: Part # ISL28213FEZ changed to ISL28213FHZ and Part Marking changed to "TBD"
-Added Related Literature on page 1, updated ordering information by adding Eval boards.
-Added to ordering information part number ISL28213FHZ 8 Ld SOT-23 Package as coming soon.
-Replaced Figure 24 Simulated Input Noise Voltage with following changes:
Y-axis from “10 to 100” to “10,000 to 10”
Removed (A) AC sims.dat (active) from top of graph
Curve changed to improve noise performance
Made changes to Spice Net List as follows:
-Changed Revision from “C” to “D” and added improved noise performance to Revision line.
-Changed in Voltage Noise
“V_V9 29 0 .00035” to “V_V9 29 0 0.45”
“R_R21
28 0 800E3 TC=0,0” to “R_R21
28 0 30”
-Removed TC=0 in Input Stage from R_R1 through C_Cin2
-Removed TC=0 in 1st Gain Stage from R_R9 through R_R12
-Removed TC=0 in 2nd Gain Stage from R_R13 through C_C3
-Changed in Common Mode Gain Stage with Zero
“G_G5
V++ VC VCM VMID 2.5118E-10” to “G_G5
V++ VC VCM VMID 0.25118”
“G_G6
V-- VC VCM VMID 2.5118E-10” to “G_G6
V-- VC VCM VMID 0.25118”
Removed TC=0 from R_R16 through R_R23
-Changed in Pole Stage
“G_G7
V++ 23 VG VMID 188.49e-6” to ‘G_G7
V++ 23 VG VMID 0.18849”
“G_G8
V-- 23 VG VMID 188.49e-6” to “G_G8
V-- 23 VG VMID 0.18849”
Removed TC=0 from R_R17 through C_C5
Removed TC=0 in Output Stage with Correction Current Sources from R_R19 and R_R20
Made changes to Spice Schematic Figure 21 as follows:
-Input Stage - Modified connection to the EOS (voltage control voltage source)
-Added to Thermal Information 8 LD SOT-23 as TBD
-Added to pin configuration for the ISL28213 8 Ld SOT-23
相關PDF資料 |
PDF描述 |
|---|---|
| MTMM-102-02-T-D-150 | CONN HEADER 4POS 2MM DL TIN |
| RNCP0603FTD3K32 | RES 3.32K OHM 1/8W 1% 0603 SMD |
| FWK-35A25F | FUSE 35A 750V 25X146MM FERRULE |
| MTSW-106-09-T-S-430-RA | CONN HEADER 6POS .100" TH |
| RNCP0603FTD2K21 | RES 2.21K OHM 1/8W 1% 0603 SMD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL28213FUZ-T7 | 功能描述:IC OPAMP GP RRIO 2MHZ DUAL 8MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:MicroAmplifier™ 放大器類型:通用 電路數:2 輸出類型:- 轉換速率:3.5 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:5pA 電壓 - 輸入偏移:1500µV 電流 - 電源:220µA 電流 - 輸出 / 通道:60mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 36 V，±2.25 V ~ 18 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:帶卷 (TR) |
| ISL28213MSOPEVAL2Z | 功能描述:EVALUATION BOARD FOR ISL28213 RoHS:是 類別:編程器，開發系統 >> 評估板 - 運算放大器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- |
| ISL28213SOICEVAL2Z | 功能描述:EVALUATION BOARD FOR ISL28213 RoHS:是 類別:編程器，開發系統 >> 評估板 - 運算放大器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- |
| ISL28214 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Single, Dual, Quad General Purpose Micropower, RRIO Operational Amplifiers |
| ISL28214FBZ | 功能描述:IC OPAMP GP RRIO 5MHZ DUAL 8SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1 系列:- 放大器類型:儀表 電路數:2 輸出類型:滿擺幅 轉換速率:5 V/µs 增益帶寬積:- -3db帶寬:2MHz 電流 - 輸入偏壓:0.5pA 電壓 - 輸入偏移:250µV 電流 - 電源:415µA 電流 - 輸出 / 通道:48mA 電壓 - 電源，單路/雙路(±):2.5 V ~ 5.5 V，±1.25 V ~ 2.75 V 工作溫度:-55°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:剪切帶 (CT) 產品目錄頁面:849 (CN2011-ZH PDF) 其它名稱:296-12431-1296-12431-1-NDINA2331AIPWRCT |
發布緊急采購，3分鐘左右您將得到回復。