- 您現在的位置：買賣IC網 > PDF目錄1926 > ISL36111DRZ-TS (Intersil)IC EQUALIZER REC 11.1GBPS 16QFN PDF資料下載
參數資料
| 型號： | ISL36111DRZ-TS |
| 廠商： | Intersil |
| 文件頁數： | 6/9頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC EQUALIZER REC 11.1GBPS 16QFN |
| 標準包裝： | 100 |
| 系列： | QLx™ |
| 應用： | 數據傳輸 |
| 電源電壓： | 1.1 V ~ 1.3 V |
| 封裝/外殼： | 16-VFQFN 裸露焊盤 |
| 供應商設備封裝： | 16-QFN（3x3） |
| 包裝： | 帶卷 (TR) |
| 安裝類型： | 表面貼裝 |
ISL36111
6
FN6974.2
July 19, 2012
Line Silence/Quiescent Mode
Line silence is commonly broken by the limiting amplification in
other equalizers. This disruption can be detrimental in many
systems that rely on line silence as part of the protocol. The
ISL36111 contains special lane management capabilities to
detect and preserve periods of line silence while still providing
the fidelity-enhancing benefits of limiting amplification during
active data transmission. Line silence is detected by measuring
the amplitude of the input signal and comparing that to a
threshold set by the voltage at the DT pin. When the amplitude
falls below the threshold, the output driver stage is muted.
LOS Bar Indicator
Pin 4 (LOSB) is used to output the state of the muting circuitry to
serve as a loss of signal indicator for the device. This signal is
directly derived from the muting signal output by the detection
threshold / signal detector comparator. The LOSB signal goes
LOW when the signal detector output is below the externally
controlled detection threshold and HIGH when the detector
output goes above this threshold. This feature is meant to be
used in optical systems (e.g. SFP+) where there are no quiescent
or electrical-idle states. In these cases, the detection threshold is
used to determine the sensitivity of the LOSB indicator. Figure 7
shows the schematic of the LOSB equivalent output structure.
Detection Thereshold (DT) Pin
Functionality
The ISL36111 is capable of maintaining periods of line silence by
monitoring the channel for loss of signal (LOS) conditions and
subsequently muting the output driver when such a condition is
detected. A reference voltage applied to the detection threshold
(DT) pin is used to set the LOS threshold of the internal signal
detection circuitry. The DT voltage is set with an external pull-up
resistor, RDT. For typical applications, a 30kΩ resistor is
recommended for channels with loss greater than 12dB at 5GHz,
and a 1.8k
Ω resistor is recommended for lower loss channels.
Other values of the resistor may also be applicable; therefore DT
settings should be verified on an application-specific basis.
FIGURE 6. CML OUTPUT EQUIVALENT CIRCUIT FOR THE
ISL36111
VDD
50
OUT [P]
OUT [N]
FIGURE 7. LOSB EQUIVALENT OUTPUT STRUCTURE
VDD
LOSB
11k
Internal LOS
Indicator
Ω
相關PDF資料 |
PDF描述 |
|---|---|
| ISL36411DRZ-TS | IC EQUALIZER REC 11.3GBPS 46QFN |
| ISL4223EIR-T | IC TXRX 2TX/2RX 3V RS-232 20-QFN |
| ISL4243EIR-T | IC 3DRVR/5RCVR RS232 3V 32-QFN |
| ISL4245EIR-T | IC 3DRVR/5RCVR RS232 3V 32-QFN |
| ISL4260EIR-T | IC 3DRVR/2RCVR RS232 3V 32-QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL36356A-APDK | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:PRISM 11Mbps Wireless Local Area Network Access Point |
| ISL36356A-APDK-EVAL | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:PRISM 11Mbps Wireless Local Area Network Access Point |
| ISL36411 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Quad Lane Extender |
| ISL36411DRZ-EVALZ | 功能描述:EVAL BOARD FOR ISL36411DRZ RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:* 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- 主要目的:電源管理，電池充電器 嵌入式:否 已用 IC / 零件:MAX8903A 主要屬性:1 芯鋰離子電池 次要屬性:狀態 LED 已供物品:板 |
| ISL36411DRZ-T7 | 功能描述:接口 - 專用 ISL54100AHDMI EVAL BRD RHS CMPL 12 8LD RoHS:否 制造商:Texas Instruments 產品類型:1080p60 Image Sensor Receiver 工作電源電壓:1.8 V 電源電流:89 mA 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:BGA-59 |
發布緊急采購，3分鐘左右您將得到回復。