- 您現在的位置：買賣IC網 > PDF目錄9642 > ISL4245EIR (Intersil)IC LINE TRANSCVR CMOS 3-DRVR PDF資料下載
參數資料
| 型號： | ISL4245EIR |
| 廠商： | Intersil |
| 文件頁數： | 4/17頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC LINE TRANSCVR CMOS 3-DRVR |
| 標準包裝： | 60 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 3/5 |
| 規程： | RS232 |
| 電源電壓： | 2.7 V ~ 5.5 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-VFQFN 裸露焊盤 |
| 供應商設備封裝： | 32-QFN 裸露焊盤（5x5） |
| 包裝： | 管件 |
| 其它名稱： | Q1969098 |
第1頁第2頁第3頁當前第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁
12
FN8038.5
May 13, 2010
Hybrid Automatic Power-down Options
For devices which communicate only through a detachable
cable, connecting INVALID to FORCEOFF (with
FORCEON = 0) may be a desirable configuration. While the
cable is attached INVALID and FORCEOFF remain high, so the
enhanced automatic power-down logic powers down the RS-
232 device whenever there is 30 seconds of inactivity on the
receiver and transmitter inputs. Detaching the cable allows the
receiver inputs to drop to an invalid level (GND), so INVALID
switches low and forces the RS-232 device to power down. The
ISL4238E, ISL4244E, ISL4245 remains powered down until the
cable is reconnected (INVALID = FORCEOFF = 1) and a
transition occurs on a receiver or transmitter input (see Figure
7). For immediate power up when the cable is reattached,
connect FORCEON to FORCEOFF through a network similar
to that shown in Figure 5.
Capacitor Selection
The ISL4238E charge pumps require 0.1
μF, or greater,
capacitors for 3.3V (5% tolerance) operation. For other
supply voltages refer to Table 3 for capacitor values. Do not
use values smaller than those listed in Table 3.
The ISL4244E/45E charge pumps require 0.1F capacitors
for proper operation. Increasing the capacitor values (by a
factor of 2) reduces ripple on the transmitter outputs and
slightly reduces power consumption. C2, C3, and C4 can be
increased without increasing C1’s value, however, do not
increase C1 without also increasing C2, C3, and C4 to
maintain the proper ratios (C1 to the other capacitors).
When using minimum required capacitor values, make sure
that capacitor values do not degrade excessively with
temperature. If in doubt, use capacitors with a larger nominal
value. The capacitor’s equivalent series resistance (ESR)
usually rises at low temperatures and it influences the
amount of ripple on V+ and V-.
Power Supply Decoupling
In most circumstances a 0.1F bypass capacitor is
adequate. In applications that are particularly sensitive to
power supply noise, decouple VCC to ground with a
capacitor of the same value as the charge-pump capacitor C1.
Connect the bypass capacitor as close as possible to the IC.
Transmitter Outputs when Exiting
Power-down
Figure 10 shows the response of two transmitter outputs
when exiting power-down mode. As they activate, the two
transmitter outputs properly go to opposite RS-232 levels,
with no glitching, ringing, nor undesirable transients. Each
transmitter is loaded with 3k
Ω in parallel with 2500pF. Note
that the transmitters enable only when the magnitude of the
supplies exceed approximately 3V.
Operation Down to 2.7V
ISL4238E, ISL4244E, ISL4245 transmitter outputs meet
RS-562 levels (±3.7V), at the full data rate, with VCC as low
as 2.7V. RS-562 levels typically ensure interoperability with
RS-232 devices.
TABLE 3. REQUIRED CAPACITOR VALUES (ISL4238E)
VCC (V)
C1 (F)
C2, C3, C4 (F)
3.0 to 3.6 (3.3V ±10%)
0.22
3.15 to 3.6 (3.3V ±5%)
0.1
4.5 to 5.5
0.047
0.33
3.0 to 5.5
0.22
1
RECEIVER
INPUTS
TRANSMITTER
OUTPUTS
INVALID
OUTPUT
V+
VCC
0
V-
tINVL
tINVH
FIGURE 9. ENHANCED AUTOMATIC POWER-DOWN AND INVALID TIMING DIAGRAMS
OUTPUT
TRANSMITTER
INPUTS
tWU
tAUTOPWDN
tWU
INVALID
REGION
}
ISL4238E, ISL4244E, ISL4245E
相關PDF資料 |
PDF描述 |
|---|---|
| VI-2VP-MX-F1 | CONVERTER MOD DC/DC 13.8V 75W |
| D38999/26MD19JN | CONN PLUG 19POS STRAIGHT W/SCKT |
| VI-2VN-MX-F4 | CONVERTER MOD DC/DC 18.5V 75W |
| MS27505E17F55S | CONN RCPT 55POS BOX MNT W/SCKT |
| VI-2VN-MX-F3 | CONVERTER MOD DC/DC 18.5V 75W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL4245EIR-T | 功能描述:IC 3DRVR/5RCVR RS232 3V 32-QFN RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:25 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:4.5 V ~ 5.5 V 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 供應商設備封裝:16-PDIP 包裝:管件 |
| ISL4245EIRZ | 功能描述:RS-232接口集成電路 RS232 3V 3D/5R 15KV 1MBPS E-DWN 32QFN IN RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| ISL4245EIRZ-T | 功能描述:IC XMITTER/RCVR ESD RS232 32-QFN RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 類型:發射器 驅動器/接收器數:4/0 規程:RS422，RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| ISL4260E | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:QFN Packaged, ±15kV ESD Protected, +3V to +5.5V, 150nA, 250kbps, RS-232 Transmitters/Receivers with Separate Logic Supply |
| ISL4260EIR | 功能描述:IC 3DRVR/2RCVR RS232 3V 32-QFN RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:25 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:4.5 V ~ 5.5 V 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 供應商設備封裝:16-PDIP 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。