- 您現在的位置：買賣IC網 > PDF目錄9597 > ISL43485IB (Intersil)IC TXRX 1TX/1RX 3V RS-485 8-SOIC PDF資料下載
參數資料
| 型號： | ISL43485IB |
| 廠商： | Intersil |
| 文件頁數： | 7/11頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TXRX 1TX/1RX 3V RS-485 8-SOIC |
| 標準包裝： | 98 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 1/1 |
| 規程： | RS422，RS485 |
| 電源電壓： | 3 V ~ 3.6 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SOICN |
| 包裝： | 管件 |
5
FN6071.1
March 15, 2005
Time to Shutdown
tSHDN
(Note 7)
Full
80
190
300
ns
Receiver Enable from Shutdown to
Output High
tZH(SHDN) RL = 1k, CL = 15pF, SW = GND (Figure 5),
(Notes 7, 9)
Full
-
240
400
ns
Receiver Enable from Shutdown to
Output Low
tZL(SHDN) RL = 1k, CL = 15pF, SW = VCC (Figure 5),
(Notes 7, 9)
Full
-
240
400
ns
NOTES:
2. All currents into device pins are positive; all currents out of device pins are negative. All voltages are referenced to device ground unless
otherwise specified.
3. Supply current specification is valid for loaded drivers when DE = 0V.
4. Applies to peak current. See “Typical Performance Curves” for more information.
5. When testing this parameter, keep RE = 0 to prevent the device from entering SHDN.
6. When testing this parameter, the RE signal high time must be short enough (typically <100ns) to prevent the device from entering SHDN.
7. The ISL43485 is put into shutdown by bringing RE high and DE low. If the inputs are in this state for less than 80ns, the parts are guaranteed
not to enter shutdown. If the inputs are in this state for at least 300ns, the parts are guaranteed to have entered shutdown. See “Low-Power
Shutdown Mode” section.
8. Keep RE = VCC, and set the DE signal low time >300ns to ensure that the device enters SHDN.
9. Set the RE signal high time >300ns to ensure that the device enters SHDN.
Test Circuits and Waveforms
FIGURE 1A. VOD AND VOC
FIGURE 1B. VOD WITH COMMON MODE LOAD
FIGURE 1. DC DRIVER TEST CIRCUITS
Electrical Specifications
Test Conditions: VCC = 3V to 3.6V; Unless Otherwise Specified. Typicals are at VCC = 3.3V, TA = 25°C,
Note 2 (Continued)
PARAMETER
SYMBOL
TEST CONDITIONS
TEMP
(°C)
MIN
TYP
MAX
UNITS
D
DE
DI
VCC
VOD
VOC
RL/2
Z
Y
D
DE
DI
VCC
VOD
375
375
Z
Y
RL = 60
VCM
-7V TO +12V
ISL43485
相關PDF資料 |
PDF描述 |
|---|---|
| VE-B2X-MY-S | CONVERTER MOD DC/DC 5.2V 50W |
| VE-B2V-MY-S | CONVERTER MOD DC/DC 5.8V 50W |
| MS3126E22-41S | CONN PLUG 41POS STRAIGHT W/SCKT |
| CY28317PVXC-2T | IC CLK FTG VIA PL/E133T 48SSOP |
| D38999/24WG11SC | CONN RCPT 11POS JAM NUT W/SCKT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL43485IB-T | 功能描述:IC TXRX 1TX/1RX 3V RS-485 8-SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:25 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:4.5 V ~ 5.5 V 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 供應商設備封裝:16-PDIP 包裝:管件 |
| ISL43485IBZ | 功能描述:RS-422/RS-485 接口 IC HI SPD 8LD -40+85 3V RS-485 TRANS 1T RoHS:否 制造商:Maxim Integrated 數據速率:1136 Kbps 工作電源電壓:3 V to 5.5 V 電源電流:5.9 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-28 封裝:Tube |
| ISL43485IBZ | 制造商:Intersil Corporation 功能描述:IC TRANSCEIVER HALF DUP |
| ISL43485IBZ-T | 功能描述:IC TXRX 1TX/1RX 3V RS-485 8-SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 類型:發射器 驅動器/接收器數:4/0 規程:RS422，RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR) |
| ISL43640 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Low-Voltage, Single Supply, 4 to 1 Multiplexer, High Performance Analog Switch |
發布緊急采購，3分鐘左右您將得到回復。