12 FN6816.3 June 28, 2010 mode, the computer or USB hub transceiver and the MP3 player or cellphone USB transceiver #2 are connected a" />
參數資料
型號: ISL54214EVAL1Z
廠商: Intersil
文件頁數: 4/22頁
文件大?。?/td> 0K
描述: EVALUATION BOARD FOR ISL54214
標準包裝: 1
主要目的: 接口,3:1 多路復用器
嵌入式:
已用 IC / 零件: ISL54214
主要屬性: 2 x SP3T 模擬開關
次要屬性: 2.7 V ~ 4.6 V 電源
已供物品:
ISL54214
12
FN6816.3
June 28, 2010
mode, the computer or USB hub transceiver and the MP3
player or cellphone USB transceiver #2 are connected
and digital data will be able to be transmit back and
forth.
Audio MUTE Mode
If the C1 pin = Logic “1” and C0 pin = Logic “0”, the part
will be in the Audio Mute mode provided that the last
state was the Audio state. In the Audio Mute mode, the
2D- and 2D+ USB switches, the L and R audio switches
and the 1D- and 1D+ USB switches will be OFF (high
impedance).
The 1kΩ COM shunt resistors will be connected (ON). The
1kΩ shunts provide 77dB of off-isolation when driving
10kΩ to 20kΩ amplifier inputs.
The 1kΩ COM shunt resistors are active (ON) only when
in the Audio Mute mode.
Logic Control Timing Between C1 and C0
The ISL54214 has a unique logic control architecture.
The part has five different logic states but only two
external logic control pins, C1 and C0. Refer to the “State
The following state transitions require both C1 and C0
logic control bits to change their logic levels in unison:
All OFF(C1 = 0, C0 = 0) -----> Audio (C1 = 1, C0 = 1)
Audio (C1 = 1, C0 = 1) -----> All OFF (C1 = 0, C0 = 0)
Audio Mute (C1 = 1, C0 = 0) -----> USB1 (C1 = 0, C0 = 1)
The delay time between these bits must be < 100ns to
ensure that you directly move between these states
without momentarily transitioning to one of the other
states.
For example, if you are going from the “All OFF” state to
the “Audio” state and C0 does not go high until 100nS
after C1 went high you will momentarily transition to the
“USB2” state. Any signals connected at the USB2 signal
lines will momentarily get passed through to the COM
outputs.
Delay time between C1 and C0 must be < 100ns and
should be controlled by logic control drivers with well
behaved monotonic transitions from High to Low and Low
to High and with typical logic family rise and fall times of
1ns to 6ns.
POWER
The power supply connected at VDD (pin 11) provides
power to the ISL54214 part. Its voltage should be kept in
the range of 2.7V to 4.6V. In a typical application, VDD
will be in the range of 2.7V to 4.3V and will be connected
to the battery or LDO of the MP3 player or cellphone.
A 0.01F or 0.1F decoupling capacitor should be
connected from the VDD pin to ground to filter out any
power supply noise from entering the part. The capacitor
should be located as close to the VDD pin as possible.
Typical Performance Curves T
A = +25°C, Unless Otherwise Specified.
FIGURE 8. AUDIO ON-RESISTANCE vs SUPPLY
VOLTAGE vs SWITCH VOLTAGE
FIGURE 9. AUDIO ON-RESISTANCE vs SUPPLY
VOLTAGE vs SWITCH VOLTAGE
2.45
2.50
2.55
2.60
2.65
2.70
2.75
2.80
2.85
2.90
2.95
-1.5
-1.0
-0.5
0
0.5
1.0
1.5
r ON
(
Ω
)
VCOM (V)
ICOM = 60mA
VDD = 3.6V
VDD = 2.7V
VDD = 4.6V
2.48
2.50
2.52
2.54
2.56
2.58
2.60
-1.5
-1.0
-0.5
0
0.5
1.0
1.5
r ON
(
Ω
)
VCOM (V)
ICOM = 60mA
VDD = 3.0V
VDD = 3.3V
VDD = 4.0V
VDD = 3.6V
VDD = 4.6V
ISL54214
相關PDF資料
PDF描述
2-1906051-3 CA 2MM OFNR 62.5/125,LC SEC RED
VI-B4K-EY-S CONVERTER MOD DC/DC 40V 50W
VI-B4J-EY-S CONVERTER MOD DC/DC 36V 50W
VI-B43-EY-S CONVERTER MOD DC/DC 24V 50W
VI-B41-EY-S CONVERTER MOD DC/DC 12V 50W
相關代理商/技術參數
參數描述
ISL54214IRTZ 功能描述:IC USB SWITCH DUAL SP3T 12TQFN RoHS:是 類別:集成電路 (IC) >> 接口 - 模擬開關,多路復用器,多路分解器 系列:- 其它有關文件:STG4159 View All Specifications 標準包裝:5,000 系列:- 功能:開關 電路:1 x SPDT 導通狀態電阻:300 毫歐 電壓電源:雙電源 電壓 - 電源,單路/雙路(±):±1.65 V ~ 4.8 V 電流 - 電源:50nA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:7-WFBGA,F(xiàn)CBGA 供應商設備封裝:7-覆晶 包裝:帶卷 (TR)
ISL54214IRTZ-T 功能描述:IC USB SWITCH DUAL SP3T 12TQFN RoHS:是 類別:集成電路 (IC) >> 接口 - 模擬開關,多路復用器,多路分解器 系列:- 其它有關文件:STG4159 View All Specifications 標準包裝:5,000 系列:- 功能:開關 電路:1 x SPDT 導通狀態電阻:300 毫歐 電壓電源:雙電源 電壓 - 電源,單路/雙路(±):±1.65 V ~ 4.8 V 電流 - 電源:50nA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:7-WFBGA,F(xiàn)CBGA 供應商設備封裝:7-覆晶 包裝:帶卷 (TR)
ISL54214IRUZ-T 功能描述:IC USB SWITCH DUAL SP3T 12UTQFN RoHS:是 類別:集成電路 (IC) >> 接口 - 模擬開關,多路復用器,多路分解器 系列:- 其它有關文件:STG4159 View All Specifications 標準包裝:5,000 系列:- 功能:開關 電路:1 x SPDT 導通狀態電阻:300 毫歐 電壓電源:雙電源 電壓 - 電源,單路/雙路(±):±1.65 V ~ 4.8 V 電流 - 電源:50nA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:7-WFBGA,F(xiàn)CBGA 供應商設備封裝:7-覆晶 包裝:帶卷 (TR)
ISL54215 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:MP3/USB 2.0 High Speed Switch with Negative Signal Handling and Low Power Shutdown
ISL54215IRUZ-T 功能描述:IC USB SWITCH DUAL SPDT 10UTQFN RoHS:是 類別:集成電路 (IC) >> 接口 - 模擬開關,多路復用器,多路分解器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:36 系列:- 功能:多路復用器 電路:2 x 4:1 導通狀態電阻:75 歐姆 電壓電源:單/雙電源 電壓 - 電源,單路/雙路(±):2 V ~ 12 V,±2 V ~ 6 V 電流 - 電源:- 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:20-SOIC(0.295",7.50mm 寬) 供應商設備封裝:20-SOIC W 包裝:管件