5
November 25, 2008
COM ON-Capacitance,
CCOMx(ON)
f = 1MHz, VDD = 3.0V, IN = 3.0V, CTRL = 0V or 3V, VD- or
VD+ = VCOMx = 0V (Figure 5) 25
-
7
-
pF
POWER SUPPLY CHARACTERISTICS
Power Supply Range, VDD
Full
2.5
5.0
V
Positive Supply Current, IDD
VDD = 3.6V, IN = 0V or 3.6V, CTRL = 3.6V
25
-
7
13
A
Full
-
15
A
Positive Supply Current, IDD
(Low Power State)
VDD = 3.6V, IN = 0V, CTRL = 0V or float
25
-
1
10
nA
Full
-
150
nA
Power OFF-Current, IDx ICOMx VDD = 0V, VDx = VCOMx = 5.25V, IN = CTRL = Float
25
-
7
-
A
DIGITAL INPUT CHARACTERISTICS
Voltage Low, VINL, VCTRLL
VDD = 2.7V to 3.6V
Full
-
0.5
V
Voltage High, VINH, VCTRLH
VDD = 2.7V to 3.6V
Full
1.4
-
V
Input Current, IINL, ICTRLL
VDD = 3.6V, IN = 0V, CTRL = 0V
Full
-50
20
50
nA
Input Current, IINH
VDD = 3.6V, IN = 3.6, CTRL = 0V
Full
-2
0.9
2
A
Input Current, ICTRLH
VDD = 3.6V, IN = 0V, CTRL = 3.6V
Full
-2
0.9
2
A
CTRL Pull-Down Resistor,
RCTRL
VDD = 3.6V, IN = 0V, CTRL = 3.6V; measure current through the
internal pull-down resistor and calculate resistance value.
Full
-
4
-
M
Ω
IN Pull-Down Resistor, RIN
VDD = 3.6V, IN = 3.6V, CTRL = 3.6V; measure current through
the internal pull-down resistor and calculate resistance value.
Full
-
4
-
M
Ω
NOTES:
6. Vlogic = Input voltage to perform proper function.
7. The algebraic convention, whereby the most negative value is a minimum and the most positive a maximum, is used in this data sheet.
8. Parameters with MIN and/or MAX limits are 100% tested at +25°C, unless otherwise specified. Temperature limits established by characterization
and are not production tested.
9. Flatness is defined as the difference between maximum and minimum value of ON-resistance over the specified analog signal range.
10. Limits established by characterization and are not production tested.
11. rON matching between channels is calculated by subtracting the channel with the highest max rON value from the channel with lowest max rON
value, between L and R or between D+ and D-.
Electrical Specifications - 2.7V to 3.6V Supply
Test Conditions: VDD = +3.0V, GND = 0V, VINH = VCTRLH = 1.4V, VINL = VCTRLL =
0.5V, (Note 6), Unless Otherwise Specified. (Continued)
PARAMETER
TEST CONDITIONS
TEMP
(°C)
MIN
(Notes 7, 8)
TYP
MAX
(Notes 7, 8) UNITS
ISL54215