- 您現在的位置：買賣IC網 > PDF目錄10585 > ISL98001CQZ-140 (Intersil)IC TRPL VIDEO DIGITIZER 128-MQFP PDF資料下載
參數資料
| 型號： | ISL98001CQZ-140 |
| 廠商： | Intersil |
| 文件頁數： | 20/31頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TRPL VIDEO DIGITIZER 128-MQFP |
| 標準包裝： | 66 |
| 類型： | 視頻數字轉換器 |
| 應用： | 數字電視，顯示器，數字 KVM，圖形處理 |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 128-BFQFP |
| 供應商設備封裝： | 128-MQFP（14x20） |
| 包裝： | 托盤 |
| 產品目錄頁面： | 1247 (CN2011-ZH PDF) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁當前第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁
27
FN6148.5
September 21, 2010
To allow input monitoring and mode detection during
power-down, the following blocks remain active:
Serial interface (including the crystal oscillator) to enable
register read/write activity
Activity and polarity detect functions (registers 0x01 and
0x02)
The HSYNCOUT and VSYNCOUT pins (for mode
detection)
EMI Considerations
There are two possible sources of EMI on the ISL98001:
Crystal oscillator. The EMI from the crystal oscillator is
negligible. This is due to an amplitude-regulated, low voltage
sine wave oscillator circuit, instead of the typical high-gain
square wave inverter-type oscillator, so there are no harmonics.
Note: The crystal oscillator is not a significant source of EMI.
Digital output switching. This is the largest potential source of
EMI. However, the EMI is determined by the PCB layout and
the loading on the databus. The way to control this is to put
series resistors on the output of all the digital pins (as our demo
board and reference circuits show). These resistors should be
as large as possible, while still meeting the setup and hold
timing requirements of the scaler. We recommend starting with
22
Ω. If the databus is heavily loaded (long traces, many other
part on the same bus), this value may need to be reduced. If
the databus is lightly loaded, it may be increased.
Intersil’s recommendations to minimize EMI are:
Minimize the databus trace length
Minimize the databus capacitive loading.
If EMI is a problem in the final design, increase the value of the
digital output series resistors to reduce slew rates on the bus.
This can only be done as long as the scaler’s setup and hold
timing requirements continue to be met.
ISL98001 Serial Communication
Overview
The ISL98001 uses a 2-wire serial bus for communication
with its host. SCL is the Serial Clock line, driven by the host,
and SDA is the Serial Data line, which can be driven by all
devices on the bus. SDA is open drain to allow multiple
devices to share the same bus simultaneously.
Communication is accomplished in three steps:
1)
The Host selects the ISL98001 it wishes to communicate
with.
2)
The Host writes the initial ISL98001 Configuration
Register address it wishes to write to or read from.
3)
The Host writes to or reads from the ISL98001’s
Configuration Register. The ISL98001’s internal address
pointer auto increments, so to read registers 0x00 through
0x1B, for example, one would write 0x00 in step 2, then
repeat step three 28 times, with each read returning the
next register value.
The ISL98001 has a 7-bit address on the serial bus. The
upper 6-bits are permanently set to 100110, with the lower
bit determined by the state of pin 48 (SADDR). This allows
two ISL98001s to be independently controlled while sharing
the same bus.
The bus is nominally inactive, with SDA and SCL high.
Communication begins when the host issues a START
command by taking SDA low while SCL is high (Figure 9).
The ISL98001 continuously monitors the SDA and SCL lines
for the start condition and will not respond to any command
until this condition has been met. The host then transmits the
7-bit serial address plus a R/W bit, indicating if the next
transaction will be a Read (R/W = 1) or a Write (R/W = 0). If
the address transmitted matches that of any device on the
bus, that device must respond with an ACKNOWLEDGE
(Figure 10).
Once the serial address has been transmitted and
acknowledged, one or more bytes of information can be
written to or read from the slave. Communication with the
selected device in the selected direction (read or write) is
ended by a STOP command, where SDA rises while SCL is
high (Figure 9), or a second START command, which is
commonly used to reverse data direction without
relinquishing the bus.
Data on the serial bus must be valid for the entire time SCL
is high (Figure 11). To achieve this, data being written to the
ISL98001 is latched on a delayed version of the rising edge
of SCL. SCL is delayed and deglitched inside the ISL98001
for three crystal clock periods (120ns for a 25MHz crystal) to
eliminate spurious clock pulses that could disrupt serial
communication.
When the contents of the ISL98001 are being read, the SDA
line is updated after the falling edge of SCL, delayed and
deglitched in the same manner.
Configuration Register Write
Figure 12 shows two views of the steps necessary to write
one or more words to the Configuration Register.
Configuration Register Read
Figure 13 shows two views of the steps necessary to read
one or more words from the Configuration Register.
ISL98001
相關PDF資料 |
PDF描述 |
|---|---|
| ISL59604IRZ-T7 | IC VIDEO EQUALIZER 20-QFN |
| VE-B5J-IV-F2 | CONVERTER MOD DC/DC 36V 150W |
| LTC2453CDDB#TRMPBF | IC ADC 16BIT DELTA SIG 8-DFN |
| TW8806EP-PB2-GRS | IC LCD DISPLAY PROCESSOR 128PQFP |
| VE-B5J-IV-F1 | CONVERTER MOD DC/DC 36V 150W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISL98001CQZ-170 | 功能描述:IC TRPL VIDEO DIGITIZER 128-MQFP RoHS:是 類別:集成電路 (IC) >> 線性 - 視頻處理 系列:- 產品變化通告:Product Discontinuation 07/Mar/2011 標準包裝:3,000 系列:OMNITUNE™ 類型:調諧器 應用:移動電話，手機，視頻顯示器 安裝類型:表面貼裝 封裝/外殼:65-WFBGA 供應商設備封裝:PG-WFSGA-65 包裝:帶卷 (TR) 其它名稱:SP000365064 |
| ISL98001CQZ-210 | 功能描述:IC TRPL VIDEO DIGITIZER 128-MQFP RoHS:是 類別:集成電路 (IC) >> 線性 - 視頻處理 系列:- 產品變化通告:Product Discontinuation 07/Mar/2011 標準包裝:3,000 系列:OMNITUNE™ 類型:調諧器 應用:移動電話，手機，視頻顯示器 安裝類型:表面貼裝 封裝/外殼:65-WFBGA 供應商設備封裝:PG-WFSGA-65 包裝:帶卷 (TR) 其它名稱:SP000365064 |
| ISL98001CQZ-240 | 功能描述:IC TRPL VIDEO DIGITIZER 128-MQFP RoHS:是 類別:集成電路 (IC) >> 線性 - 視頻處理 系列:- 產品變化通告:Product Discontinuation 07/Mar/2011 標準包裝:3,000 系列:OMNITUNE™ 類型:調諧器 應用:移動電話，手機，視頻顯示器 安裝類型:表面貼裝 封裝/外殼:65-WFBGA 供應商設備封裝:PG-WFSGA-65 包裝:帶卷 (TR) 其它名稱:SP000365064 |
| ISL98001CQZ-275 | 功能描述:IC TRPL VIDEO DIGITIZER 128-MQFP RoHS:是 類別:集成電路 (IC) >> 線性 - 視頻處理 系列:- 產品變化通告:Product Discontinuation 07/Mar/2011 標準包裝:3,000 系列:OMNITUNE™ 類型:調諧器 應用:移動電話，手機，視頻顯示器 安裝類型:表面貼裝 封裝/外殼:65-WFBGA 供應商設備封裝:PG-WFSGA-65 包裝:帶卷 (TR) 其它名稱:SP000365064 |
| ISL98001CQZ-EVALZ | 功能描述:EVALUATION BOARD ISL98001CQZ RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:- 標準包裝:1 系列:PCI Express® (PCIe) 主要目的:接口，收發器，PCI Express 嵌入式:- 已用 IC / 零件:DS80PCI800 主要屬性:- 次要屬性:- 已供物品:板 |
發布緊急采購，3分鐘左右您將得到回復。