- 您現在的位置：買賣IC網 > PDF目錄353894 > JANS2N3499L (MICROSEMI CORP) 1024 x 18 synchronous FIFO memory 68-PLCC 0 to 70 PDF資料下載
參數資料
| 型號： | JANS2N3499L |
| 廠商： | MICROSEMI CORP |
| 元件分類： | 功率晶體管 |
| 英文描述： | 1024 x 18 synchronous FIFO memory 68-PLCC 0 to 70 |
| 中文描述： | 500 mA, 100 V, NPN, Si, SMALL SIGNAL TRANSISTOR, TO-5 |
| 文件頁數： | 4/20頁 |
| 文件大?。?/td> | 128K |
| 代理商： | JANS2N3499L |
MIL-PRF-19500/560E
12
* 4.4.3.1 Group C inspection, table VII of MIL-PRF-19500.
Subgroup
Method
Condition
C2
2036
Test condition E.
C5
3131
See 4.5.3.
C6
1037
For solder die attach: VCB ≥ 10 V dc, TA = Room ambient as defined in the
general requirements of MIL-STD-750. 6,000 cycles.
*
C6
1027
For eutectic die attach: VCB ≥ 10 V dc, adjust PT to achieve TJ = + 175°C min.
* 4.4.4 Group E inspection, Group E inspection shall be conducted in accordance with the conditions specified for
subgroup testing in table IX of MIL-PRF-19500, and herein. Electrical measurements (end-points) shall be in
accordance with group A, subgroup 2 herein. Group E inspection shall be performed for qualification or re-
qualification only. In case qualification was awarded to a prior revision of the spec sheet that did not request the
performance of table II tests, the tests specified in table II herein must be performed to maintain qualification.
4.5 Method of inspection. Methods of inspection shall be as specified in the appropriate tables and as follows.
4.5.1 Pulse measurements. Conditions for pulse measurement shall be as specified in section 4 of MIL-STD-750.
4.5.2 Input capacitance. This test shall be conducted in accordance with method 3240 of MIL-STD-750, except
the output capacitor shall be omitted.
4.5.3 Thermal resistance (to be performed for qualification inspection only). The thermal resistance
measurements shall be conducted in accordance with method 3131 of MIL-STD-750. The following details shall
apply:
a.
Collector current magnitude during power application shall be 0.15 A dc.
b.
Collector to emitter voltage magnitude shall be 20 V dc.
c.
Reference temperature measuring point shall be the case.
d.
Reference point temperature shall be + 25
°C ≤ T
R ≤ +35° C and recorded before the test is started.
e.
Mounting arrangement shall be with heat sink to case.
f.
Maximum limit shall be R
θJC = 17.5° C/W for TO-39 devices and RθJC = 1.7.5° C/W for U3 devices.
相關PDF資料 |
PDF描述 |
|---|---|
| JANS2N3700S | Quadruple 2-Input Exclusive-OR Gates 14-SSOP -40 to 85 |
| JANTX1N2807B | Quadruple 2-Input Positive-NOR Gates 14-SOIC -40 to 85 |
| JANTXV1N1184 | Quad Wide-Bandwidth High-Output-Drive Op Amp w/Shutdown 16-SOIC -40 to 125 |
| JANTXV1N1184R | Quad Wide-Bandwidth High-Output-Drive Op Amp w/Shutdown 16-PDIP -40 to 125 |
| JANTXV1N1186 | Quad Wide-Bandwidth High-Output-Drive Op Amp w/Shutdown 16-PDIP -40 to 125 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| JANS2N3500 | 制造商:Microsemi Corporation 功能描述:Trans GP BJT NPN 150V 0.3A 3-Pin TO-39 制造商:Microsemi Corporation 功能描述:NPN TRANSISTOR - Waffle Pack |
| JANS2N3500L | 制造商:Microsemi Corporation 功能描述:Trans GP BJT NPN 150V 0.3A 3-Pin TO-5 制造商:Microsemi Corporation 功能描述:NPN TRANSISTOR - Waffle Pack |
| JANS2N3501 | 制造商:Microsemi Corporation 功能描述:Trans GP BJT NPN 150V 0.3A 3-Pin TO-39 制造商:Microsemi Corporation 功能描述:NPN TRANSISTOR - Bulk 制造商:Microsemi Corporation 功能描述:NPN TRANSISTOR - Waffle Pack |
| JANS2N3501L | 制造商:Microsemi Corporation 功能描述:Trans GP BJT NPN 150V 0.3A 3-Pin TO-5 制造商:Microsemi Corporation 功能描述:NPN TRANSISTOR - Bulk 制造商:Microsemi Corporation 功能描述:NPN TRANSISTOR - Waffle Pack |
| JANS2N3501UB | 制造商:Microsemi Corporation 功能描述:Trans GP BJT NPN 150V 0.3A 3-Pin SMD |
發布緊急采購，3分鐘左右您將得到回復。