- 您現在的位置：買賣IC網 > PDF目錄353861 > JDLHCATN-44.736MHZ Voltage-Controlled Oscillator PDF資料下載
參數資料
| 型號： | JDLHCATN-44.736MHZ |
| 英文描述： | Voltage-Controlled Oscillator |
| 中文描述： | 壓控振蕩器 |
| 文件頁數： | 2/8頁 |
| 文件大?。?/td> | 113K |
| 代理商： | JDLHCATN-44.736MHZ |
J-Type Voltage Controlled Crystal Oscillator
Vectron International 166 Glover Avenue, Norwalk, CT 06856 Tel: 1-88-VECTRON-1 Fax: 1-888-FAX-VECTRON
1
Vc
VCXO Control Voltage.
2
Tri-State1
TTL logic low disables output
TTL logic high, or no connect, enables output
3
GND
Case and electrical ground.
4
Output
VCXO Output
5
CMOS/TTL
TTL logic low optimizes symmetry for CMOS
select1,2
TTL logic high, or NC, optimizes symmetry for TTL.
6VCC
Power Supply Voltage (5.0 V or 3.3V ±10%)
Pin Out Information for the CMOS output option
Electrical Performance @ 25°C for the CMOS output option
CMOS Output Option
1. Standard option. Tri-State can be connected to pin 5 and CMOS/TTL select would be on pin 2.
2. Output is HCMOS. For frequencies >12MHz, this option optimizes symmetry for either CMOS or TTL thresholds. Ground this pin for fre-
quencies < 12MHz.
Supply Voltage1, +5 volt option
4.5
5.0
5.5
Vdc
+3.3 volt option
3.0
3.3
3.6
Vdc
Supply Current
10mA + 0.25mA per MHz, typical
Center Frequency, see ordering information
FN
1.024
77.760
MHz
Operating Temperature, see ordering info
TOP
0/70, -40/85
°C
Absolute Pull Range over the operating tempera-
APR
±50 to ±100
ppm
ture range, aging and power supply Vc=0.5 to
4.5 at 5V supply or 0.3 to 3.0 V at 3.3V supply
see ordering information for options
Gain Transfer
K
Positive
(Frequency vs. Control Voltage)
Output Level High2
VOH
0.8*Vcc
-
V
Output Level Low2
VOL
-
0.1*Vcc
V
Output Rise/Fall Time2
tR/ tF
5ns
Duty Cycle3, see ordering info
SYM
45/55 or 40/60
%
Control Input Leakage
IL
1uA
Control Voltage Modulation Bandwidth
BW
-
10
-
kHz
RMS Jitter, Output=12.0-77.760 MHz
3ps
RMS Jitter, Output =12.0-77.760 MHz.
<0.5
ps
Band =12.0 KHz - 20 MHz
Control Range
0
VDD
Maximum Supply Voltage
7V
Storage Temperature
TS
-55
-
125
°C
Soldering Temp./Time
TLS
-
220/10
°C/s
2
Parameter
Symbol
Minimum
Typical
Maximum
Unit
1. Power supply bypass is required and a 0.1uF in parallel with a 0.01uF high frequency capacitor is recommended.
2. Figure 1 defines these parameters. Figure 2 illustrates the load used to test devices.
3. Duty cycle is defined as on-time versus period at 1.4 V for TTL, and 2.5 V for CMOS (5volt supply) and at 1.65 V for CMOS (3.3 volt operation)
Pin
Symbol
Function
相關PDF資料 |
PDF描述 |
|---|---|
| JDLHCATN-5.000MHZ | Voltage-Controlled Oscillator |
| JDLHCATN-50.000MHZ | Voltage-Controlled Oscillator |
| JDLHCATN-51.840MHZ | Voltage-Controlled Oscillator |
| JDLHCATN-52.000MHZ | Voltage-Controlled Oscillator |
| JDLHCATN-6.144MHZ | Voltage-Controlled Oscillator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| JDLI | 制造商:Thomas & Betts 功能描述:DIRECT BURIAL LAY IN GROUND CLAMP |
| JDLI-1 | 制造商:Thomas & Betts 功能描述:DIRECT BURIAL LAY IN GROUND CLAMP |
| JDLI-B1-10 | 制造商:Thomas & Betts 功能描述:3/8-1 GROUND CLAMP BRONZE LAYIN |
| JDLSLJTN-63.8976MHZ | 制造商:Vectron International 功能描述: |
| JDMGCMUX7776000MHZ | 制造商:Vectron International 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。