- 您現在的位置：買賣IC網 > PDF目錄11594 > KSZ8841-16MVL (Micrel Inc)IC MAC CTRLR 8/16BIT 128-LQFP PDF資料下載
參數資料
| 型號： | KSZ8841-16MVL |
| 廠商： | Micrel Inc |
| 文件頁數： | 22/105頁 |
| 文件大小： | 0K |
| 描述： | IC MAC CTRLR 8/16BIT 128-LQFP |
| 標準包裝： | 90 |
| 控制器類型： | 以太網控制器，MAC |
| 接口： | 總線 |
| 電源電壓： | 3.1 V ~ 3.5 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 128-LQFP |
| 供應商設備封裝： | 128-LQFP（14x14） |
| 包裝： | 托盤 |
| 產品目錄頁面： | 1081 (CN2011-ZH PDF) |
| 配用： | 576-1632-ND - BOARD EVALUATION KSZ8841-16MVL |
| 其它名稱： | 576-2113 KSZ8841-16MVL-ND |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁當前第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁
Micrel, Inc.
KSZ8841-16/32 MQL/MVL/MBL
October 2007
23
M9999-102207-1.6
Pin Number
Pin Name
Type
Pin Function
15
SRDYN
Opu
Synchronous Ready Not
Ready signal to interface with synchronous bus for both EISA-like and VLBus-like extend
accesses.
For VLBus-like mode, the falling edge of this signal indicates ready. This signal is
synchronous to the bus clock signal BCLK.
For burst mode (32-bit interface only), the KSZ8841M drives this pin low to signal wait
states.
16
INTRN
Opd
Interrupt
Active Low signal to host CPU to indicate an interrupt status bit is set, this pin need an
external 4.7K pull-up resistor
17
LDEVN
Opd
Local Device Not
Active Low output signal, asserted when AEN is Low and A15-A4 decode to the
KSZ8841M address programmed into the high byte of the base address register. LDEVN
is a combinational decode of the Address and AEN signal.
18
RDN
Ipd
Read Strobe Not
Asynchronous read strobe, active Low.
19
EECS
Opu
EEPROM Chip Select
This signal is used to select an external EEPROM device.
20
ARDY
Opd
Asynchronous Ready
ARDY may be used when interfacing asynchronous buses to extend bus access cycles. It
is asynchronous to the host CPU or bus clock. this pin need an external 4.7K pull-up
resistor.
21
CYCLEN
Ipd
Cycle Not
For VLBus-like mode cycle signal; this pin follows the addressing cycle to signal the
command cycle.
For burst mode (32-bit interface only), this pin stays High for read cycles and Low for write
cycles.
22
NC
Opd
No Connect
23
DGND
Gnd
Digital IO ground
24
VDDCO
P
1.2V digital core voltage output (internal 1.2V LDO power supply output), this 1.2V output
pin provides power to VDDC, VDDA and VDDAP pins. It is recommended this ball should
be connected to 3.3V power rail by a 100 ohm resistor for the internal LDO application.
Note: Internally generated power voltage. Do not connect an external power supply to this
pin. This pin is used for connecting external filter (Ferrite bead and capacitors).
25
VLBUSN
Ipd
VLBus-like Mode
Pull-down or float: Bus interface is configured for synchronous mode.
Pull-up: Bus interface is configured for 32-bit asynchronous mode or EISA-like burst
mode.
26
EEEN
Ipd
EEPROM Enable
EEPROM is enabled and connected when this pin is pull-up.
EEPROM is disabled when this pin is pull-down or no connect.
27
P1LED3
Opd
Port 1 LED indicator
See the description in pins 3, 4, and 5.
28
EEDO
Opd
EEPROM Data Out
This pin is connected to DI input of the serial EEPROM.
29
EESK
Opd
EEPROM Serial Clock
A 4
s (OBCR[1:0]=11 on-chip bus speed @ 25 MHz) or 800 ns (OBCR[1:0]=00 on-chip
bus speed @ 125 MHz) serial output clock cycle to load configuration data from the serial
EEPROM.
相關PDF資料 |
PDF描述 |
|---|---|
| PIC16F636T-I/ST | IC MCU FLASH 2KX14 14TSSOP |
| PIC12F683-E/MF | IC MCU FLASH 2KX14 8DFN |
| PIC12LCE518-04/P | IC MCU OTP 512X12 LV W/EE 8DIP |
| PIC16F1828-E/SS | IC MCU 8BIT 7KB FLASH 20SSOP |
| KSZ8842-32MQL | IC SWITCH 10/100 32BIT 128PQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| KSZ8841-16MVL TR | 功能描述:以太網 IC Single Ethernet Port + Generic (8, 16-bit) bus interface(Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8841-16MVL-EVAL | 功能描述:BOARD EVALUATION KSZ8841-16MVL RoHS:是 類別:編程器，開發系統 >> 過時/停產零件編號 系列:- 標準包裝:1 系列:- 類型:MCU 適用于相關產品:Freescale MC68HC908LJ/LK（80-QFP ZIF 插口） 所含物品:面板、纜線、軟件、數據表和用戶手冊 其它名稱:520-1035 |
| KSZ8841-16MVLI | 功能描述:以太網 IC Single Ethernet Port + Generic (8, 16-bit) bus interface(Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8841-16MVLI TR | 功能描述:以太網 IC Single Ethernet Port + Generic (8, 16-bit) bus interface(Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ8841-32MQL | 功能描述:以太網 IC Single Ethernet Port + Generic (32-bit) bus interface(Lead Free) RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。