- 您現在的位置：買賣IC網 > PDF目錄4597 > KSZ8999I (Micrel Inc)IC SWITCH 9-PORT 10/100 208PQFP PDF資料下載
參數資料
| 型號： | KSZ8999I |
| 廠商： | Micrel Inc |
| 文件頁數： | 8/52頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC SWITCH 9-PORT 10/100 208PQFP |
| 標準包裝： | 24 |
| 系列： | * |
| 類型： | * |
| 應用： | * |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 208-MQFP，208-PQFP |
| 供應商設備封裝： | 208-PQFP（28x28） |
| 包裝： | 管件 |
| 產品目錄頁面： | 1081 (CN2011-ZH PDF) |
| 配用： | 576-1644-ND - BOARD EVALUATION FOR KSZ8999 |
| 其它名稱： | 576-2128 KSZ8999I-ND |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁
KS8999
Micrel
KS8999
16
January 2005
Group
I/O Names
Active Status
Description(Note 1)
LED[9][1]
Programs port duplex (full / half) on port 7. This is only effective if auto-negotiation is
disabled or if this end has auto-negotiation enabled and the far end has auto-
negotiation disabled.
D = Full-duplex, F/U = Half-duplex (default)
LED[9][0]
Programs port duplex (full / half) on port 8. This is only effective if auto-negotiation is
disabled or if this end has auto-negotiation enabled and the far end has auto-
negotiation disabled.
D = Full-duplex, F/U = Half-duplex (default)
LED[6][3]
Programs back-off aggressiveness for half-duplex mode
D = Less aggressive back-off, F/U = More aggressive back-off (default)
LED[6][2]
Programs retries for frames that encounter collisions.
D = Drop frame after 16 collisions, F/U = Continue sending frame regardless of the
number of collisions (default)
LED[6][1:0]
Reserved – use float configuration
LED[7][3]
Programs flow control
D = No flow control, F/U = Flow control enabled (default)
LED[7][2]
Programs broadcast storm protection.
D = 5% broadcast frames allowed, F/U = Unlimited broadcast frames (default)
LED[7][1]
Programs buffer sharing feature.
D = Equal amount of buffers per port (113 buffers), F/U = Share buffers up to 512
buffers on a single port (default)
LED[7][0]
Reserved – use float configuration
LED[8][3]
Programs address aging.
D = Aging disabled, F/U = Enable 5 minute aging (default)
LED[8][2]
Programs frame length enforcement.
D = Max length for VLAN is 1522 bytes and without VLAN is 1518 bytes
F/U = Max length is 1536 bytes (default)
LED[8][1]
Reserved
LED[8][0]
Programs half-duplex back pressure.
D = No half-duplex back pressure, F/U = Half-duplex back pressure enabled (default)
MRXD[3]
Programs port 9 speed
D = 10Mbps, F/U = 100Mbps (default)
MRXD[2]
Programs port 9 duplex
D = Half-duplex, F/U = Full duplex (default)
MRXD[1]
Programs port 9 flow control
D = Flow control, F/U = No flow control (default)
MRXD[0]
D = reserved, F/U = normal operation (default)
CTRL
EN1P
H
Enable 802.1p for all ports – this enables QoS based on the priority field in the layer
2 header.
0 = 802.1p selected by port in EEPROM
1 = Use 802.1p priority field unless disabled in EEPROM
Note: This is also controlled by the EEPROM registers (registers 4-12 bit 4). The values
in the EEPROM supercede this pin. Also, if the priority selection is unaltered in the
EEPROM registers (register 3 bits 0-7) then values above 3 are considered high priorty
and less than 4 are low priority.
MIIS[1:0]
H
MII mode selection – allows the MII to run in the following modes
MIIS
Operating mode
10
0
Disable MII interface
0
1
Reverse MII
1
0
Forward MII
1
7 wire mode (SNI)
Note 1.
All unmanaged programming takes place at reset time only. For unmanaged programming: F = Float, D = Pull-down, U = Pull-up.
See
“Reference Circuits” section.
相關PDF資料 |
PDF描述 |
|---|---|
| KSZ8695PI | IC ARM9 W/MMU 5PORT 289-PBGA |
| KSZ8999 | IC SWITCH 10/100 9PORT 208PQFP |
| KSZ8997 | IC SWITCH 10/100 8PORT 128PQFP |
| KSZ8995FQI | IC SWITCH 10/100 5PORT 128-PQFP |
| AD9970BCPZ | IC PROCESSOR CCD SIGNAL 32LFCSP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| KSZ9021GN | 功能描述:以太網 IC Gigabit Ethernet Transceiver with GMII/MII, Lead Free RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ9021GN TR | 功能描述:以太網 IC Gigabit Ethernet Transceiver with GMII/MII RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ9021GN-EVAL | 功能描述:以太網開發工具 Gigabit Ethernet Transceiver with GMII/MII - Evaluation Board RoHS:否 制造商:Micrel 產品:Evaluation Boards 類型:Ethernet Transceivers 工具用于評估:KSZ8873RLL 接口類型:RMII 工作電源電壓: |
| KSZ9021GNI | 功能描述:以太網 IC Gigabit Ethernet Transceiver with GMII/MII, I-Temp RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| KSZ9021GQ | 功能描述:以太網 IC Gigabit Ethernet Transceiver with GMII/MII, Lead Free RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。