- 您現在的位置：買賣IC網 > PDF目錄69003 > L6208PD (STMICROELECTRONICS) STEPPER MOTOR CONTROLLER, 5.6 A, PDSO36 PDF資料下載
參數資料
| 型號： | L6208PD |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 運動控制電子 |
| 英文描述： | STEPPER MOTOR CONTROLLER, 5.6 A, PDSO36 |
| 封裝： | POWER, SO-36 |
| 文件頁數： | 2/27頁 |
| 文件大?。?/td> | 462K |
| 代理商： | L6208PD |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁
L6208
10/27
Figure 6. Charge Pump Circuit
LOGIC INPUTS
Pins CONTROL, HALF/FULL, CLOCK, RESET and CW/CCW are TTL/CMOS and uC compatible logic inputs.
The internal structure is shown in Fig. 7. Typical value for turn-on and turn-off thresholds are respectively
Vth(ON)= 1.8V and Vth(OFF)= 1.3V.
Pin EN (Enable) has identical input structure with the exception that the drain of the Overcurrent and thermal
protection MOSFET is also connected to this pin. Due to this connection some care needs to be taken in driving
this pin. The EN input may be driven in one of two configurations as shown in Fig. 8 or 9. If driven by an open
drain (collector) structure, a pull-up resistor REN and a capacitor CEN are connected as shown in Fig. 8. If the
driver is a standard Push-Pull structure the resistor REN and the capacitor CEN are connected as shown in Fig.
9. The resistor REN should be chosen in the range from 2.2K
to 180K. Recommended values for REN and
CEN are respectively 100K
and 5.6nF. More information on selecting the values is found in the Overcurrent
Protection section.
Figure 7. Logic Inputs Internal Structure
Figure 8. EN Pin Open Collector Driving
Figure 9. EN Pin Push-Pull Driving
D2
CBOOT
D1
RP
CP
VS
VSA
VCP
VBOOT
VSB
D01IN1328
5V
D01IN1329
ESD
PROTECTION
5V
OPEN
COLLECTOR
OUTPUT
REN
CEN
EN
D01IN1330
ESD
PROTECTION
5V
PUSH-PULL
OUTPUT
REN
CEN
EN
D01IN1331
ESD
PROTECTION
相關PDF資料 |
PDF描述 |
|---|---|
| L6219DS | STEPPER MOTOR CONTROLLER, 1 A, PDSO24 |
| L6219DS013TR | STEPPER MOTOR CONTROLLER, 1 A, PDSO24 |
| L6227Q | BRUSH DC MOTOR CONTROLLER, 2.8 A, QCC32 |
| L6228D | STEPPER MOTOR CONTROLLER, 2.8 A, PDSO24 |
| L6228N | STEPPER MOTOR CONTROLLER, 2.8 A, PDIP24 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L6208PD013TR | 功能描述:馬達/運動/點火控制器和驅動器 DMOS Stepper Motor RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
| L6208Q | 功能描述:馬達/運動/點火控制器和驅動器 DMOS Driver Bipolar 5.6A 100kHz 8 to 52V RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
| L6208QTR | 功能描述:馬達/運動/點火控制器和驅動器 DMOS Dual Full Bridge Driver 5.6A RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
| L620C | 制造商:Pass & Seymour/Legrand 功能描述:Connector, Turnlok 3 Wire Ground, IP20, 20A, 250V, Black Back, White Front Body 制造商:Pass & Seymour/Legrand 功能描述:CONNECTOR POWER ENTRY RECEPTACLE 20A 制造商:Pass & Seymour/Legrand 功能描述:CONNECTOR, POWER ENTRY, RECEPTACLE, 20A 制造商:Pass & Seymour/Legrand 功能描述:CONNECTOR, POWER ENTRY, RECEPTACLE, 20A; Connector Type:Power Entry; Series:Turnlok; Current Rating:20A; Connector Color:Black / White; Connector Body Material:Nylon (Polyamide); Voltage Rating VAC:125V; Connector Mounting:Cable 制造商:Hubbell Premise Wiring 功能描述:Conn Power PL 2Power/1Ground POS Solder ST Panel Mount 3 Terminal 1 Port 制造商:Hubbell Wiring Device-Kellems 功能描述:LKG CONN, 20A 250V, HUB PRO, L6-20R |
| L620FI | 制造商:Pass & Seymour/Legrand 功能描述:CONNECTOR POWER ENTRY PLUG 制造商:Pass & Seymour/Legrand 功能描述:CONNECTOR, POWER ENTRY, PLUG, 20A; Connector Type:Power Entry; Series:Turnlok; Current Rating:20A; Connector Color:Grey; Connector Body Material:PC (Polycarbonate); Voltage Rating VAC:125V; Connector Mounting:Flange; Gender:Plug |
發布緊急采購，3分鐘左右您將得到回復。