- 您現在的位置：買賣IC網 > PDF目錄69003 > L6562ADTR (STMICROELECTRONICS) 0.8 A POWER FACTOR CONTROLLER, PDSO8 PDF資料下載
參數資料
| 型號： | L6562ADTR |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.8 A POWER FACTOR CONTROLLER, PDSO8 |
| 封裝： | ROHS COMPLIANT, SOP-8 |
| 文件頁數： | 9/26頁 |
| 文件大?。?/td> | 557K |
| 代理商： | L6562ADTR |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
L6562A
Application information
17/26
7.5
Comparison between the L6562A and the L6562
The L6562A is not a direct drop-in replacement of the L6562, even if both have the same
pin-out. One function (Disable) has been relocated.
Table 2 compares the two devices, i.e. those parameters that may result in different values
of the external components. The parameters that have the most significant impact on the
design, i.e. that definitely require external component changes when converting an L6562-
based design to the L6562A, are highlighted in bold.
The lower value (-36%) for the clamp level of the current sense reference voltage allows the
use of a lower sense resistor for the same peak current, with a proportional reduction of the
associated power dissipation. Essentially, the advantage is the reduction of the power
dissipated in a single point (hotspot), which is a considerable benefit in applications where
heat removal is critical, e.g. in adapters enclosed in a sealed plastic case. The lower value
for the Dynamic OVP triggering current allows the use of a higher resistance value (+48%)
for the upper resistor of the divider sensing the output voltage of the PFC stage (keeping the
same overvoltage level) with no significant increase of noise sensitivity. This reduction goes
in favor of standby consumption in applications required to comply with energy saving
regulations.
Table 6. L6562A vs. L6562
Parameter
L6562
L6562A
IC turn-on & turn-off thresholds (typ.)
12/9.5 V
12.5/10 V
Turn-off threshold spread (max.)
±0.8 V
±0.5 V
IC consumption before start-up (max.)
70 uA
60 uA
Multiplier gain (typ.)
0.6
0.38
Current sense reference clamp (typ.)
1.7 V
1.08 V
Current sense propagation delay (delay-to-output) (typ.)
200 ns
175 ns
Dynamic OVP triggering current (typ.)
40 uA
27 uA
ZCD arm/trigger/clamp thresholds (typ.)
2.1/1.4/0.7 V
1.4/0.7/0 V
Enable threshold (typ.)
0.3 V (1)
1.
Function located on pin 5 (ZCD)
0.45 V (2)
2.
Function located on pin 1 (INV)
Gate-driver internal drop (max.)
2.6 V
2.2 V
Leading-edge blanking on current sense
No
Yes
Reference voltage accuracy ( overall)
2.4%
1.8%
相關PDF資料 |
PDF描述 |
|---|---|
| L6563STR | POWER FACTOR CONTROLLER, PDSO14 |
| L6563S | POWER FACTOR CONTROLLER, PDSO14 |
| L6564DTR | SWITCHING CONTROLLER, PDSO10 |
| L6564D | SWITCHING CONTROLLER, PDSO10 |
| L6585DE | POWER FACTOR CONTROLLER, PDSO20 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L6562ADTR☞原裝☜ | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:深創輝科技，全新原裝L6562ADTR☞原裝☜ |
| L6562AN | 功能描述:功率因數校正 IC Low 2.5mA 30uA Transition Mode PFC RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
| L6562AT | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Transition-mode PFC controller |
| L6562ATD | 功能描述:開關變換器、穩壓器與控制器 Transition-mode PFC controller RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
| L6562ATDTR | 功能描述:開關變換器、穩壓器與控制器 Transition-mode PFC controller RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。