- 您現在的位置：買賣IC網 > PDF目錄43900 > L6585D (STMICROELECTRONICS) 0.6 A POWER FACTOR AND FLUORESCENT LIGHT CONTROLLER, 250 kHz SWITCHING FREQ-MAX, PDSO20 PDF資料下載
參數資料
| 型號： | L6585D |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 穩壓器 |
| 英文描述： | 0.6 A POWER FACTOR AND FLUORESCENT LIGHT CONTROLLER, 250 kHz SWITCHING FREQ-MAX, PDSO20 |
| 封裝： | LEAD FREE, SOP-20 |
| 文件頁數： | 13/25頁 |
| 文件大?。?/td> | 1478K |
| 代理商： | L6585D |
Re–lamp
L6585D
20/25
Table 7.
Fault conditions
Fault
Condition
IC behavior
Action required
Lamp absence
(re-lamp comparator)
At turn-on: EOL-R
voltage higher than
4.63V
–The TCH charge doesn’t start (no
ignition)
– Drivers stopped
– IC low consumption (Vcc clamped)
Lamp replacement
(EOL-R below 4.63V)
Run mode: EOL-R
voltage higher than
4.63V
– All drivers stopped
– IC low consumption (Vcc clamped)
End of life
EOL-R voltage outside
the limits of window
comparator
–TCH cycle
(1) (reset if the fault
disappears)
– drivers stopped at the end of TCH
cycle
– IC low consumption (VCC clamped)
Re-lamp cycle (2)
Half-bridge current
sense
Ignition:
HBCS threshold
–TCH cycle
(1) with lamp voltage
control
– In case of HBCS at the end of the
TCH cycle, drivers stopped
– IC low consumption (Vcc clamped)
Re-lamp cycle (2)
Run mode:
HBCSL threshold
–TCH cycle
(1) with lamp voltage
control (frequency increase)
– In case of HBCS at the end of the
TCH cycle, drivers stopped
– IC low consumption (Vcc clamped)
Re-lamp cycle (2)
Run mode:
HBCSH threshold
– Drivers stopped
– IC low consumption (Vcc clamped)
Re-lamp cycle (2)
Shut-down
CTR voltage lower than
0.8V
– Drivers stopped
– IC low consumption (Vcc clamped)
When the CTR voltage
returns above 0.8V, the
IC driver restart with a
pre-heating sequence
Choke saturation
PFCS voltage higher
than 1.6V
– Drivers stopped
– IC low consumption (Vcc clamped)
Re-lamp cycle (2)(3)
Over-voltage of PFC
output
CTR voltage higher than
3.4V
– PFC driver stopped
When the CTR voltage
returns below
3.26V (Typ.), the PFC
driver restarts
PFC open loop
(feedback
disconnection)
CTR voltage higher than
3.4V AND INV voltage
lower than 1.2
– Drivers stopped
– IC low consumption (Vcc clamped)
Re-lamp cycle (2)(3)
1.
TCH cycle: charge of the TCH voltage up to 4.63V and discharge down to 1.50V following the RDCD time constant;
2.
Re-lamp cycle: the voltage at EOL-R pin must be first pulled above 4.63V and then released below it; this typically happens
in case of lamp replacement. After a re-lamp cycle, a new pre-heating sequence will be repeated.
3.
This fault actually is a "board" fault so a lamp replacement is not effective to restart the ballast
相關PDF資料 |
PDF描述 |
|---|---|
| L6585DTR | 0.6 A POWER FACTOR AND FLUORESCENT LIGHT CONTROLLER, 250 kHz SWITCHING FREQ-MAX, PDSO20 |
| L6590AN | 0.7 A SWITCHING REGULATOR, 74 kHz SWITCHING FREQ-MAX, PDIP8 |
| L6590D013TR | 0.7 A SWITCHING REGULATOR, 74 kHz SWITCHING FREQ-MAX, PDSO16 |
| L6590D | 0.7 A SWITCHING REGULATOR, 74 kHz SWITCHING FREQ-MAX, PDSO16 |
| L6591TR | SWITCHING CONTROLLER, PDSO16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| L6585D_07 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Combo IC for PFC and ballast control |
| L6585DE | 功能描述:功率因數校正 IC Combo IC for PFC Ballast control RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
| L6585DETR | 功能描述:功率因數校正 IC Combo IC for PFC and ballast control RoHS:否 制造商:Fairchild Semiconductor 開關頻率:300 KHz 最大功率耗散: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Reel |
| L6585DTR | 功能描述:DC/DC 開關控制器 Combo IC RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK |
| L6590 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:FULLY INTEGRATED POWER SUPPLY FIPS |
發布緊急采購，3分鐘左右您將得到回復。