參數資料
型號: L6727
廠商: STMICROELECTRONICS
元件分類: 穩壓器
英文描述: 1.5 A SWITCHING CONTROLLER, 350 kHz SWITCHING FREQ-MAX, PDSO8
封裝: LEAD FREE, SOP-8
文件頁數: 3/34頁
文件大小: 974K
代理商: L6727
L6727
Soft-start and disable
Doc ID 12933 Rev 4
11/34
6
Soft-start and disable
L6727 implements a soft-start to smoothly charge the output filter avoiding high in-rush
currents to be required from the input power supply. The device progressively increases the
internal reference from 0 V to 0.8 V in about 5.1 ms, in closed loop regulation, gradually
charging the output capacitors to the final regulation voltage.
In the event of an overcurrent triggering during soft start, the over current logic will override
the soft start sequence and will shut down both the high side and low side gates for the
internal soft start residual time (up to 2048 clock cycles) plus 2048 clock cycles, then it will
begin a new soft start.
The device begins soft start phase only when VCC power supply is above UVLO threshold
and overcurrent threshold setting phase has been completed.
6.1
Low-side-less start up (LSLess)
In order to manage start up over pre-biased output, L6727 performs a special sequence in
enabling LS driver to switch: during the soft-start phase, LS driver results disabled
(LS = OFF) until HS starts to switch. This avoids the dangerous negative spike on the output
voltage that can happen if starting over a pre-biased output.
If the output voltage is pre-biased to a voltage lower than the programmed one, neither HS
nor LS will turn on until the soft start ramp exceeds the output pre-bias voltage; then VOUT
will ramp up from there, without any drop or current return.
If the output voltage is pre-biased to a voltage higher than the programmed one, HS would
never start to switch. In this case, at the end of soft start time, LS is enabled and discharges
the output to the final regulation value.
This particular feature of the device masks the LS turn-on only from the control loop point of
view: protections by-pass LSLESS, turning ON the LS MOSFET in case of need.
Figure 4.
LSless startup (left) vs non-lsless startup (right)
相關PDF資料
PDF描述
L6728AHTR SWITCHING CONTROLLER, PDSO10
L6730DTR 20 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO20
L6730D 20 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO20
L6730CQTR 20 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, QCC24
L6730CTR 20 A SWITCHING CONTROLLER, 1000 kHz SWITCHING FREQ-MAX, PDSO20
相關代理商/技術參數
參數描述
L6727_10 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Single phase PWM controller
L6727TR 功能描述:開關變換器、穩壓器與控制器 Single PWM controler RoHS:否 制造商:Texas Instruments 輸出電壓:1.2 V to 10 V 輸出電流:300 mA 輸出功率: 輸入電壓:3 V to 17 V 開關頻率:1 MHz 工作溫度范圍: 安裝風格:SMD/SMT 封裝 / 箱體:WSON-8 封裝:Reel
L6728 功能描述:DC/DC 開關控制器 Sngl phase PWM controller RoHS:否 制造商:Texas Instruments 輸入電壓:6 V to 100 V 開關頻率: 輸出電壓:1.215 V to 80 V 輸出電流:3.5 A 輸出端數量:1 最大工作溫度:+ 125 C 安裝風格: 封裝 / 箱體:CPAK
L6728_0706 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Single phase PWM controller with Power Good
L6728A 功能描述:電壓模式 PWM 控制器 Hi-Freq. singl-phase PWM controller w/Po RoHS:否 制造商:Texas Instruments 輸出端數量:1 拓撲結構:Buck 輸出電壓:34 V 輸出電流: 開關頻率: 工作電源電壓:4.5 V to 5.5 V 電源電流:600 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:WSON-8 封裝:Reel