參數資料
型號: L9215A
英文描述: CAP CER 2200PF 3.15KVDC R3 RAD
中文描述: 短回路正弦波振鈴用戶接口
文件頁數: 12/50頁
文件大?。?/td> 1115K
代理商: L9215A
Data Sheet
September 2001
Short-Loop Sine Wave Ringing SLIC
L9215A/G
12
Agere Systems Inc.
State Definitions
Forward Active
I
Pin PT is positive with respect to PR.
I
V
BAT2
is applied to tip/ring drive amplifiers.
I
Loop closure and common-mode detect are active.
I
Ring trip detector is turned off to conserve power.
I
PPM input is off.
I
Overhead is set to nominal 6.0 V for undistorted
transmission of 3.14 dBm into 900
and may be
increased via OVH.
Reverse Active
I
Pin PR is positive with respect to PT.
I
V
BAT2
is applied to tip/ring drive amplifiers.
I
Loop closure and common-mode detect are active.
I
Ring trip detector is turned off to conserve power.
I
PPM input is off.
I
Overhead is set to nominal 6.0 V for undistorted
transmission of 3.14 dBm into 900
and may be
increased via OVH.
Forward Active with PPM
I
Pin PT is positive with respect to PR.
I
V
BAT2
is applied to tip/ring drive amplifiers.
I
Loop closure and common-mode detect are active.
I
Ring trip detector is turned off to conserve power.
I
PPM input is on.
I
Overhead is set to nominal 6.0 V for undistorted
transmission of 3.14 dBm into 900
and may be
increased via OVH to accommodate higher-voltage
meter pulse signals.
Reverse Active with PPM
I
Pin PR is positive with respect to PT.
I
V
BAT2
is applied to tip/ring drive amplifiers.
I
Loop closure and common-mode detect are active.
I
Ring trip detector is turned off to conserve power.
I
PPM input is on.
I
Overhead is set to nominal 6.0 V for undistorted
transmission of 3.14 dBm into 900
and may be
increased via OVH to accommodate higher-voltage
meter pulse signals.
Scan
I
Except for loop closure, all circuits (including ring trip
and common-mode detector) are powered down.
I
On-hook transmission is disabled.
I
Pin PT is positive with respect to PR and V
BAT1
is
applied to tip/ring.
I
The tip-to-ring on-hook differential voltage will be
typ-
ically
between –44 V and –51 V with a –70 V primary
battery.
On-Hook Transmission
Forward Battery
I
Pin PT is positive with respect to PR.
I
V
BAT1
is applied to tip/ring drive amplifiers.
I
Supervision circuits, loop closure, and common-
mode detect are active.
I
Ring trip detector is turned off to conserve power.
I
On-hook transmission is allowed.
I
The tip-to-ring on-hook differential voltage will be
between –41 V and –49 V with a –70 V primary bat-
tery.
I
PPM is off.
相關PDF資料
PDF描述
L9216A CAP CER 270PF 3.15KVDC R3 RAD
L9217A CAP CER 2700PF 3.15KVDC R3 RAD
L9218A CAP CER 330PF 3.15KVDC R3 RAD
L9219A CAP CER 390PF 3.15KVDC R3 RAD
L9310 Line Interface and Line Access Circuit Full-Feature SLIC,Ringing Relay,and Test Access Device
相關代理商/技術參數
參數描述
L9216A 制造商:AGERE 制造商全稱:AGERE 功能描述:Short-Loop Ringing SLIC with Ground Start
L9217A 制造商:AGERE 制造商全稱:AGERE 功能描述:Low-Cost Line Interface with Reverse Battery and PPM
L9218A 制造商:AGERE 制造商全稱:AGERE 功能描述:Low-Cost Line Interface
L9219A 制造商:AGERE 制造商全稱:AGERE 功能描述:Low-Cost Line Interface with Reverse Battery and Dual Current Limit
L9222 功能描述:功率驅動器IC Quad Inv Tran Switch RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube