- 您現在的位置：買賣IC網 > PDF目錄30713 > LA1137N AM, AUDIO SINGLE CHIP RECEIVER, PDIP20 PDF資料下載
參數資料
| 型號： | LA1137N |
| 元件分類： | 接收器 |
| 英文描述： | AM, AUDIO SINGLE CHIP RECEIVER, PDIP20 |
| 封裝： | SDIP-20 |
| 文件頁數： | 11/19頁 |
| 文件大?。?/td> | 720K |
| 代理商： | LA1137N |
(2) SD sensitivity adjustment method
The SD sensitivity is determined by the voltage level of the two inputs to the comparator. Because the absolute value is
determined by the resistor as described above, no matter which level, the sensitivity can be adjusted through both levels.
However, from the standpoint of the stability of the system as a whole and given the possibility that the S-meter output will
be used for other purposes, it is best to make adjustments by adjusting the value on pin 9.
Because the S-meter I/O characteristics during a seek operation or a receive operation are basically as depicted in the diagram
below, so allowing for potential differences, the setting level for the adjustable range should be 25 to 60 dB.
(3) Support for the LM7000 (IF count method)
Implemented as shown in the figure at right.
15. Tweet Prevention Circuit
(1) Cause and countermeasures for Tweet distortion
The beat noise frequency characteristics for LA1137N is fr = 900 kHz and the corresponding circuit where it is generated are
shown below. The minimum signal-to-noise ratio for tuners using a reference input signal is 30 dB.
Mechanism behind the deterioration of the characteristics
The 900 kHz RF input signal from the antenna is amplified by the FET RF amplifier before passing through the RF
alignment stage to the mixer. If this signal is large, the varactor diodes can cause second-harmonic distortion of 1.8 MHz.
The 900 kHz and 1.8 MHz components each generate an IF signal; (450 + α) kHz for the 900 kHz signal, and (450 – α) kHz
for the 1.8 kHz signal. These two signals interact to produce a beat frequency at 2 × α kHz.
Receive mode
Station seek mode
Antenna input level – dB
IF count control voltage (STRQ)
IF buffer signal
Ω
Output
–
dB
Antenna input – dB
Complete alignment (Maximum
beat noise at 900 kHz)
Complete alignment
(zero beat noise)
Tweet input
Signal Characteristics
LA1136N, 1136NM, 1137N, 1137NM
No. 3507-19/28
相關PDF資料 |
PDF描述 |
|---|---|
| LA1136NM | AM, AUDIO SINGLE CHIP RECEIVER, PDSO24 |
| LA1136N | AM, AUDIO SINGLE CHIP RECEIVER, PDIP24 |
| LA1143 | FM, AUDIO DEMODULATOR, PDIP16 |
| LA1145M | SPECIALTY CONSUMER CIRCUIT, PDSO20 |
| LA1145 | SPECIALTY CONSUMER CIRCUIT, PZIP18 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LA1137NM | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:AM Tuners for Car Radios and Home Stereos |
| LA1140 | 制造商:Panasonic Industrial Company 功能描述:IC |
| LA1140_09 | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:FM IF SYSTEM FOR CAR RADIO |
| LA1140B-E | 制造商:ON Semiconductor 功能描述:CAR RADIO FM IF SYSTEM - Ammo Pack |
| LA1140-E | 功能描述:射頻接收器 CAR RADIO FM IF SYSTEM RoHS:否 制造商:Skyworks Solutions, Inc. 類型:GPS Receiver 封裝 / 箱體:QFN-24 工作頻率:4.092 MHz 工作電源電壓:3.3 V 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。