- 您現(xiàn)在的位置：買賣IC網 > PDF目錄30719 > LA47510 48 W, 2 CHANNEL, AUDIO AMPLIFIER, ZFM25 PDF資料下載
參數資料
| 型號： | LA47510 |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | 48 W, 2 CHANNEL, AUDIO AMPLIFIER, ZFM25 |
| 封裝： | HZIP-25 |
| 文件頁數： | 4/8頁 |
| 文件大?。?/td> | 1082K |
| 代理商： | LA47510 |
LA47510
No.8306-4/8
Description of Operation
1. Standby switch function (pin 4)
The Pin 4 threshold voltage is set to 2 VBE, and the amplifier turns on when Vst = 2.0 V or higher, and off when Vst
= 0.7 V or lower. In addition, Pin 4 requires an operating current of 40
A or more.
Note: Do not ground the output with the Pin 4 voltage at approximately 1.4 V. In addition, do not give the Pin 4
voltage a time constant.
2. Mute function
Mute mode is established and the audio can be muted by connecting Pin 22 to GND through 10 k
.
The mute time constant is determined by the external capacitor and resistor constants. The recommended external
constants are C = 3.3
F, R = 10 k.
3. Self-check function (loudspeaker burnout prevention)
Pin 25 is used to check, during normal operation, for any abnormality in the offset level of the amplifier and generates
a signal when an abnormal level is detected. Speaker burnout can be prevented by detecting this Pin 25 signal with a
microcontroller or other device and controlling the standby power supply, etc. (Output offset errors are thought to be
caused by the leak current of the input capacitor, etc.)
In addition, the Pin 25 signal can be turned off by setting Pin 1 to the GND potential.
4. Oscillation stability
Parasitic oscillation may be induced depending on the board layout.
Countermeasures against oscillation can be taken by adding the following parts.
Note that the following are only examples for reference, and that the optimum capacitance values must be confirmed
in the mounted condition for each set.
Connect a Mylar capacitor (0.033
F) between the BTL outputs.
Connect a capacitor and a resistor (0.1 F and 2.2
in series) between each output and GND.
5. Sound quality (low frequencies)
The frequency response in the low frequency range can be improved by varying the capacitance value of the input
capacitor. The recommended value is 2.22
F or less.
6. Shock noise
This IC incorporates a shock noise canceling circuit, and the shock noise canceling performance can be further
improved by using together with the mute function.
When turning on the amplifier, turn the power supply and the mute function on at the same time.
Then turn the mute function off after the output current potential has stabilized.
When turning off the amplifier, first turn the mute function off and then turn the power supply off.
7. Using the pin 25 function and the pin 1 off function
(1) Offset detection function (Pin 25)
Output offsets can be detected by directly monitoring the pin potential in the condition with 5 V applied through a
10 k
resistor. When an offset is detected, the Pin 25 potential falls from 5 V to 0 V.
* The voltage level at pin 25 swings up and down in synchronization with the output signal when the LA47510 is
in the normal operating state.
(2) Offset detection function OFF switch (Pin 1)
The offset detection function (Pin 25) can be turned off by connecting Pin 1 to GND. Leave Pin 1 open during
normal operation.
8. Electric mirror noise suppression measures
Electric mirror noise can be reduced by inserting a bypass capacitor between the output and GND.
For reference, the standard value is approximately 470 pF and the maximum value is approximately 2200 pF.
However, note that inserting a bypass capacitor will cause the oscillation stability to worsen, so thorough
investigation of anti-oscillation measures should be made in the set condition before use.
相關PDF資料 |
PDF描述 |
|---|---|
| LA47516 | 29 W, 4 CHANNEL, AUDIO AMPLIFIER, ZFM25 |
| LA47536 | 28 W, 4 CHANNEL, AUDIO AMPLIFIER, PZFM25 |
| LA4800V | 0.025 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO16 |
| LA4802T | 0.038 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO20 |
| LA4809M | 0.16 W, 2 CHANNEL, AUDIO AMPLIFIER, PDSO12 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LA47532-S-E | 制造商:ON Semiconductor 功能描述: 制造商:Sony Semiconductor Solutions Division 功能描述: |
| LA47536 | 制造商:SANYO Semiconductor Co Ltd 功能描述:4Ch 45W Btl Car Audio Pwr Amp Sanyo IC 25-Pin Zip-Hs |
| LA47536-E | 功能描述:音頻放大器 RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| LA4763-E | 制造商:Sony Semiconductor Solutions Division 功能描述: |
| LA4800 | 制造商:SANYO 制造商全稱:Sanyo Semicon Device 功能描述:3 V Stereo Headphone Power Amplifier |
發(fā)布緊急采購，3分鐘左右您將得到回復。