- 您現在的位置：買賣IC網 > PDF目錄358742 > LAN91C96I (SMSC Corporation) NON-PCI SINGLE-CHIP FULL DUPLES ETHERNET CONTROLLER PDF資料下載
參數資料
| 型號： | LAN91C96I |
| 廠商： | SMSC Corporation |
| 英文描述： | NON-PCI SINGLE-CHIP FULL DUPLES ETHERNET CONTROLLER |
| 中文描述： | 非PCI單芯片以太網控制器全DUPLES |
| 文件頁數： | 17/110頁 |
| 文件大小： | 655K |
| 代理商： | LAN91C96I |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁
Non-PCI Single-Chip Full Duplex Ethernet Controller
SMSC DS – LAN91C96I
Page 17
Rev. 11/18/2004
DATASHEET
PIN NO.
TQFP
1
QFP
3
PIN NAME
ENEEP
TYPE
I with
pullup
**
I with
pullup
**
DESCRIPTION
Input. This active high input enables the EEPROM to be read
or written by the LAN91C96I. Internally pulled up. Must be
connected to ground if no serial EEPROM is used.
91
93
nEN16
Input. When low the LAN91C96I is configured for 16 bit bus
operation. If left open the LAN91C96I works in 8 bit bus
mode. 16 bit configuration can also be programmed via serial
EEPROM or software initialization of the CONFIGURATION
REGISTER.
An external parallel resonance 20MHz crystal should be
connected across these pins. If an external clock source is
used, it should be connected to this pin (XTAL1) and XTAL2
should be left open.
An external parallel resonance 20MHz crystal should be
connected across these pins. If an external clock source is
used, it should be connected to XTAL1 and this pin (XTAL2)
should be left open.
AUI receive differential inputs.
94
96
XTAL1
Iclk
**
95
97
XTAL2
Iclk
83
82
85
84
RECP/
RECN
Diff.
Input
**
Diff.
Output
77
76
79
78
TXP/nCOLL
TXN/nCRS
INTERNAL ENDEC - (nXENDEC pin open). In this mode
TXP and TXN are the AUI transmit differential outputs. They
must be externally pulled up using 150 ohm resistors.
EXTERNAL ENDEC - (nXENDEC pin tied low). In this mode
the pins are inputs used for collision and carrier sense
functions.
AUI collision differential inputs. A collision is indicated by a
10MHz signal at this input pair.
I
**
81
80
83
82
COLP
COLN
Diff.
Input
**
Diff.
Input
**
Diff.
Output
Diff.
Output
I with
pullup
**
85
84
87
86
TPERXP
TPERXN
10BASE-T receive differential inputs.
75
73
72
74
77
75
74
76
TPETXP
TPETXN
TPETXDP
TPETXDN
INTERNAL ENDEC - 10BASE-T transmit differential outputs.
10BASE-T delayed transmit differential outputs. Used in
combination with TPETXP and TPETXN to generate the
10BASE-T transmit pre-distortion.
66
68
PWRDWN/
TXCLK
INTERNAL ENDEC - Powerdown input. It keeps the
LAN91C96I in powerdown mode when high (open). Must be
low for normal operation.
EXTERNAL ENDEC - Transmit clock input from external
ENDEC.
A resistor should be connected between this pin and analog
ground to determine the threshold level of the TP Receive,
AUI Receive, AUI Collision and AUI Transmit level.
When tied low the LAN91C96I is configured for EXTERNAL
ENDEC. When tied high or left open the LAN91C96I will use
its internal encoder/decoder.
88
90
RBIAS
Analog
Input
90
92
nXENDEC
I with
pullup
**
11,19,
48,59,
98,38
13,21,40,
50,
61,100
VDD
+5.0V power supply pins or 3.3V power supply pins
相關PDF資料 |
PDF描述 |
|---|---|
| LAN91C96I-MS | NON-PCI SINGLE-CHIP FULL DUPLES ETHERNET CONTROLLER |
| LAN91C96I-MU | NON-PCI SINGLE-CHIP FULL DUPLES ETHERNET CONTROLLER |
| LAN91C96IQFP | NON-PCI SINGLE-CHIP FULL DUPLES ETHERNET CONTROLLER |
| LAN91C96ITQFP | NON-PCI SINGLE-CHIP FULL DUPLES ETHERNET CONTROLLER |
| LANF72351D | ETHERNET 10BASE-T LAN FILTER MODULES |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LAN91C96I_07 | 制造商:SMSC 制造商全稱:SMSC 功能描述:Non-PCI Single-Chip Full Duplex Ethernet Controller |
| LAN91C96IMS | 制造商:Microchip Technology Inc 功能描述: |
| LAN91C96I-MS | 功能描述:以太網 IC Non-PCI 10 Mbps Ethernet MAC RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| LAN91C96I-MU | 功能描述:以太網 IC Non-PCI 10 Mbps Ethernet MAC RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| LAN91C96IQFP | 功能描述:以太網 IC Non-PCI 10 Mbps Ethernet MAC RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。