參數資料
型號: LK1001-9PD4T
廠商: POWER-ONE INC
元件分類: 電源模塊
英文描述: 1-OUTPUT 150 W AC-DC REG PWR SUPPLY MODULE
封裝: HEAT SINK, METAL, CASE K02, MODULE
文件頁數: 13/26頁
文件大?。?/td> 1027K
代理商: LK1001-9PD4T
Cassette Style
AC-DC Converters
K Series
Edition 5/5.2000
20/26
Input
Filter
Control
Converter
FET
Ci
RI
RS
Rectifier
PFC
-
Control
1
1001
Fig. 28
Option E block diagram
Precaution:
Subsequent switch-on cycles at start-up are limited to
max. 10 cycles during the rst 20 seconds (cold unit) and
at continuing on/off (
TC =95°C) max. 1 cycle every
8 sec.
15
Ii [A]
10
5
0
–5
–10
–15
0
20
40
60
80
t [ms]
tinr
LK type
Ui = 230 V AC
Po = Po nom
Capacitor Ci
fully charged
Normal operation
(FET fully conducting)
20
10065
Fig. 29
Inrush current with option E
-9 Extended Temperature Range
Option -9 extends the operational ambient temperature
range from –25...71
°C (standard to –40...71°C. The power
supplies provide full nominal output power with convection
cooling. Option -9 excludes inrush current limitation by
NTC.
P Potentiometer
The potentiometer provides an output voltage adjustment
range of +10/–60% of
Uo nom and is accessible through a
hole in the front cover. This feature enables compensation
of voltage drops across the connector and wiring. Option P
is not recommended if units are connected in parallel.
Option P excludes the R-function. With double output units
both outputs are affected by the potentiometer setting (dou-
bling the voltage setting if the outputs are in series).
If the output voltages are increased above
Uo nom via R-in-
put control, option P setting, remote sensing or option T, the
output current(s) should be reduced accordingly so that
Po nom is not exceeded.
E Inrush Current Limitation
The converters may be supplemented by an electronic cir-
cuit (option E, replacing the standard built-in NTC) to
achieve an enhanced inrush current limiting function.
Table 17: Inrush current characteristics with option E
Characteristics
LK
Unit
Ui = 230 V AC
typ
max
Iinr p
Peak inrush current
21.7
A
tinr
Inrush current duration
35
50
ms
Description of Options
Table 16: Survey of options
Option
Function of option
Characteristic
–9
Extended operational ambient temperature range
TA = –40...71°C
E
Electronic inrush current limitation circuitry
Active inrush current limitation
P 1
Potentiometer for fine adjustment of output voltage
Adjustment range +10/-60% of
Uo nom, excludes R input
D 2
Input and/or output undervoltage monitoring circuitry
Safe data signal output (D0...DD)
V 2 3
Input and/or output undervoltage monitoring circuitry
ACFAIL signal according to VME specifications (V0, V2, V3)
T
Current sharing
Interconnect T-pins if paralleling outputs (5 units max.)
B1/B2
Cooling plate
Replaces standard heat sink, allowing direct chassis-mounting
1 Function R excludes option P and vice versa
2 Option D excludes option V and vice versa
3 Only available if main output voltage Uo1 = 5.1 V
相關PDF資料
PDF描述
LK1001-9PD5B1 1-OUTPUT 150 W AC-DC REG PWR SUPPLY MODULE
LK1001-9PD5TB2 1-OUTPUT 150 W AC-DC REG PWR SUPPLY MODULE
LK1001-9PD7 1-OUTPUT 150 W AC-DC REG PWR SUPPLY MODULE
LK1001-9PV3T 1-OUTPUT 150 W AC-DC REG PWR SUPPLY MODULE
LK1301-7D1 1-OUTPUT 150 W AC-DC REG PWR SUPPLY MODULE
相關代理商/技術參數
參數描述
LK100-24P 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Optoelectronic
LK100-28P 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Optoelectronic
LK10051R0K-T 功能描述:固定電感器 INDCTR STD MULTILYR 0402 1uH 10% RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm
LK10051R0K-T 制造商:TAIYO YUDEN 功能描述:Inductor Series:LF LK
LK10051R0K-TV 功能描述:FIXED IND 1UH 20MA 640 MOHM SMD 制造商:taiyo yuden 系列:LK 包裝:剪切帶(CT) 零件狀態:在售 類型:多層 材料 - 磁芯:- 電感:1μH 容差:±10% 額定電流:20mA 屏蔽:無屏蔽 DC 電阻(DCR):640 毫歐 不同頻率時的 Q 值:20 @ 10MHz 頻率 - 自諧振:60MHz 等級:AEC-Q200 工作溫度:-40°C ~ 85°C 頻率 - 測試:10MHz 安裝類型:表面貼裝 封裝/外殼:0402(1005 公制) 供應商器件封裝:0402(1005 公制) 大小/尺寸:0.039" 長 x 0.020" 寬(1.00mm x 0.50mm) 高度 - 安裝(最大值):0.022"(0.55mm) 標準包裝:1