參數資料
型號: LKP5661-5ED1TB1
廠商: POWER-ONE INC
元件分類: 電源模塊
英文描述: 2-OUTPUT 250 W AC-DC PWR FACTOR CORR MODULE
封裝: METAL, CASE K02, MODULE
文件頁數: 13/23頁
文件大小: 1150K
代理商: LKP5661-5ED1TB1
KP Series
AC-DC Converters >100 Watt
Rugged Environment
Edition 4/4.99
20/23
MELCHER
The Power Partners.
E Inrush Current Limitation
The converters may be supplemented by an electronic cir-
cuit (option E, replacing the standard built-in NTC) to
achieve an enhanced inrush current limiting function.
Table 15: Inrush current characteristics with option E
Characteristics
LKP
Unit
Ui = 230 V AC
typ
max
Iinr p
Peak inrush current
21.7
A
tinr
Inrush current duration
35
50
ms
15
Ii [A]
10
5
0
–5
–10
0
20
40
60
80
t [ms]
tinr
Capacitor Ci
fully charged
Normal operation
(FET fully conducting)
20
10
50
70
30
11002
Fig. 30
Inrush current with option E, Ui = 230 V AC, Po = Po nom
Precaution:
Subsequent switch-on cycles at start-up are limited to
max. 10 cycles during the rst 20 seconds (cold unit) and
at continuing on/off (
TC =95°C) max. 1 cycle every
8 sec.
Input
Filter
Control
Converter
FET
Ci
RI
RS
Rectifier
PFC
-
Control
1
1001
Fig. 29
Option E block diagram
Description of Options
Table 14: Survey of options
Option
Function of Option
Characteristics
E
Electronic inrush current limitation circuitry
Active inrush current limitation
P 1, 2
Potentiometer for fine adjustment of output voltage
Adjustment range +10/–60% of
Uo nom excludes R input
D
Input and/or output undervoltage monitoring circuitry
Safe data signal output (Versions D0...DD)
T
Current sharing
Interconnect T-pins if paralleling outputs (3 units max.)
B1
Cooling plate
Replaces standard heat sink, allowing direct chassis-mounting
1 Option R excludes option P and vice versa.
2 Option P not available for LKP 5740-6R
Load
max. 5 units in parallel connection
+
Power bus
Module
Vo2–
Vo2+
Vo1–
Vo1+
T
Module
Vo2–
Vo2+
Vo1–
Vo1+
T
11037
Fig. 28
Paralleling of double output units using option T with
Power Bus
Option P Potentiometer
The potentiometer provides an output voltage adjustment
range of +10/–60% of
Uo nom and is accessible through a
hole in the front cover. This feature enables compensation
for voltage drops across the connector and wiring. Option P
is not recommended if units are connected in parallel.
Option P excludes the R-function. With double output units
both outputs are affected by the potentiometer setting (dou-
bling the voltage setting if the outputs are in series).
If the output voltages are increased above
Uo nom via R-in-
put control, option P setting, remote sensing or option T, the
output current(s) should be reduced accordingly so that
Po nom is not exceeded.
Option T Current Sharing
This option ensures that the output currents are approxi-
mately shared between all paralleled modules and in-
creases system reliability. To use this facility, simply inter-
connect the T pins of all modules. The load leads should
have equal length and cross section to ensure equal volt-
age drops. Not more than 3 units should be connected in
parallel. If output voltage adjustment is requested we
strongly recommend to use the R-input instead of option P,
as with option P the required setting accuracy is difcult to
achieve. The output voltages must be individually set prior
to paralleling to within a tolerance of 1...2% or the R pins
should be connected together.
相關PDF資料
PDF描述
LKP5661-5ER 2-OUTPUT 250 W AC-DC PWR FACTOR CORR MODULE
LKP5661-5PD7TB1 2-OUTPUT 250 W AC-DC PWR FACTOR CORR MODULE
LKP5661-5RDDTB1 2-OUTPUT 250 W AC-DC PWR FACTOR CORR MODULE
LKP5662-7D2TB1 2-OUTPUT 250 W AC-DC PWR FACTOR CORR MODULE
LKP5662-7ED0T 2-OUTPUT 250 W AC-DC PWR FACTOR CORR MODULE
相關代理商/技術參數
參數描述
LKP5661-5R 制造商:Power-One 功能描述:AC/DC PS DUAL-OUT 24V/24V 5.8A/5.8A 280W 15PIN - Bulk
LKP5662-7R 制造商:Power-One 功能描述:AC/DC PS DUAL-OUT 24V/24V 280W 15PIN - Bulk
LKP5663-7ERG 制造商:Power-One 功能描述:
LKP5740-6R 制造商:Power-One 功能描述:AC/DC PS SGL-OUT 50.5V TO 56.5V 4.5A 254W - Bulk
LKP5740-7R 功能描述:線性和開關式電源 Euro-Cassette 231W (25.68V) Battery Charger RoHS:否 制造商:TDK-Lambda 產品:Switching Supplies 開放式框架/封閉式:Enclosed 輸出功率額定值:800 W 輸入電壓:85 VAC to 265 VAC 輸出端數量:1 輸出電壓(通道 1):20 V 輸出電流(通道 1):40 A 商用/醫用: 輸出電壓(通道 2): 輸出電流(通道 2): 安裝風格:Rack 長度: 寬度: 高度: