參數資料
型號: LKP5741-5RD6TB1
廠商: POWER-ONE INC
元件分類: 電源模塊
英文描述: 2-OUTPUT 250 W AC-DC PWR FACTOR CORR MODULE
封裝: METAL, CASE K02, MODULE
文件頁數: 22/23頁
文件大小: 1150K
代理商: LKP5741-5RD6TB1
KP Series
AC-DC Converters >100 Watt
Rugged Environment
Edition 4/4.99
8/23
MELCHER
The Power Partners.
Thermal Considerations
If a converter is located in free, quasi-stationary air (con-
vection cooling) at the indicated maximum ambient tem-
perature
TA max (see: table Temperature specifications) and
is operated at its nominal input voltage and output power,
the temperature measured at the
Measuring point of case
temperature TC (see: Mechanical Data) will approach the
indicated value
TC max after the warm-up phase. However,
the relationship between
TA and TC depends heavily on the
conditions of operation and integration into a system. The
thermal conditions are influenced by input voltage, output
current, airflow and temperature of surrounding compo-
nents and surfaces.
TA max is therefore, contrary to TC max,
an indicative value only.
Caution: The installer must ensure that under all operat-
ing conditions
TC remains within the limits stated in the
table:
Temperature specifications.
Notes: Sufficient forced cooling or an additional heat sink
allows
TA to be higher than 60
°C (e.g. 70°C) if T
C max is not
exceeded.
0
0.1
0.2
0.3
0.4
0.5
0.6
0.7
0.8
TA min 50
60
70
80
90
100
Io/Io nom
TA [°C]
0.9
1.00
forced cooling
convection cooling
TC max
-6 -7
-6
-7
05143
-5
Fig. 7
Output current derating versus temperature for -5, -6 and
-7 units.
Thermal Protection
A temperature sensor generates an internal inhibit signal
which disables the outputs if the case temperature exceeds
TC max. The outputs are automatically re-enabled if the tem-
perature drops below this limit.
Output Protection
Each output is protected against overvoltage which could
occur due to a failure of the control circuit by means of a
voltage suppressor diode which, under worst case condi-
tions, may become a short circuit. The suppressor diodes
are not designed to withstand externally applied over-
voltages. Overload at any of the two outputs will cause a
shut-down of both outputs. A red LED indicates the over-
load condition.
Efciency versus Load
12
3
4
0
82
70
72
74
76
78
80
Efficiency
Io/Io nom
Ui = 187 V AC
Ui = 230 V AC
05156
84
86
88
90
Fig. 8
Efciency versus load at Ui 230 V AC and 187 V AC
Switching Frequency versus Load
0.2
0.4
0.6
0.8
1
0
60
0
10
20
30
40
50
Frequency [kHz]
load [
Io/Io nom]
70
80
1.2
05157
Fig. 9
Switching frequency versus load. (The boost converter at
the input stage has a xed frequency of 100 kHz)
Parallel or Series Connection of Units
Units with equal nominal output voltage can be connected
in parallel without any precautions using option T.
With option T (current sharing), all units share the current
approximately equally.
Main and second outputs can be connected in series with
any other (similar) output.
Note:
– Parallel connection of double output units should always
include both, main and second output to maintain good
regulation of both outputs.
– Not more than 3 units should be connected in parallel.
– Series connection of second outputs without involving
their main outputs should be avoided as regulation may
be poor.
– The maximum output current is limited by the output with
the lowest current limitation if several outputs are con-
nected in series.
相關PDF資料
PDF描述
LKP5742-7D1T 2-OUTPUT 250 W AC-DC PWR FACTOR CORR MODULE
LKP5742-7ERD1 2-OUTPUT 250 W AC-DC PWR FACTOR CORR MODULE
LKP5660-6D2B1 2-OUTPUT 250 W AC-DC PWR FACTOR CORR MODULE
LKP5660-6D3TB1 2-OUTPUT 250 W AC-DC PWR FACTOR CORR MODULE
LKP5660-6D7T 2-OUTPUT 250 W AC-DC PWR FACTOR CORR MODULE
相關代理商/技術參數
參數描述
LKP5742-7R 制造商:Power-One 功能描述:AC/DC PS SGL-OUT 50.5V TO 56.5V 4A 226W 15PIN - Bulk
LKQ1AF12TV5 制造商:Panasonic Electric Works 功能描述:PCB slim relay,SPNO,TV5,flux pf,5A 12Vdc
LKQ1AF12TV5T 制造商:Panasonic Electric Works 功能描述:
LKQ1AF12TV8 制造商:Panasonic Electric Works 功能描述:PCB slim relay,SPNO,TV8,flux pf,8A 12Vdc
LKQ1AF-12V-TV-5 功能描述:通用繼電器 QUIET TYPE, HIGH SENSITIVITY 250mW, SLIM RoHS:否 制造商:Omron Electronics 觸點形式:1 Form A (SPST-NO) 觸點電流額定值:150 A 線圈電壓:24 VDC 線圈電阻:144 Ohms 線圈電流:167 mA 切換電壓:400 V 安裝風格:Chassis 觸點材料: