- 您現在的位置：買賣IC網 > PDF目錄358812 > LM1578 (National Semiconductor Corporation) RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS PDF資料下載
參數資料
| 型號： | LM1578 |
| 廠商： | National Semiconductor Corporation |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| 中文描述： | 抗輻射高效，5安培開關穩壓器 |
| 文件頁數： | 10/18頁 |
| 文件大?。?/td> | 1037K |
| 代理商： | LM1578 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁
Typical Applications
(Continued)
Figure 15 is a 15V to 5V buck regulator with an output cur-
rent, I
, of 350 mA. The circuit becomes discontinuous at
20% of I
, has 10 mV of output voltage ripple, an effi-
ciency of 75%, a load regulation of 30 mV (70 mAto 350 mA)
and a line regulation of 10 mV (12
≤
V
in
≤
18V).
Component values are selected as follows:
R1 = (V
o
1) x R2 where R2 = 10 k
R3 = V/I
sw(max)
R3 = 0.15
where:
V is the current limit sense voltage, 0.11V
I
is the maximum allowable current thru the output
transistor.
L1 is the inductor and may be found from the inductance cal-
culation chart (Figure 16) as follows:
Given
V
in
= 15V
V
o
= 5V
I
o(max)
= 350 mA
f
OSC
= 50 kHz
Discontinuous at 20% of I
o(max)
.
Note that since the circuit will become discontinuous at 20%
of I
, the load current must not be allowed to fall below
70 mA.
Step 1:
Calculate the maximum DC current through the in-
ductor, I
. The necessary equations are indicated at the
top of the chart and show that I
= I
o(max)
for the buck
configuration. Thus, I
L(max)
= 350 mA.
Step 2:
Calculate the inductor Volts-sec product, E-T
, ac-
cording to the equations given from the chart. For the Buck:
E-T
op
= (V
in
V
o
) (V
o
/V
in
) (1000/f
osc
)
=(15 5) (5/15) (1000/50)
= 66V-μs.
with the oscillator frequency, f
osc
, expressed in kHz.
Step 3:
Using the graph with axis labeled “Discontinuous At
% I
” and “I
” find the point where the desired
maximum inductor current, I
L(max, DC)
intercepts the desired
discontinuity percentage.
In this example, the point of interest is where the 0.35A line
intersects with the 20% line. This is nearly the midpoint of the
horizontal axis.
Step 4:
This last step is merely the translation of the point
found in Step 3 to the graph directly below it. This is accom-
plished by moving straight down the page to the point which
intercepts the desired E-T
. For this example, E-T
is
66V-μs and the desired inductor value is 470 μH. Since this
example was for 20% discontinuity, the bottom chart could
have been used directly, as noted in step 3 of the chart
instructions.
DS008711-5
FIGURE 14. Basic Buck Regulator
DS008711-6
V
in
= 15V
V
o
= 5V
V
ripple
= 10 mV
I
o
= 350 mA
f
osc
= 50 kHz
R1 = 40 k
R2 = 10 k
R3 = 0.15
C1 = 1820 pF
C2 = 220 μF
C3 = 20 pF
L1 = 470 μH
D1 = 1N5818
FIGURE 15. Buck or Step-Down Regulator
www.national.com
10
相關PDF資料 |
PDF描述 |
|---|---|
| LM1578A | CAP 100UF 50V ELECT TG SMD |
| LM158AFK | DUAL OPERATIONAL AMPLIFIERS |
| LM158APT | OP-AMP|DUAL|BIPOLAR|TSSOP|8PIN|PLASTIC |
| LM158AN | Voltage-Feedback Operational Amplifier |
| LM158AJ-QMLV | Voltage-Feedback Operational Amplifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM1578A | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Switching Regulator |
| LM1578AH/883 | 制造商:Rochester Electronics LLC 功能描述: |
| LM1578H | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Voltage-Mode SMPS Controller |
| LM158 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Low power dual operational amplifiers |
| LM158 MD8 | 制造商:Texas Instruments 功能描述:LINEAR IC-NON VMI |
發布緊急采購，3分鐘左右您將得到回復。