- 您現在的位置：買賣IC網 > PDF目錄358812 > LM1578A (National Semiconductor Corporation) CAP 100UF 50V ELECT TG SMD PDF資料下載
參數資料
| 型號： | LM1578A |
| 廠商： | National Semiconductor Corporation |
| 英文描述： | CAP 100UF 50V ELECT TG SMD |
| 中文描述： | 開關穩壓器 |
| 文件頁數： | 14/18頁 |
| 文件大?。?/td> | 1037K |
| 代理商： | LM1578A |
Typical Applications
(Continued)
BUCK-BOOST REGULATOR
The Buck-Boost Regulator, shown in Figure 22 may step a
voltage up or down, depending upon whether or not the de-
sired output voltage is greater or less than the input voltage.
In this case, the output voltage is 12V with an input voltage
from 9V to 15V. The circuit exhibits an efficiency of 75%, with
a load regulation of 60 mV (10 mA to 100 mA) and a line
regulation of 52 mV.
R1 = (V
o
1) R2 where R2 = 10 k
R3 = V/0. 75A
R4, C1, C3 and C4 are defined in the “Boost Regulator” sec-
tion.
D1 and D2 are Schottky type diodes such as the 1N5818 or
1N5819.
where:
V
d
is the forward voltage drop of the diodes.
V
sat
is the saturation voltage of the LM1578A output transis-
tor.
V
sat1
is the saturation voltage of transistor Q1.
L1
≥
(V
in
V
sat
V
sat1
) (t
on
/I
p
)
where:
RS-232 LINE DRIVER POWER SUPPLY
The power supply, shown in Figure 23 operates from an in-
put voltage as low as 4.2V (5V nominal), and delivers an out-
put of
±
12V at
±
40 mA with better than 70% efficiency. The
circuit provides a load regulation of
±
150 mV (from 10% to
100% of full load) and a line regulation of
±
10 mV. Other no-
table features include a cycle-by-cycle current limit and an
output voltage ripple of less than 40 mVp-p.
A unique feature of this circuit is its use of feedback from
both outputs. This dual feedback configuration results in a
sharing of the output voltage regulation by each output so
that neither side becomes unbalanced as in single feedback
systems. In addition, since both sides are regulated, it is not
necessary to use a linear regulator for output regulation.
The feedback resistors, R2 and R3, may be selected as fol-
lows by assuming a value of 10 k
for R1;
R2 = (V
o
1V)/45.8 μA = 240 k
R3 = (|V
o
| +1V)/54.2 μA = 240 k
Actually, the currents used to program the values for the
feedback resistors may vary from 40 μA to 60 μA, as long as
their sum is equal to the 100 μA necessary to establish the
1V threshold across R1. Ideally, these currents should be
equal (50 μA each) for optimal control. However, as was
done here, they may be mismatched in order to use standard
resistor values. This results in a slight mismatch of regulation
between the two outputs.
The current limit resistor, R4, is selected by dividing the cur-
rent limit threshold voltage by the maximum peak current
level in the output switch. For our purposes R4 = 110 mV/
750 mA = 0.15
. A value of 0.1
was used.
DS008711-12
V
in
= 5V
V
o
= 15V
V
ripple
= 5 mV
I
o
= 300 mA
I
min
= 60 mA
f
osc
= 50 kHz
R1 = 160 k
R2 = 10 k
R3 = 0.01
R4 = 190
R5 = 82
R6 = 220 k
C1 = 1820 pF
C2 = 1000 μF
C3 = 20 pF
C4 = 0.0022 μF
L1 = 150 μH
D1 = 1N5818
FIGURE 21. Inverting Regulator
www.national.com
14
相關PDF資料 |
PDF描述 |
|---|---|
| LM158AFK | DUAL OPERATIONAL AMPLIFIERS |
| LM158APT | OP-AMP|DUAL|BIPOLAR|TSSOP|8PIN|PLASTIC |
| LM158AN | Voltage-Feedback Operational Amplifier |
| LM158AJ-QMLV | Voltage-Feedback Operational Amplifier |
| LM158AJLQMLV | OP-AMP|DUAL|BIPOLAR|DIP|8PIN|CERAMIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM1578AH/883 | 制造商:Rochester Electronics LLC 功能描述: |
| LM1578H | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Voltage-Mode SMPS Controller |
| LM158 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Low power dual operational amplifiers |
| LM158 MD8 | 制造商:Texas Instruments 功能描述:LINEAR IC-NON VMI |
| LM158/A | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:LOW POWER DUAL OPERATIONAL AMPLIFIERS |
發布緊急采購，3分鐘左右您將得到回復。