- 您現在的位置：買賣IC網 > PDF目錄358821 > LM2577M-ADJ (NATIONAL SEMICONDUCTOR CORP) Pressure Transducer, Series 19 mm, Compensated, Pressure Range: 0 psi to 50 psi, Gage, 1/4 BSPP, 10 Vdc excitation PDF資料下載
參數資料
| 型號： | LM2577M-ADJ |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | Pressure Transducer, Series 19 mm, Compensated, Pressure Range: 0 psi to 50 psi, Gage, 1/4 BSPP, 10 Vdc excitation |
| 中文描述： | 6 A SWITCHING REGULATOR, 62 kHz SWITCHING FREQ-MAX, PDSO24 |
| 封裝： | 0.300 INCH, SO-24 |
| 文件頁數： | 13/27頁 |
| 文件大?。?/td> | 889K |
| 代理商： | LM2577M-ADJ |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁
Application Hints
(Continued)
STEP-UP (BOOST) REGULATOR
Figure 4 shows the LM1577-ADJ/LM2577-ADJ used as a
Step-Up Regulator. This is a switching regulator used for
producing an output voltage greater than the input supply
voltage.
The
LM1577-12/LM2577-12
LM2577-15 can also be used for step-up regulators with 12V
or 15V outputs (respectively), by tying the feedback pin di-
rectly to the regulator output.
A basic explanation of how it works is as follows. The
LM1577/LM2577 turns its output switch on and off at a fre-
quency of 52 kHz, and this creates energy in the inductor (L).
When the NPN switch turns on, the inductor current charges
up at a rate of V
/L, storing current in the inductor. When the
switch turns off, the lower end of the inductor flies above V
,
discharging its current through diode (D) into the output ca-
pacitor (C
) at a rate of (V
V
)/L. Thus, energy
stored in the inductor during the switch on time is transferred
to the output during the switch off time. The output voltage is
controlled by the amount of energy transferred which, in turn,
is controlled by modulating the peak inductor current. This is
done by feeding back a portion of the output voltage to the
error amp, which amplifies the difference between the feed-
back voltage and a 1.230V reference. The error amp output
voltage is compared to a voltage proportional to the switch
current (i.e., inductor current during the switch on time).
The comparator terminates the switch on time when the two
voltages are equal, thereby controlling the peak switch cur-
rent to maintain a constant output voltage.
Voltage and current waveforms for this circuit are shown in
Figure 5 and formulas for calculating them are given in Fig-
ure 6
and
LM1577-15/
STEP-UP REGULATOR DESIGN PROCEDURE
The following design procedure can be used to select the ap-
propriate external components for the circuit in Figure 4
based on these system requirements.
Given:
V
IN (min)
= Minimum input supply voltage
V
OUT
= Regulated output voltage
I
LOAD(max)
= Maximum output load current
Before proceeding any further, determine if the LM1577/
LM2577 can provide these values of V
and I
when operating with the minimum value of V
. The upper
limits for V
OUT
and I
LOAD(max)
are given by the following
equations.
V
OUT
≤
60V
and
V
OUT
≤
10 x V
IN(min)
These limits must be greater than or equal to the values
specified in this application.
1. Inductor Selection (L)
A. Voltage Options:
1.
For 12V or 15V output
DS011468-11
FIGURE 5. Step-Up Regulator Waveforms
Duty Cycle
D
Average
Inductor
Current
Inductor
Current
Ripple
Peak
Inductor
Current
Peak Switch
Current
I
IND(AVE)
I
IND
I
IND(PK)
I
SW(PK)
Switch
Voltage
When Off
Diode
Reverse
Voltage
Average
Diode
Current
Peak Diode
Current
V
SW(OFF)
V
OUT
+ V
F
V
R
V
OUT
V
SAT
I
D(AVE)
I
LOAD
I
D(PK)
Power
Dissipation
of
LM1577/2577
P
D
V
F
= Forward Biased Diode Voltage
I
LOAD
= Output Load Current
FIGURE 6. Step-Up Regulator Formulas
www.national.com
13
相關PDF資料 |
PDF描述 |
|---|---|
| LM2577T-ADJ | SIMPLE SWITCHER Step-Up Voltage Regulator |
| LM2577T-15 | SENSOR MOD GEAR TOOTH 1.5 |
| LM2577T-12 | Explosion-Proof Limit Switches Series EX: Side Rotary; 1NC 1NO SPDT Snap Action; 0.5 in - 14NPT conduit |
| LM2577S-ADJ | SIMPLE SWITCHER Step-Up Voltage Regulator |
| LM2577S-15 | SIMPLE SWITCHER Step-Up Voltage Regulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM2577M-ADJ/NOPB | 功能描述:直流/直流開關轉換器 RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| LM2577MX-12 | 功能描述:IC REG MULTI CONFIG 12V 24SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:SIMPLE SWITCHER® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:3.3V 輸入電壓:4.5 V ~ 24 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:125mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 包裝:Digi-Reel® 供應商設備封裝:SOT-6 其它名稱:MAX1836EUT33#TG16DKR |
| LM2577MX-15 | 功能描述:IC REG MULTI CONFIG 15V 24SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:SIMPLE SWITCHER® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:3.3V 輸入電壓:4.5 V ~ 24 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:125mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 包裝:Digi-Reel® 供應商設備封裝:SOT-6 其它名稱:MAX1836EUT33#TG16DKR |
| LM2577MX-ADJ | 功能描述:IC REG MULTI CONFIG ADJ 24SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:SIMPLE SWITCHER® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:3.3V 輸入電壓:4.5 V ~ 24 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:125mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 包裝:Digi-Reel® 供應商設備封裝:SOT-6 其它名稱:MAX1836EUT33#TG16DKR |
| LM2577N-12 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Texas Instruments 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。