- 您現在的位置：買賣IC網 > PDF目錄358846 > LM3557 (National Semiconductor Corporation) Step-Up Converter for White LED Applications PDF資料下載
參數資料
| 型號： | LM3557 |
| 廠商： | National Semiconductor Corporation |
| 英文描述： | Step-Up Converter for White LED Applications |
| 中文描述： | 升壓轉換器的白色發光二極管應用 |
| 文件頁數： | 8/11頁 |
| 文件大?。?/td> | 642K |
| 代理商： | LM3557 |
Application Information
(Continued)
CONTINUOUS AND DISCONTINUOUS MODES OF
OPERATION
Since the LM3557 is a constant frequency pulse-width-
modulated step-up regulator, care must be taken to make
sure the maximum duty cycle specification is not violated.
The duty cycle equation depends on which mode of opera-
tion the LM3557 is in. The two operational modes of the
LM3557 are continuous conduction mode (CCM) and dis-
continuous conduction mode (DCM). Continuous conduction
mode refers to the mode of operation where during the
switching cycle, the inductor’s current never goes to and
stays at zero for any significant amount of time during the
switching cycle. Discontinuous conduction mode refers to
the mode of operation where during the switching cycle, the
inductor’s current goes to and stays at zero for a significant
amount of time during the switching cycle.
Figure 4
illus-
trates the threshold between CCM and DCM operation. In
Figure 4
, the inductor current is right on the CCM/DCM
operational threshold. Using this as a reference, a factor can
be introduced to calculate when a particular application is in
CCM or DCM operation. R is a CCM/DCM factor we can use
to compute which mode of operation a particular application
is in. If R is
≥
1, then the application is operating in CCM.
Conversely, if R is
<
1, the application is operating in DCM.
The R factor inequalities are a result of the components that
make up the R factor. From
Figure 4
, the R factor is equal to
the average inductor current, I
(avg), divided by half the
inductor ripple current,
i
. Using
Figure 4
, the following
equation can be used to compute R factor:
20131620
20131621
20131622
20131623
V
IN
:
V
OUT
:
Eff:
Fs:
I
OUT
:
L:
D:
i
L
:
I
L
(avg): Average Inductor Current.
For CCM operation, the duty cycle can be computed with:
Input Voltage.
Output Voltage.
Efficiency of the LM3557.
Switching Frequency.
White LED Current/Load Current.
Inductance Magnitude/Inductor Value.
Duty Cycle for CCM operation.
Inductor Ripple Current.
20131624
20131625
t
ON
:
T
S
:
D:
V
OUT
: Output Voltage.
V
IN
:
Input Voltage.
For DCM operation, the duty cycle can be computed with:
Internal Power FET On-Time.
Switching Period of Operation.
Duty Cycle for CCM Operation.
20131619
FIGURE 4. Inductor Current Waveform
L
www.national.com
8
相關PDF資料 |
PDF描述 |
|---|---|
| LM3570 | Low Noise White LED Driver System |
| LM3570SD | Low Noise White LED Driver System |
| LM3570SDX | Low Noise White LED Driver System |
| LM358 | Dual Operation Amplifiers |
| LM358CS | Voltage-Feedback Operational Amplifier |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM3557SD-2 | 功能描述:LED照明驅動器 RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
| LM3557SD-2 | 制造商:Texas Instruments 功能描述:IC W LED DRIVER POWERWISE LLP-8 |
| LM3557SD-2/NOPB | 功能描述:LED照明驅動器 RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
| LM3557SDX-2 | 功能描述:LED照明驅動器 RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
| LM3557SDX-2/NOPB | 功能描述:LED照明驅動器 RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
發布緊急采購，3分鐘左右您將得到回復。