- 您現在的位置：買賣IC網 > PDF目錄30756 > LM4921ITLX/NOPB (NATIONAL SEMICONDUCTOR CORP) SPECIALTY CONSUMER CIRCUIT, PBGA20 PDF資料下載
參數資料
| 型號： | LM4921ITLX/NOPB |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 消費家電 |
| 英文描述： | SPECIALTY CONSUMER CIRCUIT, PBGA20 |
| 封裝： | MICRO, SMD-20 |
| 文件頁數： | 5/20頁 |
| 文件大?。?/td> | 457K |
| 代理商： | LM4921ITLX/NOPB |
SPI TIMING DIAGRAM
200486g1
SPI OPERATIONAL REQUIREMENTS
1. The maximum clock rate is 5MHz for the CLK pin.
2. CLK must remain logic-high for at least 100ns (t
CH ) after
the rising edge of CLK, and CLK must remain logic-low for at
least 100ns (t
CL ) after the falling edge of CLK.
3. Data bits are written to the DATA pin with the least signifi-
cant bit (LSB) first.
4. The serial data bits are sampled at the rising edge of CLK.
Any transition on DATA must occur at least 20ns (t
DS) before
the rising edge of CLK. Also, any transition on DATA must
occur at least 20ns (t
DH) after the rising edge of CLK and sta-
bilize before the next rising edge of CLK.
5. ENABLE should be logic-high only during serial data trans-
mission.
6. ENABLE must be logic-high at least 20ns (t
ES ) before the
first rising edge of CLK, and ENABLE has to remain logic-high
at least 20ns (t
EH ) after the sixteenth rising edge of CLK.
7. If ENABLE remains logic-low for more than 10ns before all
16 bits are transmitted then the data latch will be aborted.
8. If ENABLE is logic-high for more than 16 CLK pulses then
only the first 16 data bits will be latched and activated at rising
edge of sixteenth CLK.
9. ENABLE must remain logic-low for at least 30ns (t
EL ).
10. Coincidental rising or falling edges of CLK and ENABLE
are not allowed. If CLK is to be held logic-high after the data
transmission, the falling edge of CLK must occur at least 20ns
(t
CS ) before ENABLE transitions to logic-high for the next set
of data.
I2S INTERFACE BUS (J2 - Fig 2)
The I2S standard provides a uni-directional serial interface
designed specifically for digital audio. For the LM4921, the
interface provides access to a 48kHz, 16 bit full-range stereo
audio DAC. This interface uses a three wire system of clock
(I2S_CLK), data (I2S_DATA), and word select (I2S_WS,
sometimes called Right/Left Select).
A bit clock (I2S_CLK) at 32 or 64 times the sample frequency
is established by the I2S system master and the word select
(I2S_WS) line is driven at a frequency equal to the sampling
rate of the audio data, in this case 48kHz. The word line is
registered to change on the positive edge of the bit clock. The
serial data (I2S_DATA) is sent MSB first, again registers on
the positive edge of the bit clock, delayed by 1 bit clock cycle
relative to the changing of the word line (typical I2S format).
MCLK/XTAL_IN (S1 MCLK SEL - Fig 2)
This is the input for an external Master Clock. The jumper at
S1 must be removed (disconnecting the onboard crystal from
the circuit) when using an external Master Clock.
STEREO HEADPHONE OUTPUT JACK (J3 - Fig 2)
This is the stereo headphone output. Each channel is single-
ended, with 100uF DC output blocking capacitors mounted
on the demo board (C6 and C7). These capacitors are nec-
essary to block the 1/2 VDD DC bias and prevent it from
flowing through the headphone speakers (DC current will de-
stroy most audio speakers) while allowing the audio ac signal
to pass through. The jack features a typical stereo headphone
pinout.
13
www.national.com
LM4921
相關PDF資料 |
PDF描述 |
|---|---|
| LM4990ITL/NOPB | 2 W, 1 CHANNEL, AUDIO AMPLIFIER, PBGA9 |
| LM4990ITLX/NOPB | 2 W, 1 CHANNEL, AUDIO AMPLIFIER, PBGA9 |
| LM4995SDX/NOPB | 1.25 W, 1 CHANNEL, AUDIO AMPLIFIER, DSO8 |
| LM5007MMEP/NOPB | SWITCHING REGULATOR, PDSO8 |
| LM5007MMEP | SWITCHING REGULATOR, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM4922 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Ground-Referenced, Ultra Low Noise, Fixed Gain, 80mW Stereo Headphone Amplifier |
| LM4922TL | 制造商:Rochester Electronics LLC 功能描述: 制造商:Texas Instruments 功能描述: |
| LM4922TL/NOPB | 功能描述:音頻放大器 RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| LM4922TLX/NOPB | 功能描述:音頻放大器 RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| LM4923 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:1.1 Watt Fully Differential Audio Power Amplifier With Shutdown Select |
發布緊急采購，3分鐘左右您將得到回復。