- 您現在的位置：買賣IC網 > PDF目錄2153 > LMC7101BYM5 TR (Micrel Inc)IC OPAMP STD 500KHZ SOT23-5 PDF資料下載
參數資料
| 型號： | LMC7101BYM5 TR |
| 廠商： | Micrel Inc |
| 文件頁數： | 12/12頁 |
| 文件大小： | 0K |
| 描述： | IC OPAMP STD 500KHZ SOT23-5 |
| 標準包裝： | 1 |
| 系列： | IttyBitty® |
| 放大器類型： | 通用 |
| 電路數： | 1 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 0.3 V/µs |
| 增益帶寬積： | 500kHz |
| 電流 - 輸入偏壓： | 1pA |
| 電壓 - 輸入偏移： | 110µV |
| 電流 - 電源： | 800µA |
| 電流 - 輸出 / 通道： | 300mA |
| 電壓 - 電源，單路/雙路(±)： | 2.7 V ~ 12 V，±1.35 V ~ 6 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | SC-74A，SOT-753 |
| 供應商設備封裝： | SOT-23-5 |
| 包裝： | 標準包裝 |
| 產品目錄頁面： | 1110 (CN2011-ZH PDF) |
| 其它名稱： | 576-2575-6 |
February 2005
9
LMC7101
Micrel, Inc.
Application Information
Input Common-Mode Voltage
Some amplifiers exhibit undesirable or unpredictable perfor-
mance when the inputs are driven beyond the common-mode
voltage range, for example, phase inversion of the output
signal. The LMC7101 tolerates input overdrive by at least
200mV beyond either rail without producing phase inversion.
If the absolute maximum input voltage (700mV beyond either
rail) is exceeded, the input current should be limited to ±5mA
maximum to prevent reducing reliability. A 10k series input
resistor, used as a current limiter, will protect the input
structure from voltages as large as 50V above the supply or
below ground. See Figure 1.
VIN
VOUT
10k
RIN
Figure 1. Input Current-Limit Protection
Output Voltage Swing
Sink and source output resistances of the LMC7101 are
equal. Maximum output voltage swing is determined by the
load and the approximate output resistance. The output
resistance is:
R
V
I
OUT
DROP
LOAD
=
V
DROP is the voltage dropped within the amplifier output
stage. V
DROP and ILOAD can be determined from the VO
(output swing) portion of the appropriate Electrical Character-
istics table. I
LOAD is equal to the typical output high voltage
minus V+/2 and divided by R
LOAD. For example, using the
Electrical Characteristics DC (5V) table, the typical output
high voltage using a 2k load (connected to V+/2) is 4.989V,
which produces an I
LOAD of
1 245
4 989
2 5
2
1 245
.
..
.
mA
V –
V
k
mA
=
.
Voltage drop in the amplifier output stage is:
V
DROP = 5.0V – 4.989V
V
DROP = 0.011V
Because of output stage symmetry, the corresponding typical
output low voltage (0.011V) also equals V
DROP. Then:
R
V
A
9
OUT ==
≈
0 011
0 001245
88
.
Driving Capacitive Loads
Driving a capacitive load introduces phase-lag into the output
signal, and this in turn reduces op-amp system phase margin.
The application that is least forgiving of reduced phase
margin is a unity gain amplifier. The LMC7101 can typically
drive a 100pF capacitive load connected directly to the output
when configured as a unity-gain amplifier.
Using Large-Value Feedback Resistors
A large-value feedback resistor (> 500k) can reduce the
phase margin of a system. This occurs when the feedback
resistor acts in conjunction with input capacitance to create
phase lag in the fedback signal. Input capacitance is usually
a combination of input circuit components and other parasitic
capacitance, such as amplifier input capacitance and stray
printed circuit board capacitance.
Figure 2 illustrates a method of compensating phase lag
caused by using a large-value feedback resistor. Feedback
capacitor C
FB introduces sufficient phase lead to overcome
the phase lag caused by feedback resistor R
FB and input
capacitance C
IN. The value of CFB is determined by first
estimating C
IN and then applying the following formula:
R
C
R
C
IN
FB
×
≤
×
VIN
CFB
RFB
VOUT
CIN
RIN
Figure 2. Cancelling Feedback Phase Lag
Since a significant percentage of C
IN may be caused by board
layout, it is important to note that the correct value of C
FB may
change when changing from a breadboard to the final circuit
layout.
相關PDF資料 |
PDF描述 |
|---|---|
| LMH6619MAX/NOPB | IC AMP DUAL RRIO 130MHZ 8-SOIC |
| LMH6644MTX/NOPB | IC OP AMP R-R LP 3V 75MA 14TSSOP |
| LMP8270MAX/NOPB | IC AMP PREC VOLT DIFF 8-SOIC |
| LMP8277MAX/NOPB | IC AMP PREC VOLT DIFF 8-SOIC |
| LMV301SQ3T2G | IC OP AMP R-R 1.8V SC70-5 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LMC7101Q | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Tiny Low Power Operational Amplifier with Rail-to-Rail Input and Output |
| LMC7101QM5 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Tiny Low Power Operational Amplifier with Rail-to-Rail Input and Output |
| LMC7101QM5/NOPB | 功能描述:運算放大器 - 運放 Auto Qualified Sgl Amp RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| LMC7101QM5X | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Tiny Low Power Operational Amplifier with Rail-to-Rail Input and Output |
| LMC7101QM5X/NOPB | 功能描述:運算放大器 - 運放 RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。