- 您現在的位置：買賣IC網 > PDF目錄358880 > LMH6504MM (NATIONAL SEMICONDUCTOR CORP) Wideband, Low Power, Variable Gain Amplifier PDF資料下載
參數資料
| 型號： | LMH6504MM |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 模擬信號調理 |
| 英文描述： | Wideband, Low Power, Variable Gain Amplifier |
| 中文描述： | SPECIALTY ANALOG CIRCUIT, PDSO8 |
| 封裝： | MSOP-8 |
| 文件頁數： | 14/19頁 |
| 文件大小： | 759K |
| 代理商： | LMH6504MM |
Application Information
(Continued)
LMH6504 GAIN CONTROL FUNCTION
In the plot, Gain vs. V
G
, we can see the gain as a function of
the control voltage. The “Gain (V/V)” plot, sometimes re-
ferred to as the S-curve, is the linear (V/V ) gain. This is a
hyperbolic tangent relationship and is given by Equation 3.
The “Gain (dB)” plots the gain in dB and is linear over a wide
range of gains. Because of this, the LMH6504 gain control is
referred to as “l(fā)inear-in-dB.”
For applications where the LMH6504 will be used at the
heart of a closed loop AGC circuit, the S-curve control char-
acteristic provides a broad linear (in dB) control range with
soft limiting at the highest gains where large changes in
control voltage result in small changes in gain. For applica-
tions requiring a fully linear (in dB) control characteristic, use
the LMH6504 at half gain and below (V
G
≤
1V).
AVOIDING OVERDRIVE OF THE LMH6504 GAIN
CONTROL INPUT
There is an additional requirement for the LMH6504 Gain
Control Input (V
): V
must not exceed +2.3V (with
±
5V
supplies). The gain control circuitry may saturate and the
gain may actually be reduced. In applications where V
is
being driven from a DAC, this can easily be addressed in the
software. If there is a linear loop driving V
G
, such as an AGC
loop, other methods of limiting the input voltage should be
implemented. One simple solution is to place a 2.2:1 resis-
tive divider on the V
G
input. If the device driving this divider
is operating off of
±
5V supplies as well, its output will not
exceed 5V and through the divider V
G
can not exceed 2.3V.
IMPROVING THE LMH6504 LARGE SIGNAL
PERFORMANCE
Figure 4
illustrates an inverting gain scheme for the
LMH6504.
The input signal is applied through the R
resistor. The V
IN
pin should be grounded through a 25
resistor. The maxi-
mum gain range of this configuration is given in the following
equation:
Eq. 5
The inverting slew rate of the LMH6504 is much higher than
that of the non-inverting slew rate. This 2X performance
improvement comes about because in the non-inverting con-
figuration, the slew rate of the overall amplifier is limited by
the input buffer. In the inverting circuit, the input buffer re-
mains at a fixed voltage and does not affect slew rate.
TRANSMISSION LINE MATCHING
One method for matching the characteristic impedance of a
transmission line is to place the appropriate resistor at the
input or output of the amplifier.
Figure 5
shows a typical
circuit configuration for matching transmission lines.
The resistors R
, R
I
, R
, and R
are equal to the character-
istic impedance, Z
, of the transmission line or cable. Use
C
to match the output transmission line over a greater
frequency range. It compensates for the increase of the op
amp’s output impedance with frequency.
MINIMIZING PARASITIC EFFECTS ON SMALL SIGNAL
BANDWIDTH
The best way to minimize parasitic effects is to use surface
mount components and to minimize lead lengths and com-
ponent distance from the LMH6504. For designs utilizing
through-hole components, specifically axial resistors, resis-
tor self-capacitance should be considered. Example: the
average magnitude of parasitic capacitance of RN55D 1%
metal film resistors is about 0.15 pF with variations of as
much as 0.1 pF between lots. Given the LMH6504’s ex-
tended bandwidth, these small parasitic reactance variations
can cause measurable frequency response variations in the
highest octave. We therefore recommend the use of surface
mount resistors to minimize these parasitic reactance ef-
fects.
RECOMMENDATIONS
Here are some recommendations to avoid problems and to
get the best performance:
Do not place a capacitor across R
. However, an appro-
priately chosen series RC combination could be used to
shape the frequency response.
Keep traces connecting R
F
separated and as short as
possible
Place a small resistor (20-50
) between the output and
C
L
Cut away the ground plane, if any, under R
G
LMH6504.
Connect pin 2 through a minimum resistance of 25
.
ADJUSTING OFFSETS AND DC LEVEL SHIFTING
Offsets can be broken into two parts: an input-referred term
and an output-referred term. These errors can be trimmed
using the circuit in
Figure 6
. First set V
G
to 0V and adjust the
20084354
FIGURE 4. Inverting Amplifier
20084356
FIGURE 5. TRANSMISSION LINE MATCHING
L
www.national.com
14
相關PDF資料 |
PDF描述 |
|---|---|
| LMH6504MMX | Wideband, Low Power, Variable Gain Amplifier |
| LMH6533 | Four - Channel Laser Diode Driver with Dual Output, LVDS Interface and HFM Oscillator |
| LMH6533SP | Four - Channel Laser Diode Driver with Dual Output, LVDS Interface and HFM Oscillator |
| LMH6533SPX | Four - Channel Laser Diode Driver with Dual Output, LVDS Interface and HFM Oscillator |
| LMH6551 | Differential, High Speed Op Amp |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LMH6504MM NOPB | 制造商:Texas Instruments 功能描述:1 Variable Gain Amplifier 制造商:Texas Instruments 功能描述:1 Variable Gain Amplifier Bulk |
| LMH6504MM/NOPB | 功能描述:特殊用途放大器 RoHS:否 制造商:Texas Instruments 通道數量:Single 共模抑制比（最小值）: 輸入補償電壓: 工作電源電壓:3 V to 5.5 V 電源電流:5 mA 最大功率耗散: 最大工作溫度:+ 70 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-20 封裝:Reel |
| LMH6504MMX | 功能描述:特殊用途放大器 RoHS:否 制造商:Texas Instruments 通道數量:Single 共模抑制比（最小值）: 輸入補償電壓: 工作電源電壓:3 V to 5.5 V 電源電流:5 mA 最大功率耗散: 最大工作溫度:+ 70 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-20 封裝:Reel |
| LMH6504MMX/NOPB | 功能描述:特殊用途放大器 RoHS:否 制造商:Texas Instruments 通道數量:Single 共模抑制比（最小值）: 輸入補償電壓: 工作電源電壓:3 V to 5.5 V 電源電流:5 mA 最大功率耗散: 最大工作溫度:+ 70 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-20 封裝:Reel |
| LMH6505 | 制造商:INTERSIL 制造商全稱:Intersil Corporation 功能描述:Wideband, Low Power, Linear-in-dB, Variable Gain Amplifier |
發布緊急采購，3分鐘左右您將得到回復。