參數資料
型號: LMX2487
廠商: National Semiconductor Corporation
英文描述: 3.0 GHz - 6.0 GHz High Performance Delta-Sigma Low Power Dual PLLatinum⑩ Frequency Synthesizers with 3.0 GHz Integer PLL
中文描述: 為3.0 GHz - 6.0 GHz的高性能Δ-Σ低功耗雙PLLatinum⑩頻率合成器與整數的3.0 GHz鎖相環
文件頁數: 19/37頁
文件大?。?/td> 856K
代理商: LMX2487
Bench Test Setups
(Continued)
20154771
Input Impedance Measurement Procedure
The above block diagram shows the test setup used for measuring the input impedance for the LMX2487. The DC blocking
capacitor used between the input SMA connector and the pin being measured must be changed to a zero Ohm resistor. This
procedure applies to the FinRF, FinIF, and OSCin pins. The basic test procedure is to calibrate the network analyzer, ensure that
the part is powered up, and then measure the input impedance. The network analyzer can be calibrated by using either calibration
standards or by soldering resistors directly to the evaluation board. An open can be implemented by putting no resistor, a short
can be implemented by soldering a zero ohm resistor as close as possible to the pin being measured, and a short can be
implemented by soldering two 100 ohm resistors in parallel as close as possible to the pin being measured. Calibration is done
with the PLL removed from the PCB. This requires the use of a clamp down fixture that may not always be generally available.
If no clamp down fixture is available, then this procedure can be done by calibrating up to the point where the DC blocking
capacitor usually is, and then implementing port extensions with the network analyzer. Zero ohm resistor is added back for the
actual measurement. Once the setup is calibrated, it is necessary to ensure that the PLL is powered up. This can be done by
toggling the power down bits (RF_PD and IF_PD) and observing that the current consumption indeed increases when the bit is
disabled. Sometimes it may be necessary to apply a signal to the OSCin pin in order to program the part. If this is necessary,
disconnect the signal once it is established that the part is powered up. It is useful to know the input impedance of the PLL for
the purposes of debugging RF problems and designing matching networks. Another use of knowing this parameter is make the
trace width on the PCB such that the input impedance of this trace matches the real part of the input impedance of the PLL
frequency of operation. In general, it is good practice to keep trace lengths short and make designs that are relatively resistant
to variations in the input impedance of the PLL.
L
www.national.com
19
相關PDF資料
PDF描述
LMX2487SQ 3.0 GHz - 6.0 GHz High Performance Delta-Sigma Low Power Dual PLLatinum⑩ Frequency Synthesizers with 3.0 GHz Integer PLL
LMX2487SQX 3.0 GHz - 6.0 GHz High Performance Delta-Sigma Low Power Dual PLLatinum⑩ Frequency Synthesizers with 3.0 GHz Integer PLL
LMX3161 Single Chip Radio Transceiver(單芯片無線電收發器)
LMX3161VBH Single Chip Radio Transceiver
LMX3161VBHX Single Chip Radio Transceiver
相關代理商/技術參數
參數描述
LMX2487_08 制造商:NSC 制造商全稱:National Semiconductor 功能描述:1.0 GHz - 6.0 GHz High Performance Delta-Sigma Low Power Dual PLLatinum? Frequency Synthesizers with 3.0 GHz Integer PLL
LMX2487E 制造商:NSC 制造商全稱:National Semiconductor 功能描述:7.5 GHz High Performance Delta-Sigma Low Power Dual PLLatinum⑩ Frequency Synthesizers with 3.0 GHz Integer PLL
LMX2487E-EVM 功能描述:EVAL MODULE FOR LMX2487 制造商:texas instruments 系列:PLLatinum?? 零件狀態:在售 類型:頻率合成器 頻率:3GHz ~ 7.5GHz 配套使用產品/相關產品:LMX2487E 所含物品:板 標準包裝:1
LMX2487ESQ 制造商:NSC 制造商全稱:National Semiconductor 功能描述:7.5 GHz High Performance Delta-Sigma Low Power Dual PLLatinum⑩ Frequency Synthesizers with 3.0 GHz Integer PLL
LMX2487ESQ/NOPB 功能描述:鎖相環 - PLL RoHS:否 制造商:Silicon Labs 類型:PLL Clock Multiplier 電路數量:1 最大輸入頻率:710 MHz 最小輸入頻率:0.002 MHz 輸出頻率范圍:0.002 MHz to 808 MHz 電源電壓-最大:3.63 V 電源電壓-最小:1.71 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:QFN-36 封裝:Tray