- 您現在的位置：買賣IC網 > PDF目錄358904 > LP124 (National Semiconductor Corporation) Micropower Quad Operational Amplifier PDF資料下載
參數資料
| 型號： | LP124 |
| 廠商： | National Semiconductor Corporation |
| 元件分類： | 運算放大器 |
| 英文描述： | Micropower Quad Operational Amplifier |
| 中文描述： | 微功耗四運算放大器 |
| 文件頁數： | 5/10頁 |
| 文件大?。?/td> | 230K |
| 代理商： | LP124 |
Application Hints
(Continued)
should be used from the output of the amplifier to ground.
The resistor biases the output into class A operation.
The LP124 has improved stability margin for driving capaci-
tive loads. No special precautions are needed to drive loads
in the 50 pF to 1000 pF range. It should be noted however
that since the power supply current has been reduced by a
factor of 10, so also has the slew rate and gain bandwidth
product. This reduction can cause reduced performance in
AC applications where the LM124 is being replaced by an
LP124. Such situations usually occur when the LM124 has
been operated near its power bandwidth.
Output short circuits either to ground or to the positive pow-
er supply should be of short time duration. Units can be
destroyed, not as a result of the short circuit current causing
metal fusing, but rather due to the large increase in IC chip
dissipation which will cause eventual failure due to exces-
sive junction temperatures. For example: If all four amplifi-
ers were simultaneously shorted to ground on a 10V supply
the junction temperature would rise by 110
§
C.
Exceeding the negative common-mode limit on either input
will cause a reversal of phase to the output and force
the amplifier to the corresponding high or low state. Exceed-
ing the negative common-mode limit on both inputs will
force the amplifier output to a high state. Exceeding the
positive common-mode limit on a single input will not
change the phase of the output. However, if both inputs
exceed the limit, the output of the amplifier will be forced to
a low state. In neither case does a latch occur since return-
ing the input within the common mode range puts the input
stage and thus the amplifier in a normal operating mode.
The circuits presented in the section on typical applications
emphasize operation on only a single power supply voltage.
If complementary power supplies are available, all of the
standard op amp circuits can be used. In general, introduc-
ing a pseudo-ground (a bias voltage reference to V
a
/2) will
allow operation above and below this value in single power
supply systems. Many application circuits are shown which
take advantage of the wide input common-mode voltage
range which includes ground. In most cases, input biasing is
not required and input voltages which range to ground can
easily be accommodated.
Driving CMOS
TL/H/8562–3
Comparator with Hysteresis
TL/H/8562–6
Non-Inverting Amplifier
TL/H/8562–4
Adder/Subtractor
TL/H/8562–7
Unity Gain Buffer
TL/H/8562–5
Positive Integrator
TL/H/8562–8
http://www.national.com
5
相關PDF資料 |
PDF描述 |
|---|---|
| LP124J | Micropower Quad Operational Amplifier |
| LP141X13-C1 | LCD MODULE |
| LP150X1 | DATA DISPLAY AG LP150X1 15.0 XGA TFT LCD PRELIMINARY SPECIFICATION |
| LP21 | CRYSTAL IN HC-49/S TRU-HOLE PACKAGE |
| LP239J | LOW-POWER QUAD DIFFERENTIAL COMPARATORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LP1240-12-YZ | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Switch-Mode LED Driver |
| LP1240-24-YZ | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Switch-Mode LED Driver |
| LP1240-48-YZ | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Switch-Mode LED Driver |
| LP-12-450 | 功能描述:XFRMR PWR 115/230V 6.3VAC 900MA RoHS:是 類別:變壓器 >> 功率 系列:LP 標準包裝:1 系列:260 類型:標準 最大功率:65 VA 主線圈:雙 副線圈:三路，中心抽頭 在某電流時的串聯輸出電壓:500 VAC @ 85mA，5 VAC @ 2A，6.3 VAC @ 2A 在某電流時的并聯輸出電壓:- 安裝類型:底座安裝 尺寸/尺寸:102.36mm L x 67.31mm W 高度 - 座高（最大）:66.80mm 端接類型:導線引線 |
| LP12-450 | 制造商:SUPERWORLD 制造商全稱:Superworld Electronics 功能描述:POWER TRANSFORMER |
發布緊急采購，3分鐘左右您將得到回復。