- 您現在的位置：買賣IC網 > PDF目錄358910 > LP2981AIM5X-4.0 (NATIONAL SEMICONDUCTOR CORP) Micropower 100 mA Ultra Low-Dropout Regulator PDF資料下載
參數資料
| 型號： | LP2981AIM5X-4.0 |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | Micropower 100 mA Ultra Low-Dropout Regulator |
| 中文描述： | 4 V FIXED POSITIVE LDO REGULATOR, 0.375 V DROPOUT, PDSO5 |
| 封裝： | SOT-23, SOP-5 |
| 文件頁數： | 13/20頁 |
| 文件大?。?/td> | 346K |
| 代理商： | LP2981AIM5X-4.0 |
SLVS521B JULY 2004 REVISED OCTOBER 2004
13
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
output capacitor (C
out
) (continued)
It is critical that both the minimum capacitance and ESR requirement be met over the entire operating
temperature range.
Depending on the type of capacitor used, both of these parameters can vary significantly
with temperature (see capacitor characteristics section).
capacitor characteristics
ceramics
Due to their very low ESR values, ceramic capacitors are not suitable for use as the output capacitor. For
instance, a typical 2.2-
μ
F ceramic capacitor has an ESR in the range of 10 m
to 20 m
and, thus, easily can
fall out of minimum ESR requirements under certain operating conditions.
If a ceramic capacitor is used at the output, a 1-
resistor should be placed in series with the capacitor to raise
the ESR seen by the regulator.
tantalum
Solid tantalum capacitors are optimal choices for the LP2981, but they still must meet the minimum ESR
requirement. Note that the ESR of a tantalum capacitor increases as temperature drops, as much as double
from 25
°
C to 40
°
C. Thus, ESR margins must be maintained over the temperature range to prevent regulator
instability. For operation at very low temperatures, paralleling a tantalum capacitor with a ceramic one keeps
the combined ESR from increasing near the upper limit of the ESR curve.
aluminum
Aluminum capacitors can be used, but use with the LP2981 is impractical due to their large physical dimensions.
They also must meet the ESR requirements over the full temperature range. In this regard, aluminium capacitors
are at a big disadvantage due to their sharp ESR increase as temperature drops. For example, over a
temperature drop from 20
°
C to 40
°
C, the ESR of an aluminum electrolytic capacitor can increase by a factor
of 50. In addition, some of the electrolytes used in these capacitors can freeze at 25
°
C, making the capacitor
nonoperational.
ON/OFF operation
The LP2981 allows for a shutdown mode via the ON/OFF pin. If the shutdown feature is not used, ON/OFF
should be connected to the input to ensure that the regulator is on at all times. To drive ON/OFF:
A LOW (
≤
0.3 V) turns the regulator OFF; a HIGH (
≥
1.6 V) turns it ON.
Use either a totem-pole output or an open-collector output with a pullup resistor tied to V
IN
(or another
logic supply). The HIGH signal can exceed V
IN
, but must not exceed the absolute maximum ratings of
20 V for the ON/OFF pin.
Apply a signal with a slew rate of
≥
40 mV/
μ
s. A slow slew rate can cause the shutdown function to
operate incorrectly.
ADJ version
From Figure 3, V
OUT
is set according to the following equation:
R
ADJ
R
1
V
OUT
= V
REF
1
where V
REF
= 1.23 V (nominal). Under no-load conditions, a minimum “bias” current is required through the R
ADJ
and R
1
divider to maintain regulator stability. Therefore, the maximum value for R
1
should be
39.5 k
.
相關PDF資料 |
PDF描述 |
|---|---|
| LP2981IM5X-4.0 | Micropower 100 mA Ultra Low-Dropout Regulator |
| LP2981AIM5X-3.0 | Micropower 100 mA Ultra Low-Dropout Regulator |
| LP2981IM5X-3.0 | Reed Relay; Contacts:4PST-4NO; Contact Carry Current:0.5A; Coil Voltage DC Max:5V; Relay Terminals:SMT BGA; Switching Current Max:0.4A; Switching Voltage Max:125V; Contact Carrying Power:3W; Mounting Type:PCB Surface Mount |
| LP2981AIM5-4.0 | Micropower 100 mA Ultra Low-Dropout Regulator |
| LP2981AIM5-5.0 | Micropower 100 mA Ultra Low-Dropout Regulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LP2981AIM5X-5.0 | 功能描述:低壓差穩壓器 - LDO RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| LP2981AIM5X-5.0/NOPB | 功能描述:低壓差穩壓器 - LDO RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| LP2981BUP-3.3 WAF | 制造商:Texas Instruments 功能描述: |
| LP2981BY-2.9 WAF | 制造商:Texas Instruments 功能描述: |
| LP2981BY-4.0 WAF | 制造商:Texas Instruments 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。