參數資料
型號: LPC2478FET208
廠商: NXP Semiconductors N.V.
元件分類: 數學處理器
英文描述: Single-chip 16-bit-32-bit micro; 512 kB flash, Ethernet, CAN, LCD, USB 2.0 device-host-OTG, external memory interface
封裝: LPC2478FBD208<SOT459-1 (LQFP208)|<<http://www.nxp.com/packages/SOT459-1.html<1<Always Pb-free,;LPC2478FET208<SOT950-1 (TFBGA208)|<<http://www.nxp.com/packages/SOT950-1.ht
文件頁數: 41/93頁
文件大?。?/td> 751K
代理商: LPC2478FET208
LPC2478
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2011. All rights reserved.
Product data sheet
Rev. 3 — 12 September 2011
41 of 93
NXP Semiconductors
LPC2478
Single-chip 16-bit/32-bit microcontroller
Conforms to
Multimedia Card Specification v2.11
.
Conforms to
Secure Digital Memory Card Physical Layer Specification, v0.96.
Can be used as a multimedia card bus or a secure digital memory card bus host. The
SD/MMC can be connected to several multimedia cards or a single secure digital
memory card.
DMA supported through the GPDMA controller.
7.20 I
2
C-bus serial I/O controller
The LPC2478 contains three I
2
C-bus controllers.
The I
2
C-bus is bidirectional, for inter-IC control using only two wires: a serial clock line
(SCL), and a serial data line (SDA). Each device is recognized by a unique address and
can operate as either a receiver-only device (e.g., an LCD driver) or a transmitter with the
capability to both receive and send information (such as memory). Transmitters and/or
receivers can operate in either master or slave mode, depending on whether the chip has
to initiate a data transfer or is only addressed. The I
2
C-bus is a multi-master bus and can
be controlled by more than one bus master connected to it.
The I
2
C-bus implemented in LPC2478 supports bit rates up to 400 kbit/s (Fast I
2
C-bus).
7.20.1
Features
I
2
C0 is a standard I
2
C compliant bus interface with open-drain pins.
I
2
C1 and I
2
C2 use standard I/O pins and do not support powering off of individual
devices connected to the same bus lines.
Easy to configure as master, slave, or master/slave.
Programmable clocks allow versatile rate control.
Bidirectional data transfer between masters and slaves.
Multi-master bus (no central master).
Arbitration between simultaneously transmitting masters without corruption of serial
data on the bus.
Serial clock synchronization allows devices with different bit rates to communicate via
one serial bus.
Serial clock synchronization can be used as a handshake mechanism to suspend and
resume serial transfer.
The I
2
C-bus can be used for test and diagnostic purposes.
7.21 I
2
S-bus serial I/O controllers
The I
2
S-bus provides a standard communication interface for digital audio applications.
The I
2
S-bus specification defines a 3-wire serial bus using one data line, one clock line,
and one word select signal. The basic I
2
S connection has one master, which is always the
master, and one slave. The I
2
S interface on the LPC2478 provides a separate transmit
and receive channel, each of which can operate as either a master or a slave.
相關PDF資料
PDF描述
LPC2917FBD144 ARM9 microcontroller with CAN and LIN
LPC2919FBD144 ARM9 microcontroller with CAN and LIN
LPC2921FBD100 ARM9 microcontroller with CAN, LIN, and USB
LPC2923FBD100 ARM9 microcontroller with CAN, LIN, and USB
LPC2925FBD100 ARM9 microcontroller with CAN, LIN, and USB
相關代理商/技術參數
參數描述
LPC2478FET208,551 功能描述:ARM微控制器 - MCU LCD CONT/ETHNET USB/512K FL RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT
LPC2478FET208551 制造商:NXP Semiconductors 功能描述:MCU ARM7 208TFBGA
LPC2478-STK 功能描述:開發板和工具包 - ARM DEV BRD FOR LPC2478 64MB SDRAM 100MBIT RoHS:否 制造商:Arduino 產品:Development Boards 工具用于評估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口類型:DAC, ICSP, JTAG, UART, USB 工作電源電壓:3.3 V
LPC2478-STK-MICTOR 功能描述:開發板和工具包 - ARM DEV BRD FOR LPC2478 RoHS:否 制造商:Arduino 產品:Development Boards 工具用于評估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口類型:DAC, ICSP, JTAG, UART, USB 工作電源電壓:3.3 V
LPC-24B-12R 制造商:OPTIFUSE 功能描述: