- 您現在的位置：買賣IC網 > PDF目錄385498 > LT1086 Series (Linear Technology Corporation) 1.5A Low Dropout Positive Regulators Adjustable and Fixed 2.85V, 3.3V, 3.6V, 5V, 12V(1.5A，低壓差正輸出固定和可調穩壓器) PDF資料下載
參數資料
| 型號： | LT1086 Series |
| 廠商： | Linear Technology Corporation |
| 英文描述： | 1.5A Low Dropout Positive Regulators Adjustable and Fixed 2.85V, 3.3V, 3.6V, 5V, 12V(1.5A，低壓差正輸出固定和可調穩壓器) |
| 中文描述： | 1.5A的低壓差穩壓器可調正和固定工作在2.85V，3.3V和3.6V的，5V的，12V的（1.5安培的電流，低壓差正輸出固定和可調穩壓器） |
| 文件頁數： | 8/16頁 |
| 文件大?。?/td> | 287K |
| 代理商： | LT1086 SERIES |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁
8
LT1086 Series
The LT1086 family of 3-terminal regulators is easy to use
and has all the protection features that are expected in high
performance voltage regulators. They are short-circuit
protected, have safe area protection as well as thermal
shutdown to turn off the regulator should the temperature
exceed about 165
°
C at the sense point.
These regulators are pin compatible with older 3-terminal
adjustable devices, offer lower dropout voltage and more
precise reference tolerance. Further, the reference stabil-
ity with temperature is improved over older types of
regulators. The only circuit difference between using the
LT1086 family and older regulators is that they require an
output capacitor for stability.
Stability
The circuit design used in the LT1086 family requires the
use of an output capacitor as part of the device frequency
compensation. For all operating conditions, the addition of
150
μ
F aluminum electrolytic or a 22
μ
F solid tantalum on
the output will ensure stability. Normally capacitors much
smaller than this can be used with the LT1086. Many
different types of capacitors with widely varying charac-
teristics are available. These capacitors differ in capacitor
tolerance (sometimes ranging up to
±
100%), equivalent
series resistance, and capacitance temperature coeffi-
cient. The 150
μ
F or 22
μ
F values given will ensure stability.
When using the LT1086 the adjustment terminal can be
bypassed to improve ripple rejection. When the adjust-
ment terminal is bypassed the requirement for an output
capacitor increases. The values of 22
μ
F tantalum or 150
μ
F
aluminum cover all cases of bypassing the adjustment
terminal. For fixed voltage devices or adjustable devices
without an adjust pin bypass capacitor, smaller output
capacitors can be used with equally good results and the
table below shows approximately what size capacitors are
needed to ensure stability.
Recommended Capacitor Values
INPUT
10
μ
F
10
μ
F Tantalum, 50
μ
F Aluminum
10
μ
F
22
μ
F Tantalum, 150
μ
F Aluminum
OUTPUT
ADJUSTMENT
None
20
μ
F
Normally, capacitor values on the order of 100
μ
F are used
in the output of many regulators to ensure good transient
APPLICATIO
S I
N
FOR
ATIO
U
W
U
response with heavy load current changes. Output capaci-
tance can be increased without limit and larger values of
output capacitor further improve stability and transient
response of the LT1086 regulators.
Another possible stability problem that can occur in mono-
lithic IC regulators is current limit oscillations. These can
occur because in current limit, the safe area protection
exhibits a negative impedance. The safe area protection
decreases the current limit as the input-to-output voltage
increases.That is the equivalent of having a negitive resis-
tance since increasing voltage causes current to decrease.
Negative resistance during current limit is not unique to
the LT1086 series and has been present on all power IC
regulators. The value of negative resistance is a function of
how fast the current limit is folded back as input-to-output
voltage increases. This negative resistance can react with
capacitors or inductors on the input to cause oscillation
during current limiting. Depending on the value of series
resistance, the overall circuitry may end up unstable. Since
this is a system problem, it is not necessarily easy to solve;
however it does not cause any problems with the IC
regulator and can usually be ignored.
Protection Diodes
In normal operation the LT1086 family does not need any
protection diodes. Older adjustable regulators required
protection diodes between the adjustment pin and the
output and from the output to the input to prevent over-
stressing the die. The internal current paths on the LT1086
adjustment pin are limited by internal resistors. Therefore,
even with capacitors on the adjustment pin, no protection
diode is needed to ensure device safety under short-circuit
conditions.
Diodes between input and output are usually not needed.
The internal diode between the input and the output pins
of the LT1086 family can handle microsecond surge
currents of 10A to 20A. Even with large output capaci-
tances, it is very difficult to get those values of surge
currents in normal operation. Only with high value output
capacitors such as 1000
μ
F to 5000
μ
F, and with the input
pin instantaneously shorted to ground, can damage occur.
A crowbar circuit at the input of the LT1086 can generate
those kinds of currents and a diode from output to input is
then recommended. Normal power supply cycling or even
相關PDF資料 |
PDF描述 |
|---|---|
| LT1088 | Wideband RMS-dc Converter Building Block(寬帶RMS-DC變換器組件) |
| LT1101 | Precision Micropower,Single Supply Instrmentation Amplifier(Fixed Gain=10 or 100)(精密，微功耗，單電源儀用放大器（固定增益=10或100）) |
| LT1106 | Micropower Step-Up DC/DC Converter for PCMCIA Card Flash Memory |
| LT1106CF | 4-Bit Synchronous Up/Down Binary Counters 16-PDIP 0 to 70 |
| LT1120A | Octal Buffers/Drivers With 3-State Outputs 20-SOIC 0 to 70 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1087CT | 制造商:Linear Technology 功能描述:Voltage Regulator, Adjustable, +1.2 TO +33V, Bi-Polar, 5 Pin, Plastic, SIP |
| LT1087CT#31 | 制造商:Linear Technology 功能描述:Voltage Regulator, Adjustable, +1.2 TO +33V, Bi-Polar, 5 Pin, Plastic, SIP |
| LT1097CN8 | 功能描述:IC PREC OP-AMP LOW-COST/PWR 8DIP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:1,000 系列:- 放大器類型:電壓反饋 電路數:4 輸出類型:滿擺幅 轉換速率:33 V/µs 增益帶寬積:20MHz -3db帶寬:30MHz 電流 - 輸入偏壓:2nA 電壓 - 輸入偏移:3000µV 電流 - 電源:2.5mA 電流 - 輸出 / 通道:30mA 電壓 - 電源，單路/雙路(±):4.5 V ~ 16.5 V，±2.25 V ~ 8.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOIC 包裝:帶卷 (TR) |
| LT1097CN8#PBF | 功能描述:IC PREC OP-AMP LOW-COST/PWR 8DIP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 產品培訓模塊:Differential Circuit Design Techniques for Communication Applications 標準包裝:1 系列:- 放大器類型:RF/IF 差分 電路數:1 輸出類型:差分 轉換速率:9800 V/µs 增益帶寬積:- -3db帶寬:2.9GHz 電流 - 輸入偏壓:3µA 電壓 - 輸入偏移:- 電流 - 電源:40mA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VQFN 裸露焊盤，CSP 供應商設備封裝:16-LFCSP-VQ 包裝:剪切帶 (CT) 產品目錄頁面:551 (CN2011-ZH PDF) 其它名稱:ADL5561ACPZ-R7CT |
| LT1097CN8PBF | 制造商:Linear Technology 功能描述:LT1097CN8PBF |
發布緊急采購，3分鐘左右您將得到回復。